Plejd DAL-01 User manual

Compliant to standards
Hereby, Plejd AB declares that the radio
equipment type DAL-01 is in compliance
with Direcve 2014/53/EU.
The full text of the EU declaraon of
conformity is available at the following
internet address: plejd.com/compliance
Mains electricity
230 VAC/50 Hz, max 0.05 A
Standby power
0.4 W
External operating temperature
-25 to +35 °C
Dimensions
46x46x18 mm
Protection
Overtemperature software
Short circuit protection
DALI bus
Max 64 DALI loads
Guaranteed supply current 128 mA
Maximum supply current 150 mA
Max cable length 300 m (1.5 mm2)
Basic insulation
Radio
2.4 GHz mesh
Bluetooth®
<10 dBm
Radio range
Approx. 10 m indoors
The Plejd mesh technology extends the range by
allowing the units to communicate with each other
DAL-01
0290.3.1
EN
INSTALLATION MANUAL
Further information can be found
in the Plejd app or at plejd.com
RISK OF INJURY TO PERSON OR PROPERTY
All work on the appliance must be
carried out by an authorized electrician.
National laws and regulations
must be followed.
Plejd AB
Krokslätts Fabriker 27A
431 37 Mölndal, Sweden

Install the product in the appliance box behind the
push button/box lid or secure it with a Mounting clip
(MNT-01, not included) on the wall or DIN rail.
Connect the product according to the wiring diagram.
DAL-01 comes with a built-in power supply, so there is
no need to use a dedicated DALI power supply for the
DALI bus.
The short circuit protection activates after 2 seconds,
and recovers after 13 seconds.
Connect the product
DAL-01
DA+DA-
N1 2
LL
L
N
Control inputs 1 and 2 can be used for control with:
· push button (preset)
· light switch
· motion sensor (with neutral conductor).
The inputs can also be used to wirelessly control one
or more products from Plejd. Additionally, double click
on a push button can be used to activate scenes.
Control inputs 12
Support
Follow the instructions in the app
Hand over the Plejd system
Hand over the Plejd system to your customer by
writing the system code on the included sticker .
You will find the code in the app once you have
completed the installation.
Place the sticker in the distribution box and give
the welcome folder HI! to the customer.
In the event of any technical questions,
please contact our customer service:
[email protected] | [phone]
Download the Plejd app on the App Store or
Google Play.
After supplying power to the unit by following
the wiring diagram, use the app to complete
the installation. Setup requires Bluetooth®and
an internet connection. You do not need any
additional equipment to get started. Use the
app to easily configure all settings.