Polaroid DIGITAL 320 User manual

Camera Features
a
Self-timer button
b
Shutter button
c
Battery door
d
Tripod mount
e
Viewfinder
f
Picture counter/
status panel
g
Serial connector port
h
ON/OFF switch
i
Power indicator light
ab
cdef
g
h
i

To load the battery
1
Open the battery door as shown.
2
Insert one 9-volt battery into the
compartment. Make sure that the
battery terminals (
+
and
–
) are
properly positioned as shown.
3
Close the battery door.
You are now ready
to take pictures!

To take a picture
1
Turn on the camera.
The green power light on the back
of the camera is lit.
If the green power light is not lit,
check to make sure the battery is
properly loaded.
If you are taking a picture to use with
your Cosmopolitan
TM
Virtual Make-
over
TM
2 Software, see the next sec-
tion for important
information.

Indoor pictures
3 – 6 feet
Brightly lit room with a mixture of
sunlight and lamp light
Outdoor pictures
3 ft – infinity
Sunlight or bright shade. Avoid intense
sunlight that may cause sun spots in
pictures
Always make sure that the sun or other
light source is behind the person taking
the picture.

2
Look through the camera view-
finder to frame your picture. Hold
the camera steady and press the
shutter button. Keep holding the
camera steady until you hear a beep
sound. The beep indicates that a
picture was taken.
The picture counter on the back of the
camera tells you how many pictures you
have stored in your camera’s memory.
If you don’t use your camera but leave the power on, your camera goes into
power saving mode (to save battery power). When the camera is in power saving
mode, it beeps until you use it or turn the power off.
To take a picture while the camera is in power saving mode, compose your
picture and press the shutter button. The camera turns on and takes the
picture normally.

Tips for great COSMO Virtual
Makeover 2 pictures
Follow these steps below to get great
pictures to use with your COSMO
Virtual Makeover 2 Software.
1
If you have long hair, tie it up
tightly into a ponytail.
2 Wear a neutral, light colored shirt.
3 Remove your makeup and jewelry.
4 Sit straight in a chair with your
back against a light colored wall
(preferably white or light tan).

5
Have the person taking the picture sit in a chair directly across from the subject at
a distance of approximately 3 feet.
6
Have the subject look straight into the camera, with a slight smile
(do not show teeth).
7
Frame the subject in the viewfinder. Be sure to capture the subject from just
above the shoulders to the top of the head. Leave some space above the subject’s
head in the picture.
8
Hold the camera steady and press the shutter button. Keep holding the camera
steady until a beep is heard. When you hear the beep, a picture was taken.
For more helpful picture taking tips, see the Polaroid Digital 320 Camera FAQ
included on your COSMO Virtual Makeover 2 Software CD-ROM, or visit:
www.virtualmakeover.com

To transfer pictures to
your computer
1
Turn off your computer and any
peripherals (scanner, printer).
2
Connect the serial cable to the serial
port on your computer.
3
Connect the other end to the serial
port on the camera.
4
Turn on your computer.
5
Start your COSMO Virtual Make-
over 2 Software.

6
Click on Get Started from the main
window.
7
Click Get My Image on the Prepare
Yourself window.
8
The Select Source window opens.
Click Polaroid Digital 320 camera
and click Select.
9
The Polaroid Digital 320 Camera
TWAIN software opens. The
TWAIN software is used to down-
load, delete, and save images from
your camera.
Note: The image editing applica-
tion being used with the TWAIN
software is shown on the left side of
the window as an icon.
COSMO Virtual Makeover 2 Software
Polaroid Digital 320 TWAIN Software