Poltronova Sanremo User manual

english
about
use indoor
typology standing lamp
year 1968
dimension 38 x 38 x 225 [h] cm
weight 12 kg
materials base and trunk in
pearlescent lacquered
sheet steel, leaves in
laser-cut Perspex®
voltage !220—240 V
!110—120 V
lamp 1 x LED
GU10
8W max
6400K
certifications
Sanremo instructions
warning
The safety of this fixture is only
guaranteed if the following instructions
have been complied with.
"The lighting system is made only for
the voltage listed in the about section in
the left column, under voltage.
"Always disconnect power before
cleaning the fixture or replacing the bulb.
"Always allow the lamp to cool before
replacing it.
"To place the leaves, follow the
instructions on the back.
"Mount and maintain the fixture
carefully so as not to damage components.
"Never place less than 20-30 cm from a
heat source.
"If exposed to direct sunlight, the
materials used in this product may show a
natural chromatic variation.
"Replacement bulbs must be of same
type and wattage as specified
in instructions.
"Use the appliance only with the power
supply provided and at the rated voltage
specified on the appliance.
"The appliance may in no way be
modified or tampered with. Any change
may compromise its security and void
the warranty.
"Poltronova will not be liable
for products that are modified or
used improperly.
"Poltronova will replace merchandise
with manufacturing defects only if the
product is intact in all its parts and
provided with the original or equivalent
packaging.
Centro Studi Poltronova
per il design srl
via Lorenzo Bartolini 2,
50124 Firenze — Italy
www.poltronova.it
[e-mail]

c.
a.
b.
d.
components
a. Perspex®leaves
b. foot switch
c. base
d. internal bulb lamp
assembly of the
leaves, bulb
replacement and
maintenance
To assemble the leaves, follow the
steps in figures 1 and 2. In order
to change the bulb, disconnect the
power supply and follow the steps
shown in figures 4 and 5. To clean
the lamp, use a soft damp cloth and
mild detergent.
5
Make sure the bulb is cold and
unscrew it.
3
Connect the power supply and use
the switch to turn the appliance on.
2
4
Remove the leaves and take the
lamp holder out.
1
Insert the palm leaves in the
following order.