Pioneer MVH-S21BT User manual

MVH-S21BT
DIGITAL MEDIA RECEIVER
Owner's Manual
English

2En
▋
Contents ▋ Before You Start
Thank you for purchasing this PIONEER product.
To ensure proper use, please read through this manual before using this product. It
is especially important that you read and observe WARNINGs and CAUTIONs in this
manual.
Please keep the manual in a safe and accessible place for future reference.
WARNING
• Donotattempttoinstallorservicethisproductbyyourself.Installationorservicing
of this product by persons without training and experience in electronic equipment
and automotive accessories may be dangerous and could expose you to the risk of
electric shock, injury or other hazards.
• Donotattempttooperatetheunitwhiledriving.Makesuretopullotheroadand
park your vehicle in a safe location before attempting to use the controls on the
device.
CAUTION
• Donotallowthisunittocomeintocontactwithmoistureand/orliquids.Electrical
shock could result. Also, damage to this unit, smoke, and overheating could result
from contact with liquids.
• Alwayskeepthevolumelowenoughtohearoutsidesounds.
• Thisproductisevaluatedinmoderateandtropicalclimateconditionunderthe
Audio, video and similar electronic apparatus - Safety requirements, IEC 60065.
If you experience problems
Should this unit fail to work properly, please contact your dealer or nearest authorized
PIONEER Service Station.
Before You Start.................................................................................. 2
Basic Operation.................................................................................. 3
Detaching the front panel.............................................................. 3
Connections ........................................................................................ 3
Specications...................................................................................... 4

3
En
▋
Basic Operation
M.C. (multi-control) dial
SRC/OFF
BAND/DIMMER Display window Detach button
Hook Button
DISP/DISPOFF
Frequently used operations
Purpose Operation
Turn on the power When ignition on or system recovery, the unit
power on automatically.
Adjust the volume Turn the M.C. dial.
Select a source PressSRC/OFFrepeatedly.
Change the display
information
Press DISP repeatedly.
Return to the previous
display/list
PressBAND/DIMMER .
Return to the normal display
from the menu
PressBAND/DIMMER .
Answering/endingacall Press .
▋
Detaching the front panel
Detach the front panel to prevent theft. Remove any cables and devices
attachedtothefrontpanelandturnotheunitbeforedetachingit.
Detach Attach
▋
Connections
1. Rear line output
2. Antenna input
3. Power cord input
4.Fuse(10A)

4En
▋
Specifications
General
Power source:
14.4 V DC (10.8 V to 15.1 V allowable) Negative ground
Maximum current consumption:
10.0 A
Dimensions (W × H × D):
DIN
Chassis: 178 mm × 50 mm × 97 mm
Nose: 188 mm × 58 mm × 17 mm
D
Chassis: 178 mm × 50 mm × 97 mm
Nose: 170 mm × 46 mm × 17 mm
Weight:
0.5 kg
Audio
Maximum power output:
 49W×4ch/4Ω
Continuous power output:
 22W×4(50Hzto15000Hz,5%THD,4Ωload,bothchannelsdriven)
Load impedance:
 4Ω(4Ωto8Ωallowable)
USB
USBstandard specication:
USB 2.0 full speed
Maximum current supply:
500 mA
USB Protocol:
MSC (Mass Storage Class)
AOA (Android Open Accessory) 2.0
Filesystem:FAT12,FAT16,FAT32
FM tuner
Frequencyrange:
87.5 MHz to 108.0 MHz
Usable sensitivity:
 11dBf(1.0μV/75Ω,mono,S/N:30dB)
Signal-to-noise ratio:
72 dB (IEC-A network)
AM tuner
Frequencyrange:
531 kHz to 1 602 kHz (9 kHz)
530 kHz to 1 640 kHz (10 kHz)
Usable sensitivity:
 25μV(S/N:20dB)
Signal-to-noise ratio:
58 dB (IEC-A network)
Bluetooth
Version: Bluetooth
3.0 + EDR
Output power:
+4 dBm Maximum (Power class 2)
Frequencyband(s):
2 402 MHz to 2 480 MHz
Bluetooth proles:
GAP (Generic Access Prole) 1.1
SDAP (Service Discovery Application Prole) 1.1
 HFP(HandsFreeProle)1.6
A2DP (Advanced Audio Distribution Prole) 1.2
•Specications and the design are subject to modications without notice.

