Version1.1 APSPS1
Turn ignition OFF within 10sec, LED will start blink slowly to confirm the preset PIN
Number, please turn ignition On once LED blinks the right times of the original preset PIN
number, if correct, Siren will chirp once (if siren do not chirp, means the preset PIN
number was confirmed failure, please start over under this kind of situation);
Step 2: Input the new PIN NUMBER
Right after the siren chirp once, then please turn ignition Off, it enters into new PIN
number setting, LED starts to blink, when the blinking times turns to the PIN number you
want to set, please turn ignition onto confirm. Then turn ignition Off，LED will play the
new PIN number by blinking the right times you have chosen. System will exit PIN
NUMBER setting mode。
Exit PIN NUMBER setting：No operation or input wrong initial password within 30s,
system will exit PIN NUMBER setting mode。
VALET MODE
You can prevent your security system from automatically arming by using valet mode,
this is very useful when washing the motorcycle for example, in valet mode, the security
system will not arm, even with the transmitter, but any accessory functions will continue
to work normally.
ENTER VALET MODE:
Cycle key ON/OFF/ON within 5sec, Then press Lock button 3 times, (the siren will chirp
once even the button was pressed once)，then unit will enter valet mode. In valet mode,
press button 1, siren will chirp 3 times. LED will solid for one hour, After one hour,The
LED quickly flashes 3 times when an arm or disarm command is received.
The same way to exit valet mode.
MEMORY FUNCTION
This security system will store its current state to non-volatile memory. If power lost,
then reconnected the system will recall the stored state from memory. This means if the
unit is in valet mode and the battery is disconnected for any reason, such as servicing the
