Phoenix Hydro-X Xtreme Xtractor User manual

Owner’s Manual — Hydro-X Xtreme Xtractor
Installation, Operation & Service Instructions
1 www.UsePhoenix.com • [email protected]Toll-Free 1-800-533-7533
Read and Save These Instructions
The Phoenix Hydro-X Xtreme Xtractor is the most effective
and efficient extraction tool on the market today. The
Hydro-X’s patented Suction Roller provides both suction
and compression — forcing water to the surface then
sucking the water away, not allowing the water to be
reabsorbed back into the carpet and pad. No other
extractor today can pull as much water from the carpet and
pad as the Hydro-X Xtreme Xtractor.
The Hydro-X is steerable and self-propelled with variable
speeds. One restoration technician can operate the unit
and extract 1200 sq. ft. of carpet and pad in approximately
2 hours*!
The Phoenix Hydro-X Xtractor
• Patented suction roller provides both suction and
compression forcing water to the surface.
• Self-propelled with positive chain drive –
no belts to break or adjust
• Variable speed for every carpet and pad condition
• Extracts in both forward and reverse
• Rust and corrosion resistant stainless steel
construction
• Built to withstand daily use
• Heavy-duty electronics
• One year warranty on parts and labor
Phoenix Hydro-X
Xtreme Xtractor
Part No. 4025600
Specifications subject to change without notice.
TS-640
01/12
*Time may vary depending on carpet style.
4201 Lien Rd Madison, WI 53704
Patents:
6,152,151
6,629,333

2 www.UsePhoenix.com • [email protected]Toll-Free 1-800-533-7533
Table of Contents
Introduction ...............................................................1
1. Specifications........................................................2
2. Setup Instructions .................................................2
3. Operating Instructions............................................3
3.1 Steering .........................................................3
3.2 Directional Control...........................................3
3.3 Movement Control ...........................................3
3.4 Speed Control.................................................3
4. Basic Extraction Technique .....................................3
5. Other Information ..................................................3
5.1 Vacuum Units..................................................3
5.2 Troubleshooting...............................................3
6. Service Parts ........................................................4
Warranty...............................................................5
1 Specifications
Part No. 4025600
Power 2.5 amps; 110-120 VAC grounded, 60 hz
Speed 0 - 28 Feet/Minute (Adjustable)
Either forward or reverse
Drive Motor 2.0 Amps
Fuse 5.0 Amp 250 VAC
Warranty One year; 100% Parts and Labor
Dimensions
Machine Shipping
Width 17” (Base) 27-1/2”
Height 52” 45-1/2”
Depth 20.5” (Base) 22”
Weight 70 lbs 80 lbs
2 Setup Instructions
To set up the Phoenix Hydro-X Xtreme Xtractor, unpack the
two boxes in which the unit was shipped.
1. Connect the handle assembly to the extraction
assembly by inserting the square tube attached to the
handle assembly into the square receiver and secure
with the supplied hitch pin.
2. Connect the black electrical leads together by inserting
the base assembly lead into the handle assembly lead
and tightening the collar. See figure 1a.
Read the operation and maintenance instructions
carefully before using this unit. Proper adherence to these
instructions is essential to obtain maximum benefit from
your Phoenix Hydro-X Xtractor.
• It is designed to be used INDOORS ONLY.
• If used in a wet area, plug it into a GROUND FAULT
INTERRUPTER.
• It must always be used in the upright position.
Figure 1: Tube and receiver connections secured by hitch pins
CAUTION: Key must be lined up correctly when plugging
handle into base assembly. Improper connection can result
in damage to connector pins, blown fuses or incorrect
product operation.
Figure 1a

3 www.UsePhoenix.com • [email protected]Toll-Free 1-800-533-7533
3 Operating Instructions
The speed, movement and directional controls are located
on the control box at the top of the handle assembly.
3.1 Steering
To steer the Hydro-X Xtreme Xtractor, remove the middle
hitch pin on the wheel/base assembly. When finished
extracting, moving or transporting the Hydro-X, be sure the
reinstall to hitch pin.
3.2 Directional Control
Select the “Forward” or “Reverse” switch to set the
desired direction of movement. When the Forward/Reverse
switch is in either movement position, the machine will
begin motion when the handle on the handle grip is
depressed.
3.3 Movement Control
Depress the handle on the left handle grip to begin
movement. Always start movement on the Hydro-X with the
speed control set to “Slow.” Depressing the movement
handle when the Hydro-X speed control is set to “Fast”
may cause the operator to lose their balance as the
machine will start moving quickly. Before changing from
Forward to Reverse or vice versa, release the motion
handle.
3.4 Speed Control
The knob marked “Fast/Slow” controls the speed of
movement from 1 to 28 feet per minute. Recommended
speed for extracting water from berber is slow.
Recommended speed for cut pile is fast.
4 Basic Extraction Technique
If there is more than 1” of standing water in the area to be
extracted, a sump pump should be used to remove standing
water.
Start in corner of room - extract one pass forward and one
pass back. Pull corner of carpet back to inspect pad. If
no water splashes when jumped on with foot, two passes
are sufficient for extraction. If there is water splash, make
another pass and re-check. After determining the number
of passes required, extract entire room.
5 Other Information
5.1 Vacuum Units
For maximum extraction, the recommended vacuum unit is
the Phoenix Hydro-X Vacuum Pac. However, if using a truck
mounted vacuum unit, a 2” hose must be used from truck
to the Phoenix Hydro-X Xtreme Xtractor. Using a portable
vacuum unit other than the Phoenix Hydro-X Vacuum Pac is
not recommended.
5.2 Troubleshooting
This chart suggests common answers to problems with
your Hydro-X. The information is not all-inclusive and does
not necessarily apply in all cases. If unusual operating
conditions, or other problems occur, obtain technical
assistance from the manufacturer.
If the unit fails to operate:
No Power - Check home circuit breakers or receptacle with
circuit tester.
Blown Fuse or Open Breaker - Replace fuses or reset
circuit breaker. Inspect for damaged wiring.
GFCI Tripped - After plugging in GFCI and machine
power cord, press “RESET” button on GFCI.
Loose Motor Connections - Check handle to motor lead
connection.
Figure 2: Remove
the hitch pin to
steer the Hydro-X
during extraction
Figure 3: Directional controls
feature forward, reverse
and off. In the “off” setting
the Hydro-X will not move
when the movement lever is
depressed.
Figure 4: Compress
the movement handle
when ready to begin
extraction.
Figure 5: The Hydro-X
can move from 1 to
28 feet per minute
with the use of the
speed control knob.

