PolyJohn Heated Grandstand PSW1-2100 User manual

PSW1-2100 - Heated Grandstand
January -2018
Page 1 of 4
PSW1-2100
Heated Grandstand™
Warm Water Wash
Stand with Wheels
User Manual
The PSW1-2100 Grandstand™ sink is easily
transportable warm water sink with a built-in handle
and rubber treaded wheels. Designed for use where
convenient hand washing is desired or required, such
as oces, classrooms, construction sites, festivals,
food service locations, etc., to be used indoors or
out. The compact design allows it to be used most
anywhere. Ideal where space is limited. Shipped
fully assembled.
General Overview
All materials, including resin, pigments
and additives used to make the plastic
components as well as the plumbing
components that come in contact with
the fresh water are U.S. FDA food grade
compliant.
Height 62 in 157.5 cm
Width 18 in 45.5 cm
Depth 22 in 55.9 cm
Fresh Water Capacity 15.5 gal 58.7 L
Gray Water Capacity 19 gal 72 L
Pump Capacity (per stroke) 2  oz 59.14 ml
Soap Dispenser Capacity 30  oz 887 ml
Number of Single Dispenses 992 992
Paper Towel Capacity 1 Roll or 500 Single Fold
(2 packs - Georgia Pacic 23504)
Weight Empty 47 lb 21.3 kg
Weight Full 177 lb 80 kg
Power Requirement 110 V 15 Amp
Nominal Water Temp 110o
Specications
POLYJOHN
USA
PolyJohn Enterprises Corp
2500 Gaspar Ave.
Whiting, IN 46394
Phone: [phone]
Fax: [phone]
www.polyjohn.com
[email protected]
POLYJOHN
WORLDWIDE
PolyJohn (UK) Ltd.
Equinox 1 Audby Lane
Wetherby, England LS22 7RD
Phone: [phone]
Fax: [phone]
www.polyjohn.co.uk
[email protected]
POLYJOHN
CANADA
PolyJohn Canada
P.O. Box 2300
199 Forest Plain Rd.
Orillia, Ontario LV3 6S2
Phone: [phone]
Fax: [phone]
www.polyjohncanada.ca
[email protected]

PSW1-2100 - Heated Grandstand
January -2018
Page 2 of 4
Water Heater Information
This unit is equipped with a heating element to heat the fresh water. It is con-
trolled by a built in thermostat to maintain a nominal water temperature of 110o.
The unit is equipped with a oat switch to turn off power to the heating element
if the water level should drop too low.
Emptying Fresh Water
Drain the fresh water by unscrewing the 1”
plug located at the bottom of the sink, to the
left of the foot pump. Tighten the plug when
nished.
Emptying Gray Water
Wheel the sink to a proper and approved
drain location. Pull the hose out from the rib on
the back of the holding tank, remove the hose cap and
empty the gray water. Replace the cap when nished.
Filling with Fresh Water
NOTE: Unit must be lled prior to plugging in the
heater. Unscrew the 1” ll plug located at the
top, left hand side of the wash basin. Insert a
standard 3/4” garden or similar type hose and
ll with a few gallons of fresh water to perform
a system check. Depress the pump a few times
to “prime” it (the pump has a built-in check valve
that will hold a prime between uses). If needed,
continue lling to the top (which is the 15.5 gal-
lon water level capacity). Tighten the plug when
nished.
Fresh Water
Fill Plug
Fresh Water
Drain Plug
Paper Towel Dispenser
These dispensers are designed to accept towels that are no wider than 9-1/2” wide,
whether using single, multi-fold, or a roll towel. The recommended towels are the
Georgia Pacic #23504 - single fold towel or the Baywest Ecosoft #46200 - roll towel.
Opening the Paper Towel Dispenser
Position your hands on both sides of the
dispenser cover (as shown). While pulling
out on both sides lift up the cover and pull
down towards yourself .
Filling the Dispenser
Filling with Fold Towels: Place the package
of towels on the towel tray with the fold of the
towel facing downward. Pull the rst towel through the
middle opening of the paper towel tray. Close the cover.
