Safety Precautions
FCC Statement
1. This device complies with Part 15 of the FCC
Rules. Operation
is
subject
to
the following two
conditions:
(1)
This device may not cause
harmful interference.
(2)
This device must accept any
interference received, including
interference that may cause
undesired operation.
2.
Changes
or
modifications not expressly
approved by the party responsible for
compliance could void the user's authority
to
operate the equipment.
NOTE: This equipment has been tested and found
to comply with the limits for a Class B digital device,
pursuant
to
Part 15
of
the FCC Rules. These limits
are designed
to
provide reasonable protection
against harmful interference
in
a residential
installation. This equipment generates uses and can
radiate radio frequency energy and, if not installed
and used
in
accordance with the instructions, may
cause harmful interference
to
radio communications.
However, there
is
no guarantee that interference
will not occur
in
a particular installation. If this
equipment does cause harmful interference
to
radio
or
television reception, which can be determined
by turning the equipment off and on, the user
is
encouraged
to
try
to
correct the interference by
one or more of the following measures: Reorient
or relocate the receiving antenna. Increase the
separation between the equipment and receiver.
Connect the equipment into
an
outlet on a
circuit different from that to which the receiver
is
connected. Consult the dealer or an experienced
radio/TV technician for help.
FCC Radiation Exposure Statement
This equipment complies with FCC radiation
exposure limits set forth for
an
uncontrolled
environment. This equipment should be installed
and operated with minimum distance 20cm
between the radiator & your body.
FCC RF Warning
This equipment must
be
installed and operated
in
accordance with provided instructions and the
antenna(s) used for this transmitter must be installed
to
provide a separation distance of at least 20 em from
all
persons and must not be co-located or operating
in
conjunction with any other antenna
or
transmitter.
End-users and installers must be provide with antenna
installation instructions and transmitter operating
conditions for satisfying
RF
exposure compliance.
IC Warning
Canada, Industry Canada (IC) Notices
This Class B digital apparatus complies with Canadian
ICES-003 and RSS-21
0.
Operation
is
subject to the
following
two
conditions:
(1)
this device may not cause interference, and
(2)
this device must accept any interference,
including interference that may cause undesired
operation of the device.
Radio Frequency (RF) Exposure Information
The radiated output power of the Wireless Device
is
below the Industry Canada
(IC)
radio frequency
exposure limits. The Wireless Device should be used
in
such a manner such that the potential for human
contact during normal operation
is
minimized.
This device has also been evaluated and shown
compliant with the
IC
RF
Exposure limits under mobile
exposure conditions. (antennas are greater than 20cm
from a person's body).