Pidion BIP-5000 User manual

-Please read “Warning and Cautions for Your Safety” carefully before you use the phone.

Safety & WarningSafety & Warning : Always keep the following safety information to prevent accidents or dangers occurred through safe
and proper use of the product.
1. Battery Safety
a. Do not break, impact, heat, or sink the battery. Never disassemble it with a sharp object (such as a drill) Otherwise, it can cause an
explosion.
b. Keep a child or an animal away from the battery.
2. Never use the PDA phone in explosive area.
3. Never use the PDA phone in the airline or hospital.
4. Do not use the PDA phone including operating or searching the phone number, and etc. while driving. Please use hands-free operation,
if available or pull off the road or park before making or answering a call if driving conditions so require.
5. Do not leave the battery in a car. Avoid using or storing the phone in locations subject to extremely high temperatures, such as inside a
car exposed to the sun or near a heater. Otherwise, it can cause a deformation or a failure to the battery.
6. All batteries can cause property damages, injury, or burns if a conductive material such as jewelry, keys or beaded chains touches
exposed terminals. To protect against such unwanted touch, exercise care in handling any charged battery. Take care not to give pressure
to it with a sharp objective, or crush with a heavy object. It can cause an explosion.
7. Use only the designated and supplied batteries and adapters. They can’t be used for other purposes, excepts for our company’s PDA
phone. Otherwise, it can cause the reduction of the lifetime of battery or PDA or even an explosion. (In this case, you can’t request free
repair services).
8. Always charge the battery with the supplied adapter or the standard charger. Otherwise, it can cause the reduction of battery life or an
explosion (In this case, you can’t request free repair services).
9. With the PDA phone get wet, do not heat the battery in an oven or a micro wave. It can cause an explosion, a deformation or a failure (If
the PDA phone or battery get wet, the color of label change in the terminal. This time, you can’t request free repair services so be careful
when using the PDA phone).

CONTENTSCONTENTS
I. Cover
II. Safety & Warning - Warning and Caution
III. Contents
1. Configuration
2. Product Information
1)Left, Front, Right of Product
2)Button Description
3)Product Specification
3. Startup
1)Battery Installation, Battery Removing
2)Battery Charging Method
3)Terminal Startup
4. Network Connection
1) Scan
2) ear jack (Converter)
3) Terminal Reset
4) Host PC Connection
5) Using IrDA
6) Bluetooth
7) Using Memory Card
5. ActiveSync
1) ActiveSync Installation
2) ActiveSync Safety Information
6. Using PDA Phone Function
7. Safety Information
8. Appendix
1) Q&A
2) Accessory

Copyright © 2005 Bluebird Soft, Inc. All Rights Reserved. < # >
BIP-5000
Product ComponentsProduct Components
The picture or photo may differ from that illustrated in the user’s manual according to the model (If you want
additional accessories, contact Customer Information Service Center).
[BIP-5000 Body] [BIP-5000 Cradle] [Standard Battery][Stylus]
[Power cable] [User’s Manual]

Copyright © 2005 Bluebird Soft, Inc. All Rights Reserved. < # >
BIP-5000
Product InformationProduct Information
1. Front, Left-side, Rear, Right-side
[Front] [Right] [Rear] [Left]
Antenna
CDMA
(LED)
Speaker
Power(LED)
Alpha key
Enter
Key
Function
key Power Button
Send Button
Barcod
e
Scanne
r
window
Barcode/
Camera
Button
ear jack
IrDA
Camera
Flash
Reset
Battery Case
Latch
Hand
Strap
Barcode/
Camera
Button

Copyright © 2005 Bluebird Soft, Inc. All Rights Reserved. < # >
BIP-5000
Product InformationProduct Information
2. Button Description
Turns On/Off the PDA.
Laser(1D,2D) Bacrode / Camera Type : Press the left button to run the barcode.,
Press the right button to operate the camera.
CMOS Bacode Type : Both Left and Right buttons run the barcode.
Enters and runs the symbol or letter.
Changes the mode of character to be entered. Default shall be entered in numbers.
Press once to change into English Lower Letter, two times into English Capital Letters,
and three times into Special Characters.
Runs the phone program and connects the phone. Press once to run the phone
program, two times to display the latest call lists, and three times to put a call to the
selected list.
Moves to the left space by space to delete the letter.
Moves to the right space by space.
Press long for more than 3 seconds to change into mute (etiquette) mode and press
again for 3 seconds to release the setting.
Press long for more than 3 seconds to set into Lock mode. When used the program, a
password window shows up.

Copyright © 2005 Bluebird Soft, Inc. All Rights Reserved. < # >
BIP-5000
3. Product Specification
Sect. Specification
CPU Intel Xscale PXA270
OS Win CE 5.0
DISPLAY 3.5”, 240 x 320 / 260,000 color
INTERFACE
1 x USB 1.1 Client
1 x RS-232C
SD slot
IrDA 1.2 (Option: IrFM) (Option: Bluetooth class )
CAMERA 2.0M pixel camera
BATTERY 2000mAH
SIZE mm x mm x mm x
WEIGHT g
ADAPTER
Product InformationProduct Information

Copyright © 2005 Bluebird Soft, Inc. All Rights Reserved. < # >
BIP-5000
1. Battery Installation and Removing
[Battery Installation] [Removing the Battery]
•Insert the battery at the groove and slide the
battery to the lock In the direction of arroow. •Slide the battery lock to the unlock
position in the direction of arrow to
remove the battery.
※It is recommended to power off the phone before you remove the battery.
Sudden power interruption may cause a failure to the phone.
StartupStartup

Copyright © 2005 Bluebird Soft, Inc. All Rights Reserved. < # >
BIP-5000
StartupStartup
2. Charging Battery
[If connected to the cradle using the adaptor] [If connected to PDA directly using the]
* Connect the cradle as shown in above the figure. * Connect the jack attached with Converter to PDA.
* Key point : It is recommended to use the supplied adapter with the product for the most safe and effective use.

