PolyJohn PS14 Series Operating manual

PS14 Guide - July 2009
Page 1 of 4
POLYJOHN
USA
PolyJohn Enterprises Corp
2500 Gaspar Ave.
Whiting, IN 46394
Phone: [phone]
Fax: [phone]
www.polyjohn.com
[email protected]
POLYJOHN
WORLDWIDE
PolyJohn (UK) Ltd.
Equinox 1 Audby Lane
Wetherby, England LS22 7RD
Phone: [phone]
Fax: [phone]
www.polyjohn.co.uk
[email protected]
POLYJOHN
CANADA
PolyJohn Canada
P.O. Box 2300
199 Forest Plain Rd.
Orillia, Ontario LV3 6S2
Phone: [phone]
Fax: [phone]
www.polyjohncanada.ca
[email protected]
PS14 Series
4-Person Hand Wash Station
Operations & Maintenance Guide
All materials, including resin, pigments and additives
used to make the plastic components as well as the
plumbing components that come in contact with the
fresh water are U.S. FDA food grade compliant.
We recommend reading through the entire booklet prior
to proceeding with use, service or maintenance.
Height 58 in 147 cm
Width 22.5 in 57 cm
Depth 22.5 in 57 cm
Fresh Water
Capacity 20 gal 76 L
Gray Water
Capacity 22 gal 83 L
Pump Capacity
(per stroke) 2  oz 59.1 ml
Weight Empty 60 lb 27 kg
Weight Full 226 lb 103 kg
Paper Towel Dispenser
Four packs of single-fold towels (Georgia Pacic 23504)
250 towels per pack. 1000 per wash station.
Soap Dispensers
Capacity 4/30  oz 4/887 ml
Color Options
Granite Gray, Tan, Evergreen & Army Green
SPECIFICATIONS
Dimension Imperial Metric
NOTE: All dimensions are subject to change due to environmental factors.
PS14 Guide - July 2009
Page 2 of 4
General Product Overview & Operation Information
This self-contained, stand alone four person hand wash station is designed for
use where convenient hand washing is desired or required, such as food service
locations at outdoor events or construction sites. The compact design is ideal
for areas where limited space is available and is easy to transport. Supplied
fully assembled with a simplied plumbing system that is easy to maintain.
TOOLS REQUIRED FOR SERVICE OR MAINTENANCE
• Rivet Gun
• Drill with 13/64” bit
• Standard slotted screwdriver
Fresh Water Plumbing
The plumbing system in this sink is simple and requires minimal maintenance.
If the system becomes plugged, rst check the foot pumps. Depress each foot
pump and observe the level of resistance. If there is resistance and water is not
dispensed, there is most likely an obstruction in the tube or at the orice of the
water tap spigot. If there is no resistance and the water is not dispensed, then
either a.) a tube connection is loose or b.) an internal rubber part of the pump
needs replacing.
Drain Plumbing System
The drain system is designed to be virtually maintenance free. Each of the four
sink bowls are molded into the inner tank and the gray water drains directly
into it through the three drilled holes in the bottom of each basin. These holes
are kept small to minimize debris and foreign matter from entering the inner
holding tank.
Pump Removal
The base plate does not have to be removed for pump maintenance. The pumps
are fastened to the base plate with (4) PC-000104 - Rivets (which will have to be
drilled out to remove the pumps). Quick disconnect ttings are used throughout
the plumbing system. To disconnect the tubing, push the ring of the tting
toward the tting stem while at the same time pulling out on the tubing.

PS14 Guide - July 2009
Page 3 of 4
Service / Maintenance Information
Filling with Fresh Water
Unscrew the 1” plug located in the top corner of the sink. Insert a standard 1”
garden or similar type hose and ll with a few gallons of fresh water to perform
a system check. Depress each pump a few times to “prime” them (the pumps
have built-in check valves that will hold a prime between uses). Continue lling to
the 20 gallon water level capacity (which should take approximately ve minutes
with a standard garden hose and normal water pressure). The tank is full when
you can view the water level in the 1”hole. Tighten the plug when nished.
Emptying Fresh Water
Drain the fresh water by unscrewing the 1/2”plug located at the bottom of the
sink. Tighten the plug when nished.
Emptying Gray Water
NOTE: Certain geographical areas prohibit “dumping” of gray water and re-
quires proper disposal. Unscrew the 3”cap located in the top corner of the sink
to pump out the gray water. Tighten the cap when nished.
Access Inner Plumbing / Spigot Replacement
Drill out the (8) PC-000117 - Star Rivets that attach the outer tank to the inner
tower. Drill out the (8) PC-000104 - Rivets located at the spigots. Pull out the
spigots with elbows attached approximately 5”. Disconnect the tubing by
pushing the ring on the tting toward the tting stem while at the same time
pulling out on the tubing. To reattach the spigots, we recommend using PC-
000104 - Rivets with PC-000106 - Back-up Washers on the stems of the rivets.
To remove the paper towel holder, drill out the (4) PC-000105 - Bulbex Rivets
located inside the dispenser.
PS14 Guide - July 2009
Page 4 of 4
Service & Maintenance Information (Continued)
Paper Towel Dispenser
Unlock the master lock on the paper towel holder. Add one pack of single fold
towels (Georgia Pacic 23504 or equivalent) to each compartment (total of 4
packs) and feed the rst towel through the slots in the bottom of the towel
holder body.
Soap Dispensers
Open the soap dispenser by placing your hands on
both sides of the dispenser and pressing up on the tabs
of the lid. Locate the tab on the mounting plate at the
rear of the dispenser and push in on it and slide the dis-
penser up and o. Fill with 30 uid ounces of liquid
soap. Refasten it to the mounting plate and snap the
lid back on. Repeat for the other three dispensers.
IMPORTANT DECALS
NOT FOR COOKING OR DRINKING, is required by law in certain areas of the
U.S. Other geographical areas require that the materials used to manufacture
the sinks comply with the U.S. Federal Food and Drug Administration (FDA)
guidelines 21 CFR 175.300 (resins), 177.1520 (olen polymers) and 178.3297
(colorants for polymers). The materials also comply with the U.S. Public Health
Service Drinking Water Standards, 42 CFR part 72 and U.S. Environmental Pro-
tection Agency Interim Primary Drinking Water Regulations 40 CFR part 141.
HANDS FREE PUMP, instruction for user to use foot pump to operate the
sink.
UNIT MUST BE DRAINED BEFORE TRANSPORTING, reminds service opera-
tor to empty the sink before transporting.