Pneumercator TMS 3000 User manual

–
TMS Quick Reference.doc Page 1 of 2 July 1, 2009
TMS Quick Reference Guide
Alarm LEDs* Display Mode LEDs
LEAK – In-Tank / Sensor GAL – Gross Volume (Gallons)
Net Volume (with ºF LED on)
SP1 – Above 95% (High High) %GAL – Percent of Capacity
SP2 – Above 90% (High) ULL – Ullage Vol (Gallons, Default 90%)
SP3 – Below 20% (Low) IN – Product Level (Inches)
Water Level (with “u” symbol, inches)
WATER – Above 2” ºF – Product Temperature (ºF)
Front Panel Buttons
PAPER FEED PRINT MODE TANK SELECT TEST
Press to advance Press for Current Press to display tank name. Press to select tank Press to test
paper Inventory / Sensor Press and hold until beep Press and hold until display and
Status report to select display mode beep for autoscan horn
STEP GROUP SELECT EDIT
Current Inventory / Sensor Status Report: Press PRINT button.
* If an alarm LED is blinking, an active tank alarm is present on a tank(s) not currently being displayed. When
an alarm LED is on continuously, it applies to the currently displayed tank. Note that this alarm may apply to
more than one tank, which can be determined by viewing each tank with the TANK SELECT button.
Site Name Tech Support Phone
Site Location Emergency Phone
Audible Alarm
Acknowledgment
To silence an alarm,
press any of the right
three buttons. The visual
indicator will remain
active as long as the
alarm condition persists.
A theft alarm can only
be silenced by pressing
the ACKNOWLEDGE
pushbutton located on
the inside of the front
door.
Visual Alarm
Acknowledgment
The only visual alarms
that can be cancelled
are failed in-tank leak
test and no monthly in-
tank leak test. These
visual alarms are
deactivated by pressing
the ACKNOWLEDGE
pushbutton located on
the inside of the front
door. All other visual
alarms are persistent
until remedied.

TMS Quick Reference.doc Page 2 of 2 July 1, 2009
Print Log Procedure
Print Log(s)
selected log
Return
ReturnReturn
Return selected log
Log
LogLog
Log Return
ReturnReturn
Return Log
LogLog
Log
Return
ReturnReturn
Return normal mode
Return to Normal Display Mode*
Inventory
InventoryInventory
Inventory
L
E
G
E
N
D
Log
LogLog
Log
Enter Access Mode
Press and release. Press and hold
until second beep.
Flashing Display
While holdin
Note: the list of logs may vary with the version of firmware in the TMS.
g the TEST button, hold the MODE button until is displayed, then release buttons.
,
EDIT EDIT
,,
,
or
,,
STEP EDITEDIT
,,
or EDIT
,
Inventory
InventoryInventory
Inventory
Log
LogLog
Log Inventory
InventoryInventory
Inventory
xxxxxxxxxx xxxxxx xxxxxx xxxxx
xxxxxxxxxx xxxxxx xxxxxx xxxxx
xxxxxxxxxx xxxxxxxxx xxxxxxx
xxxxxxxxxx xxxxxx xxxxxx xxxxx
xxxxxxxxxx xxxxxxxxx xxxxxxx
xxxxxxxxxx xxxxxx xxxxxx xxxxx
xxxxxxxxxx xxxxxxxxx xxxxxxx
xxxxxxxxxx xxxxxx xxxxxx xxxxx
xxxxxxxxxx xxxxxx xxxxxx xxxxx
xxxxxxxxxx xxxxxxxxx xxxxxxx
xxxxxxxxxx xxxxxx xxxxxx xxxxx
xxxxxxxxxx xxxxxxxxx xxxxxxx
xxxxxxxxxx xxxxxxxxx xxxxxxxx
selected log
*Return to normal tank gauging
display mode may also be achieved
by allowing console to timeout for
four minutes with no pushbutton
activity.
1.
2.
3.
PRINT
rEturn
Events
ALarms
tank Leak
LIne Leak
Water
Orders
tHefts
saLes
deLivery
Inventory
Leak Hist