Polaroid ID100 Operating instructions

Repair Manual
Americas Business Center
Technical Services
201 Burlington Road
Bedford MA 01730
TEL: [phone]
FAX: [phone]
ID-100 (Vertical )
May 1997

ID-100 Manual Addendum
2
VERTICAL ID-100 CAMERA
Description
The Vertical ID-100 System is basically a standard ID-100 camera with the
Optical Assembly/Data Card Holder mounted in the vertical position (Refer to
Figure 1). The data card is inserted from the top. This produces a vertical ID
card with subject and data appearing one on top of the other instead of side-by-
side. To accommodate this change, some modifications were necessary.
Figure 1
Modifications
Note: All new part numbers are designated in the illustrations and in the table on
page 6.
Repositioning the Optical Assembly/Data Card holder resulted in the following
modifications:
1. A new molded Front Shroud and extended Data Card Guide (Refer to
Figure 2).
Optical Assembly/Data Card
Holder (vertically aligned)
Data Card Slot

ID-100 Manual Addendum
3
Figure 2
2. The following Logic Board and Strobe Board connectors were modified
because they were obstructed by the repositioned Optical Assembly/Data
Card Holder:
Logic Board (Refer to Figure 3)
• DC to DC Converter Board Harness connector (P1).
• Subject and Data Shutter Solenoid Harness connector (P5).
Subject Strobe Board (Refer to Figure 4)
• Capacitor Board Harness connector (P1)
• Logic/Subject/Data Harness connector (P2)
New Molded
Front Shroud
(PN 70100V)
Vertical Card Guide
(PN 70154V)

ID-100 Manual Addendum
4
Figure 3 Logic Board
Figure 4 Subject Strobe Board
Modified Harness
Connector (P5)
Note: Harness plugs into side
of connector instead of top
Modified
Harness
Connector (P1)
DC to DC Harness
(PN 70140V)
Subject/Data
Shutter Solenoid
Harness
Logic/Subject/Data
Harness
(PN 70141V)
Modified Logic/Subject/Data
Harness Connector (P2)
Capacitor Harness
Connection
Note: Harness leads are soldered
on underside of board
Logic Board
(PN SA71400V)
Subject Strobe Board
(PN SA71000V)

ID-100 Manual Addendum
5
3. To maneuver around the repositioned Optical Assembly/Data Card
Holder, the following harnesses were lengthened:
• DC to DC Harness (from Logic Board to DC/DC Converter Board)
- Refer to Figure 3.
• Logic/Subject/Data Harness (from Logic Board to Subject Strobe
and Data Strobe Boards) - Refer to Figure 3.
• Capacitor/Data Strobe Harness (from Capacitor Board to Data
Strobe Board) - Refer to Figure 5.
Figure 5
Camera Repair
Refer to the ID-100 Repair Manual for all repairs. All parts are the same except
for those noted in this addendum.
Important
Prior to modification of the Logic and Strobe boards, all obstructed connections
were soldered. Also, harnesses were lengthened with splices. If any of these
cameras are returned for repair, be sure to replace boards and/or harnesses
with the new parts listed on the next page.
Capacitor/Data
Strobe Harness
(PN 70144V)

ID-100 Manual Addendum
6
Special Parts
Parts Description Part Number
Front Shroud 70100V
Vertical Card Guide 70154
DC/DC Harness 70140
Logic/Subject/Data Harness 70141
Subject Strobe Board SA71000V
Logic Board SA71400V