Pioneer SPH-EVO93DAB User manual

Installation manual CA-HM-UNI-EVO.006 | Version 1.0
Mount the locking tabs (bulge up) onto the unit support
Install the side support with a wrench n°7 (not included)
Install the sliding mecha with the supplied hardware
Once finalised, mount the complete bracket to the silver box
using the supplied hex screws
1 2
43
SPH-EVO93DAB
KIT INSTALLATION 1 DIN réglablePOUR
CA-HM-UNI-EVO.006
Habillage 1 DIN
Habillage écran
Cache connecteur
Cage 1 DIN
Pièces d'ajustement
Support écran
Fixation écran
Pattes métalliques

Installation manual CA-HM-UNI-EVO.006 | Version 1.0
Slide the metal cage into the vehicle with the opening on top
Put the screen holder on and fix only the top two screws
Close the locking tabs and secure with the necessary screws
Click the plastic tabs onto the metal holder as shown (L+R)
Whilst sliding the silver box in the car pull the display cable
through using some tape and extension cable CD-RGB150E
(not included)
install the metal holder - you can adjust height and angle
by using different positions
Put the DIN cover over the unit
By using the two top screws, mount the screen holder
to the screen
5
11
6
12
8
10
7
9

Installation manual CA-HM-UNI-EVO.006 | Version 1.0
After having to determined the correct position
install the bottom cover
13
Fix the bottom cover using two screws -
If the bottom cover collides with the metal bracket,
you need to break off some strips
14
Slide the screen into the support and secure with two screws
15
Verify the necessary lenght of the neck cover
16

Installation manual CA-HM-UNI-EVO.006 | Version 1.0
Final product image
Slide the cover onto the screen and fix the screwInstall the neck cover onto the screen and fix the screws
Put the screw cover over it
17
19 20
18