Copyright © 2005 Bluebird Soft, Inc. All Rights Reserved. < # >
BIP-5000
StartupStartup
2. Battery Charging
[Battery Charging Time and Life]
* Battery charging time may vary depending on the charging condition. If the battery life shorter by more than half to
new battery, please purchase new battery.
Life Standard
(2000mhA)
Continuous
Call
Continuous
Wait
Charging Time Standard (2000mhA)
Time
* To prevent loss of battery power, the modem automatically powers off. Then, recharge it.
•Battery’s Continuous Call and Wait Time was measured in an actual environment, but may vary depending on the
condition and environment where you use the product.
[Battery Charged]
In Charging Charging
Completed
Charging
Lamp Red Green
* If the charging lamp changed to green in the cradle or PDA, it indicates that charging completes. Continuous
charging will not cause damage to the product.

Copyright © 2005 Bluebird Soft, Inc. All Rights Reserved. < # >
BIP-5000
3. Startup
[Terminal Power up]
-Power Button
StartupStartup
• Press the Power Button to turn on the terminal.
• With power on, press the Power Button for about 2 seconds to turn on/off the Front Light.

Copyright © 2005 Bluebird Soft, Inc. All Rights Reserved. < # >
BIP-5000
StartupStartup
3. Terminal Startup
[Using the Stylus Pen (How to use Stylus Pen, Tab, Drag)]
* You can use the stylus to point, click, and run various objects on the screen.
# Take out the stylus
: Take out the stylus from the lower side of terminal (hand strap).
# Tab
: Touch the screen once with the stylus to open items and select options. It works like the left button of a mouse.
# Drag
: Hole the stylus on the screen and drag across the screen to select text and images. Drag in a list to select
multiple items. It works like drag of a mouse.
# Tap and Hold
: Tab and hold the stylus on an item to see a list of actions available for that item. Then, a pop-up menu appears.
It works like the right button of a mouse.

Copyright © 2005 Bluebird Soft, Inc. All Rights Reserved. < # >
BIP-5000
StartupStartup
3. Terminal Startup
[Screen Setup]
* You can use the stylus to point, click, and run various objects on the screen.
If pressed lightly the target in the center using the stylus, the
target moves to the upper left, lower left, upper right up, and
etc. Then tab exactly the target using the stylus (Then, the
Input Value of Stylus Pen completes on the LCD, e.g. Stylus
Adjustment completes).
CEZoom0
* Tab exactly in the order of center, upper left, lower left, and
lower right.
Tab the center of a cross symbol. Repeat it whenever
a cross symbol moves.
Press <ESC> key to cancel it.

Copyright © 2005 Bluebird Soft, Inc. All Rights Reserved. < # >
BIP-5000
StartupStartup
3. Terminal Startup
[Install Wizard Window of Win CE]
* After a completion of Install wizard, it appears as shown in the figure.

Copyright © 2005 Bluebird Soft, Inc. All Rights Reserved. < # >
BIP-5000
Product
Information
Product
Information
3. Terminal Startup
Sect. Description
Function + 1 Brightness Level Down.
Function + 2 One space up.
Function + 5 Code Input.
Function + 6 One space right.
Function + 7 Page Down
Function + 8 One space down
Function + 3 Brightness Level Up.
Function + 4 One space left.
Function + 9 Page Up
Function + 0 Code Character.
Function + 1 User-defined Program.
Function + 1 User-defined Program.
Function + 1 User-defined Program.
-Using Keypad with Function key
-Press Function key and Function Button simultaneously to run as follows.

Copyright © 2005 Bluebird Soft, Inc. All Rights Reserved. < # >
BIP-5000
Network
Connection
Network
Connection
1. Scan
[Using Laser Scanner] [Using CMOS]
* Place the terminal toward barcode to press Left/Right button as shown in the
above figure.
[correct]
[incorrect] [correct]
- Barcode readable in any direction.

Copyright © 2005 Bluebird Soft, Inc. All Rights Reserved. < # >
BIP-5000
Network ConnectionNetwork Connection
1. Scan
[Laser Barcode Basic Test]
1) Open Memo-pad.
2) Open New Memo.
3) Press Barcode Button on the barcode to be red toward Barcode Reader.
4) The result barcode will be output in new memo of a memo pad.
* If used the barcode of a specific program, please contact the manufacturer of the program.

Copyright © 2005 Bluebird Soft, Inc. All Rights Reserved. < # >
BIP-5000
Network ConnectionNetwork Connection
1. Scan
[CMOS Barcode Basic Test]
1) Open Memo-pad.
2) Open New Memo.
3) Press Barcode Button on the barcode to be red toward Barcode Reader.
4) The result barcode will be output in new memo of a memo pad.
* If used the barcode of a specific program, please contact the manufacturer of the program.

Copyright © 2005 Bluebird Soft, Inc. All Rights Reserved. < # >
BIP-5000
Network
Connection
Network
Connection
2. Ear jack
[Using Ear jack] [Using Converter]
•Remove the cover of ear jack and
then plug it in correctly as shown in the figure. •Plug in Terminal –Converter –Earphone
correctly as shown in the figure.

Copyright © 2005 Bluebird Soft, Inc. All Rights Reserved. < # >
BIP-5000
[reset]
Network ConnectionNetwork Connection
3. Terminal Reset
• Use the stylus pen to press the Reset Button slightly.
※ Normally, you do not need to reset your phone. However, if your terminal does not turn on or respond,
perform a soft reset may solve the problem.
※ It is similar with resetting of the computer and all records will be lost unless you have made a backup.