Pond Pro CAN-AIR KOI 4 User manual

North America’s Pond Superstore
CAN-AIR KOI 4
AERATION SYSTEM
1-855-414-7663
PONDPRO.CA
CAMROSE, AB
[e-mail]
M
A
D
E
I
N
C
A
N
A
D
A

INCLUDED
IN THIS KIT
[1] Jebao PA-200 Linear Air Compressor
[4] Eco Diffusers
[4] 50' 3/8" I.D. Sinking Airline
[9] Hose Clamps
[1] 4-way Manifold
The Can-Air Koi 4 aeration system is designed
for ponds with a depth less than or equal to 7’.
TO SET UP SYSTEM
Place the diffusers in the desired location.
This can be done with a boat or by tossing
the diffusers into the pond. The diffusers
are designed to sink and self-right.
Optional: a rope can be tied to the diffusers
for easy retrival.
4
Remove the diffusers and all other components
from the box. The diffusers’ check valve and hose
barb are pointed inwards for shipping purposes.
Rotate the check valve and barb to point outwards.
1
Connect one roll of 50' sinking line to the hose barbs
on each diffuser. Use a hose clamp to secure the
barb in place. Do not overtighten clamp.
2
Install the other end of the sinking line on the hose
barbs on the compressor manifold and secure them
with hose clamps. Do not overtighten clamps.
3
Diffusers need to be placed at equal depths.
COMPRESSOR
MOUNTING
Your cabinet is now ready to mount on a post. The
cabinet must be mounted at least 4’ off the ground.
Your cabinet is equipped with ventilation holes.
Keep ventilation holes unobstructed.
Guide the sinking airline from the manifold
through the holes to outside of the cabinet.
The air pump comes equipped with anti-vibration
rubber feet that do not need to be bolted down.
Compressors must be protected from weather
and kept in a well ventilated/cool area to prevent
overheating. If you purchased a compressor
cabinet, follow the mounting instructions below.