Philips AJ3200 Troubleshooting guide

Always there to help you
Register your product and get support at
Question?
Contact
Philips
Question?
Contact
Philips
AJ3200
Note: You can only set time in standby mode.
Note:
• You can store a maximum of 10 preset radio stations.
• To overwrite a pre-stored radio station, store another one with its sequence
number.
The batteries (not supplied) can only back up clock and alarm settings when AC
power is disconnected.
Specications are subject to change without notice.
This product has been manufactured by, and is sold under
the responsibility of Gibson Innovations Ltd., and Gibson
Innovations Ltd. is the warrantor in relation to this product.
Philips and the Philips Shield Emblem are registered trademarks
of Koninklijke Philips N.V. and are used under license.
AJ3200_05_QSG_V5.0
Select a preset radio station
1. Important
Warning
• Never remove the casing of this clock radio.
• Never lubricate any part of this clock radio.
• Never place this clock radio on other electrical equipment.
• Keep this clock radio away from direct sunlight, naked ames or heat.
• Make sure that you always have easy access to the power cord, plug or adaptor to
disconnect the clock radio from the power.
• Make sure that there is enough free space around the product for ventilation.
• Battery usage CAUTION –To prevent battery leakage which may result in bodily injury,
property damage, or damage to the clock radio:
• Install the battery correctly, + and - as marked on the clock radio.
• Do not mix batteries (old and new or carbon and alkaline, etc.).
• Remove the battery when the clock radio is not used for a long time.
• The battery shall not be exposed to excessive heat such as sunshine, re or the like.
• Use only power supplies listed in the user manual.
• The clock radio shall not be exposed to dripping or splashing.
• Do not place any sources of danger on the clock radio (e.g. liquid lled objects, lighted
candles).
• Where the plug of the Direct Plug-in Adapter is used as the disconnect device, the
disconnect device shall remain readily operable.
2. Notice
Any changes or modications made to this device that are not expressly approved by Gibson
Innovations may void the user’s authority to operate the equipment.
Hereby, Gibson Innovations declares that this product is in compliance with the essential
requirements and other relevant provisions of Directive 2014/53/EU. You can nd the
Declaration of Conformity on www.philips.com/support.
Your product is designed and manufactured with high quality materials and components, which
can be recycled and reused.
This symbol on a product means that the product is covered by European Directive 2012/19/
EU. Inform yourself about the local separate collection system for electrical and electronic
products. Follow local rules and never dispose of the product with normal household waste.
Correct disposal of old products helps prevent negative consequences for the environment and
human health.
Environmental information
All unnecessary packaging has been omitted. We have tried to make the packaging easy to
separate into three materials: cardboard (box), polystyrene foam (buffer) and polyethylene
(bags, protective foam sheet.)
Your system consists of materials which can be recycled and reused if disassembled by a
specialized company. Please observe the local regulations regarding the disposal of packaging
materials, exhausted batteries and old equipment.
Note
• The type plate is located on the bottom of the apparatus.
Class II equipment symbol:
CLASS II apparatus with double insulation, and no protective earth provided.
Tune to FM radio stations
To download the full user manual, visit www.philips.com/support.
www.philips.com/support
Quick start guide
RADIO
FM mode Standby mode
1 Fully extend and adjust the position of the pig-tail antenna until you nd the
best reception.
2 Fix the antenna as illustrated.
Store FM radio stations
AJ3200_05_QSG_V5.0.indd 1 6/6/2017 4:22:51 PM

Charge your mobile devices
1 Connect the clock radio with your mobile device.
• For Android-powered mobile device with a micro USB socket: use the supplied cable to connect the product with the mobile device;
• For Apple device with a lightning or 30-pin connector: use the charging cable of the Apple device (not supplied) to connect the product with the mobile device.
2 Connect the clock radio to AC power.
» The mobile device begins to charge.
Specications
Amplier
Total Output Power 500 mW
Tuner (FM)
Tuning Range 87.5-108 MHz
Tuning Grid 50 KHz
Sensitivity
- Mono, 26 dB S/N Ratio <22 dBf
Total Harmonic Distortion <3%
Signal to Noise Ratio >50 dBA
General information
AC Power (power adapter) Brand name: Philips;
Model: S012B0551500B;
Input: 100-240V~ 50/60Hz max. 400mA
Output: 5.5 V 1500 mA
USB Charging Voltage DC 5 V
USB Charging Current ≤ 1000 mA
Operation Power Consumption 9 W
Standby Power Consumption <1 W
Dimensions:
- Main Unit (W x H x D) 112 x 101 x 125 mm
Weight:
- Main Unit 0.4 kg
Press SLEEP repeatedly to select a period (in minutes). After the set period, the
product switches to standby mode automatically.
• To deactivate the sleep timer,press SLEEP repeatedly until [OFF] is displayed.
When the alarm sounds, press SNOOZE.
» The alarm snoozes and repeats ringing nine minutes
later.
Press AL1 or AL2 repeatedly to select an alarm source
(FM radio or buzzer) or deactivate the alarm timer.
Note:
• You can only set the alarm in standby mode.
• Make sure that you have set the clock correctly.
AJ3200_05_QSG_V5.0.indd 2 6/6/2017 4:22:52 PM