4 www.UsePhoenix.com • [email protected]Toll-Free 1-800-533-7533
6 Service Parts
Item Description Qty Part Number
1 Perforated Roller 1 4025619
2 Handle Protector Cap 3 4025677
3 Handle Grips 2 4025599
4 Speed Control Knob 1 4025606
5 Transport Wheels 4 4025626
7 Suction Roller Axle Bearings 2 4030842
8 Hitch Pin 2 4025621
9 Replacement Power Cord 1 4032679-01
10 Handle Lever Boot 1 4025678
Items available but not shown:
Fuse (5A) 1 4025704
Drive Motor 1 4030137
Internal Handle Switch 1 4030589
1
2
3
10
7
8
4
7
2
5
9

5 www.UsePhoenix.com • [email protected]Toll-Free 1-800-533-7533
Phoenix Hydro-X Xtractor Limited Warranty
Warrantor:
Therma-Stor LLC
4201 Lien Rd
Madison, WI 53704
Telephone: [phone]
Who Is Covered: This warranty extends only to the original end-user of the Phoenix Hydro-X Xtractor
dehumidifier, and may not be assigned or transferred.
Year One: Therma-Stor LLC warrants that, for one (1) year the Phoenix Hydro-X Xtractor will operate free
from any defects in materials and workmanship, or Therma-Stor LLC will, at its option, repair or replace
the defective part(s), free of any charge.
End-User Responsibilities: Warranty service must be performed by a Servicer authorized by Therma-
Stor LLC. If the end-user is unable to locate or obtain warranty service from an authorized Servicer, he
should call Therma-Stor LLC at the above number and ask for the Therma-Stor Service Department,
which will then arrange for covered warranty service. Warranty service will be performed during normal
working hours.
The end-user must present proof of purchase (lease) upon request, by use of the warranty card or
other reasonable and reliable means. The end-user is responsible for normal care. This warranty does
not cover any defect, malfunction, etc. resulting from misuse, abuse, lack of normal care, corrosion,
freezing, tampering, modication, unauthorized or improper repair or installation, accident, acts of
nature or any other cause beyond Therma-Stor LLC’s reasonable control.
Limitation and Exclusions: If any Phoenix Hydro-X Xtractor part is repaired or replaced, the new part
shall be warranted for only the remainder of the original warranty period applicable thereto (but all
warranty periods will be extended by the period of time, if any, that the Phoenix Hydro-X Xtractor is out
of service while awaiting covered warranty service).
UPON THE EXPIRATION OF THE WRITTEN WARRANTY APPLICABLE TO THE PHOENIX HYDRO-X
XTRACTOR OR ANY PART THEREOF, ALL OTHER WARRANTIES IMPLIED BY LAW, INCLUDING
MERCHANTABILITY AND FITNESS FOR A PARTICULAR PURPOSE, SHALL ALSO EXPIRE. ALL
WARRANTIES MADE BY THERMA-STOR LLC ARE SET FORTH HEREIN, AND NO CLAIM MAY BE MADE
AGAINST THERMA-STOR LLC BASED ON ANY ORAL WARRANTY. IN NO EVENT SHALL THERMA-STOR
LLC, IN CONNECTION WITH THE SALE, INSTALLATION, USE, REPAIR OR REPLACEMENT OF ANY
HYDRO-X XTRACTOR OR PART THEREOF BE LIABLE UNDER ANY LEGAL THEORY FOR ANY SPECIAL,
INDIRECT OR CONSEQUENTIAL DAMAGES INCLUDING WITHOUT LIMITATION WATER DAMAGE (THE
END-USER SHOULD TAKE PRECAUTIONS AGAINST SAME), LOST PROFITS, DELAY, OR LOSS OF USE OR
DAMAGE TO ANY REAL OR PERSONAL PROPERTY.
Some states do not allow limitations on how long an implied warranty lasts, and some do not allow
the exclusion or limitation of incidental or consequential damages, so one or both of these limitation
may not apply to you.
Legal Rights: This warranty gives you specific legal rights, and you may also have other rights which
vary from state to state.