Filling with a Roll of Towels: Place the roll of towels on the spindle with the roll of
towels coming off towards you with the arrow end of the spindle facing towards the
right. Place the spindle into the right side of the dispenser rst.Place the left side
of the spindle into the groove on the left side of the dispenser and push down in
place. Feed the roll of towels over the front of the paper towel tray. Close the cover.
Operation Directions

PSW1-2100 - Heated Grandstand
January -2018
Page 3 of 4
Parts Drawing - Exploded View
http://www.polyjohn.com/pc-000632
http://www.polyjohn.com/pse2-2000
PC-000581G - Sink Tap
(2) PC-000107 - Rivet
(2) PC-000106 - Washer
PC- 000339
Elbow 3/8" Tube x 3/8" Npt
PC-000554 - 1" Fill Plug
PC-000345 - 1” O-Ring
PC-000325 - Straight
1" Npt x 3/4" Barb
PC-000351 - #10
Hose Clamp
CH075-037 - 3/4"
Drain Hose 37" Long
PSE2-0001
Sink Tank
PC-000415
Rubber UniSeal
CT38-046 - Tubing
3/8" O.D. x 46" Long
CT38-003
3/8" Tubing x 3" Long
PC-100421- Drain Plug Assembly
PC-000241 - 1” O-Ring
PC-000418 - UniSeal
PC-100421B - Drain Plug Body
PC-100421P - Drain Plug
PC-000600 - Baby Foot Pump
(4) PC-000102 - Rivet Small Flange
(4) PC-000106 - Washer
PS02-0003 - Foot Pump Plate
(2) PC-000147 - Screw
PSE2-0002
Cover Plate
(4) PC-000158 - Screws
PC-000660
GFCI Electrical Cord
HE01-0002
Sink Heater
PC-000633
Float Switch
PSE2-0003
Thermostat Mouting Plate
(2) PC-000154 Screw
HE01-0003
Heater Thermostat
PC-000632
Heater Relay
PC-000415
Rubber UniSeal
PC-000795 Serial ID Plate
(2) PC-000105 Rivets
http://www.polyjohn.com/pc-000581G
http://www.polyjohn.com/pc-000554
http://www.polyjohn.com/pse2-0001
http://www.polyjohn.com/pc-000415
http://www.polyjohn.com/pc-100421
http://www.polyjohn.com/pc-000600
http://www.polyjohn.com/ps02-0003
http://www.polyjohn.com/ct38-003
http://www.polyjohn.com/he01-0003
http://www.polyjohn.com/pse2-0003
http://www.polyjohn.com/pc-000415
http://www.polyjohn.com/pse2-0002
http://www.polyjohn.com/pc-000339
http://www.polyjohn.com/pc-000325
http://www.polyjohn.com/pc-000351/
http://www.polyjohn.com/ch075-037
http://www.polyjohn.com/ct38-046
http://www.polyjohn.com/pc-000660
http://www.polyjohn.com/he01-0002
http://www.polyjohn.com/pc-000633
http://www.polyjohn.com/pc-000632
http://www.polyjohn.com/pc-000107
http://www.polyjohn.com/pc-000106
http://www.polyjohn.com/pc-000241
http://www.polyjohn.com/pc-000418
http://www.polyjohn.com/pc-100421b
http://www.polyjohn.com/pc-100421p
http://www.polyjohn.com/pc-000102
http://www.polyjohn.com/pc-000106
http://www.polyjohn.com/pc-000147
http://www.polyjohn.com/pc-000154
http://www.polyjohn.com/pc-000158
http://www.polyjohn.com/pc-000345
http://www.polyjohn.com/pc-000795
http://www.polyjohn.com/pc-000105
PSE2-2000 Exploded View
Water Heater Information Cont.
The unit may take up to one hour to heat the water, depending upon the tempera-
ture of the water that it is lled with. The system is electrically protected with a
GFCI plug. If for some reason, the GFCI were to trip, simply push the reset button
on the plug. If the unit trips the GFCI protection again, remove from service, and
have a qualied electrician inspect the sink.
