L-1012e.A3 phyGATE-Tauri-S i.MX 6UL/ULL Kit Hardware and BSP Manual
© PHYTEC Messtecknik GmbH
•
•
•
•
2 Safety Instructions and Liability
2.1 Intended Use
The phyGATE Tauri-S gateway is designed for monitoring, processing, and communicating machine and sensor
data in industrial environments. For data communication, the devices provide various typical industrial interfaces
for connection to surrounding devices.
This PHYTEC standard gateway is supplied exclusively as an OEM device by PHYTEC Messtechnik GmbH and
requires an adaptation of the operating software for the intended application by the distributor of the device.
2.2 General Safety Instructions
For commissioning, development work, and assembly, the operating instructions for the device must be used.
Knowledge in the following areas is required:
Electronic circuitry
Working in electrostatically protected areas
Accident prevention regulations
On-site valid rules and regulations for occupational safety
These devices may only be commissioned and installed by adequately qualified personnel with basic electrical
knowledge! The device must be handled with care in every phase of its life cycle, in order to prevent destruction by
electrostatic discharge or mechanical stress, for example.
To ensure functional safety, the device must be powered by a SELV/PELV power supply. The gateway must be
mounted on a top-hat rail in a fire save control cabinet for permanent use.
Improper modifications and repairs may impair the integrated protective functions and the electromagnetic
behavior of the device. This can cause malfunction of the device, interference with connected and surrounding
devices, or personal injury. Therefore, interventions on the device may only be carried out by the manufacturer.
Warning
The device must not be used in a manner not specified in this manual to avoid damage of the protection
provided by the equipment.
L’appareil ne doit pas être utilisé d'une façon non spécifiée dans ce manuel afin éviter d’endommager la
protection fournie par l'équipement.
Warning
To ensure functional safety, the device must be powered by a SELV/PELV power supply. The gateway must
be mounted on a top-hat rail in a fire save control cabinet for permanent use.
Pour garantir la sécurité fonctionnelle, l’appareil doit être alimenté par une alimentation SELV/PELV. Pour
une utilisation permanente, la passerelle doit être montée sur un rail profilé chapeau dans une armoire de
commande coupe-feu.
