Podwurx BIG 60 User manual

Installation guide
Welcome to you new Podwurx A90 supra BIG 60 gauge pod!
Make sure that you have what is shown here before you start

1 pod and one square "O"ring

Then start by removing the center speaker grill from the dash. This is not a easy part to
remove, it will take some force.
Pry up on a leading edge until you can get your fingers under the panel and apply more grip to
pull up. (This grill is snap fit and no fasteners are holding it in place)

Be careful when lifting off the dash as
there are 2 hook shaped metal tabs that go under the screen bezel you will have to tip it up,
out and forward in one movement.

You will find 2 screws, these will require a (T20) Torx bit, remove both screws.
Now lift the screen in an up and slightly back motion, it will not be completely loose there are
2 pressure clips that additionally hold the display to the dash.

Note: these clips stay in the dash!
Now that the display unit if free from the dash unplug the connector.
The screen is now free to take out of the car and on to a clean dry bench or work place.

Using a soft cloth or microfiber to work on will reduce the chance of scratching the screen and
The bezel and the new Big 60 pod as well.
Now carefully and by hand use your fingers to snap the rear cover off the assembly.

With the rear cover (bezel) removed, the new PodWurX gauge pod can be snapped in to its
place.
Gently snap with fingers all the way around the perimeter until evenly secure.

When finished it should look like this, It is now ready for reinstallation in to the car.

Now reinstall the screen connector, and if needed run the connection wires or lines though
the gauge pods opening to the cup. This can be done afterwards if needed as the opening is
ample. Then snap the assembly
back on to the dash, make sure the
clips shown previously by green
arrows are secure in the dash.