Piedmont 300C User manual

customerser[email protected]om 844-424-2467
CAR
& TRUCK
DIAGONAL CABLE
300C, 700C
Installation Steps:
1Park your vehicle on level ground and make sure that parking brake is set.
Cables are to be installed on the drive axle.
2Lay the cables on the ground with the smooth side of the cross-member
hooks (stamped “Tire Side”) facing upward.
3
Reach around to the back side of the tire with both arms; grabbing the
ends of the split side cable. Pull both ends to the top of the tire so that the
fasteners can be seen and handled easily.
4
Move the cables in a sweeping motion under the vehicle so that they are on
the back side of the tire.

Center the cable chains on the tire so that each side cable extends and
equal distance down the side walls of the tire. At the top of the front side
of the tire, take the nub end of the outside cable and connect it through
the keyhole fastener.
5
Grab the outer cable with both hands and pull it towards you to removing
as much slack as possible.
customerser[email protected]om 844-424-2467
Installation Steps:
6
CAR
& TRUCK
DIAGONAL CABLE
300C, 700C
Fasten them by connecting the quick hook to the chain link.
Take the nub end of the lower outside cable and connect it through the
keyhole fastener.
7
8

Now, enjoy your new tire chains!
customerser[email protected]om 844-424-2467
CAR
& TRUCK
DIAGONAL CABLE
300C, 700C
9
Installation Steps:
10
Attach the rubber adjuster to each of the six sections on the outer side
cable to remove any additional slack. To make this process easier,
connect the first hook at the 1 o’clock position, the next directly opposite
at the 7 o’clock position, and so forth.