Soap Dispenser
To ll the soap dispenser, open it by turning the lid counter
clockwise and lifting the lid off. Fill with 30 uid ounces (or
desired amount) of liquid soap and reinstall the lid. To remove
the dispenser for transporting the unit, remove the lid, and lo-
cate the tab on the middle of the mounting plate at the rear of
the dispenser. Push in on it, and slide the dispenser up, and
off. Replace the lid back on the dispenser and lock in place by
turning the lid 1/4 turn.

PSW1-2100 - Heated Grandstand
January -2018
Page 4 of 4
www.polyjohn.com/pc-000213
www.polyjohn.com/pc-000417
www.polyjohn.com/euro-sink
www.polyjohn.com/pc-000175
www.polyjohn.com/pc-000140
www.polyjohn.com/pc-000123
www.polyjohn.com/pc-000222
www.polyjohn.com/pc-000105
www.polyjohn.com/paper-towel-dispenser
www.polyjohn.com/pc-000105
www.polyjohn.com/pc-000106
www.polyjohn.com/liquid-soap-dispenser
www.polyjohn.com/pc-000105
www.polyjohn.com/pc-000106
www.polyjohn.com/psw1-0021
www.polyjohn.com/psw1-0001p
www.polyjohn.com/pc-000417
www.polyjohn.com/pc-100316
www.polyjohn.com/pc-000354
www.polyjohn.com/ch100-0435
www.polyjohn.com/pc-000354
www.polyjohn.com/pc-000376
www.polyjohn.com/pc-000313
www.polyjohn.com/pc-000377
www.polyjohn.com/pc-000111
www.polyjohn.com/pc-000110
www.polyjohn.com/pc-000106
www.polyjohn.com/pc-000102
www.polyjohn.com/pc-100146
www.polyjohn.com/pc-100451
TD04-1000 - Paper Towel
Dispenser
(4) PC-000105 Rivet
(4) PC-000106 Washer
PC-000417
3/4” Uni-Seal
PSE2-2000
Euro Heated
Wash Stand
Complete
(2) PC-000175 - Screw
(2) PC-000140 - Nut
(4) PC-000123 - Washer Not Shown
PC-000222 - Spring Clip
(2) PC-000105 - Rivets
PSD1-1000 Soap
Dispenser
(3) PC-000105 - Rivet
(3) PC-000106 - Washer
PSW1-0001P
- Wash Stand W/Wheels Tank
PC-000377
- 3/4” Garden Hose Cap
PC-000313
- Rubber Hose Washer
PC-000376
- Fitting 1” x 3/4” MGHT
PC-000354
- Hose Clamp
CH100-0435
1”I.D. x 43.5” Long
PC-000354 - Hose Clamp
PC-100316 - Elbow
1” Barb x 1” Barb
PC-000417 - 3/4” Uni-Seal
PSW1-0021 - Axle
PC-000213 - Wheel,
Rubber Tread
PC-100451 - 4” Hatch and Cap
(1) PC-100146 - 12” Tether
(4) PC-000102 - Rivet
(3) PC-000106 - Washer
(1) PC-000110 - Rivet
(1) PC-000111 - Washer
Parts Drawing - Exploded View
Cleaning and Maintenance
Use a mild soap to clean all surfaces and component parts.
Minor scratches and abrasions can be lightly sanded or scrubbed with a
mild abrasive cleaner (such as “Soft Scrub”) that contains calcium carbonate,
hypochlorate bleach and detergents. Be sure to follow the cleaning product
directions since these ingredients may cause hazardous gases when mixed with
other chemicals. Rinse the cleaned area and buff with a conventional wax.
Some light scratches may also be hidden by using an industrial hot air gun.
To keep the water fresh add a “Fresh Sink Tablet” (chlorinated tablet)(our part
number CK01-0030) each time the sink is lled with water.
Winterizing
• Drain all water from the tanks.
• Flush tank with a solution of chlorine and water.
• Depress the foot pump to run the clorine solution through the lines.
• Drain all water from the tanks and while the drains are open, continue to pump
the foot pumps to clear all of the liquids from the lines.