5
En
▋
Appendix
FCC STATEMENT
1.ThisdevicecomplieswithPart15oftheFCCRules.Operationissubjecttothe
following two conditions:
(1) This device may not cause harmful interference.
(2) This device must accept any interference received, including interference that may
cause undesired operation.
2. Changes or modifications not expressly approved by the party responsible for
compliance could void the user’s authority to operate the equipment.
NOTE: This equipment has been tested and found to comply with the limits for a Class B
digitaldevice,pursuanttoPart15oftheFCCRules.Theselimitsaredesignedtoprovide
reasonable protection against harmful interference in a residential installation.
This equipment uses and can radiate radio frequencies and, if not installed and
used in accordance with the instructions, may cause harmful interference to radio
communications. However, there is no guarantee that interference will not occur in a
particular installation. If this equipment does cause harmful interference to radio or
televisionreception,whichcanbedeterminedbyturningtheequipmentoandon,
the user is encouraged to try to correct the interference by one or more of the following
measures:
• Reorientorrelocatethereceivingantenna.
• Increasetheseparationbetweentheequipmentandreceiver.
• Connecttheequipmentintoanoutletonacircuitdierentfromthattowhichthe
receiver is connected.
• Consultthedealeroranexperiencedradio/TVtechnicianforhelp.
FCC Radiation Exposure Statement
ThisequipmentcomplieswithFCCradiationexposurelimitssetforthforan
uncontrolled environment. This equipment should be installed and operated with
minimum distance 20cm between the unit & your body.
IC STATEMENT
This device complies with Industry Canada’s licence-exempt RSSs. Operation is subject
to the following two conditions:
(1) This device may not cause interference; and
(2) This device must accept any interference, including interference that may cause
undesired operation of the device.
Cet appareil est conforme aux CNR exemptes de licence d'Industrie Canada . Son
fonctionnement est soumis aux deux conditions suivantes :
( 1 ) Ce dispositif ne peut causer d'interférences ; et
( 2 ) Ce dispositif doit accepter toute interférence , y compris les interférences qui
peuvent causer un mauvais fonctionnement de l'appareil.

2018.
P/N:127075000XXXX
PIONEER CORPORATION
28-8, Honkomagome 2-chome, Bunkyo-ku,
Tokyo 113-0021, JAPAN
PIONEER ELECTRONICS(USA)INC.
P.O. Box 1540, Long Beach, California 90801-1540,U.S.A.
TEL:[phone]
PIONEER EUROPE NV
Haven 1087, Keetberglaan 1, B-9120 Melsele, Belgium/Belgique
TEL:[phone]
PIONEER ELECTRONICS ASIACENTRE PTE. LTD.
2 Jalan Kilang Barat, #07-01, Singapore 159346
TEL: [phone]
PIONEER ELECTRONICS AUSTRALIA PTY. LTD.
5 Arco Lane, Heatherton, Victoria, 3202 Australia
TEL:[phone]
PIONEER ELECTRONICS DE MÉXICO S.A. DE C.V.
Blvd. Manuel Ávila Camacho 138, 10 piso
Col.Lomas de Chapultepec, México, D.F. 11000
TEL: [phone], FAX: [phone]
󰆭鋒󰌭󰇃󰀫
󰁳 407 號8
電話886-(0)2-2657-3588
󰆭鋒電󰒨(󰇈 )󰌭󰇃󰀫
󰇈長 909 號5
電話852-2848-6488
http://www.pioneer-mea.com
http://global.pioneer/en/info/globalnetwork/