Pierlite NLBMAFR4040-FBD User manual

Installation instruction
1 3
4 5 6
7 8 9
10 11 12
12
3
Product list: lamp body base plate
1 2
pole
3power cord
4
accessories bag
5
2
Fix the bottom pole onto base plate
Insert the lamp holder into
the other end of the pole
Lamp holder fixed ready by step6,7,8
Fix the lamp holder with screws-1
Fix the lamp holder with screws-2 Fix the lamp holder with screws-3
45
Connect the terminal block
Open the box of lamp body
Close the box by screws Insert the power cord

1. Short press to turn on/off.
2. Long press to dimming.
Motion Sensor Motion Sensor &
Daylight sensor
A.Motion Sensor
B.Daylight Sensor
30min 30min
1. turn on the lamp 2. The lamp brightness reduce to
30% when there is no presence
3. After another 30min, the lamp
switches off automatically when
still no presence detected
4.The lamp will switches on
automatically at once when there
Here to tell you how to play Motion Sensor & Daylight Sensor
0
1
2
3
open
0
1
2
3
swithes
Motion
sensor Daylight sensor
OFF OFF
ON OFF
ON ON
OFF ON
0
1
2
3
After each time manually adjust the brightness, the control unit record the brightness which sensor detected and save this memory
until the next time brightness dimming. （ ）Note: please be sure to adjust and dim the lamp at a comfortable and soft light state
The control unit can dims light output down or up automatically according to the changes of environment brightness to have a
relatively constant light level for a desk in office situation.
in 30min is presence detected.
Open the top cover, adjust the dip switch to the module by screwdriver.
Dip information
Manual