Power Fist 8347023 User manual

1
For technical questions call: 1-800-665-8685
V 1.51 8347023
18" Laser Level
INTRODUCTION
This Laser level is a laser instrument for distant measuring of horizon, which contains a spirit level with two quality
vials, and a semiconductor laser. The main body of level is made of aluminium, and two quality vials are used as
a horizontal reference and a vertical reference. Laser level can help to find level and plumb point easily, and widely
serves for plane measuring in the field of civil engineering, and indoor decoration, so the product is very useful in
construction, industry and DIY range.
SPECIFICATIONS
• Working range: 30 to100m
• Accuracy of vials on level: 0.5 mm/m
• Accuracy of vial on base: 1mm/m
• Laser output power: < 1mw
• Visible red light = 650nm
• Laser class: II
• Degree of protection: III
• Battery operated: Two 1.5V (AAA) batteries
SAFETY INSTRUCTIONS
DO NOT STARE DIRECTLY INTO THE LASER BEAM.
IMPORTANT: Read all instructions prior to operating this tool. Do not remove any labels from tool.
CAUTION: Never attach or use any other form of optical device with this laser product.
CAUTION: Do not modify the product in any way as this may result in hazardous radiation exposure.
LASER GUIDE (GUIDE LASER)
WARNING: Laser radiation - Do not stare into the beam. Use of controls or adjustments or performance
of procedures other than those specified in this instruction manual may result in hazardous
radiation exposure.
1. Keep the laser direction towards the work piece. Do not stare directly into the laser or into a laser being
reflected off a surface.
2. Do not disassemble laser.
3. Use the laser only when the tool is in use. Turn the laser off after use.
4. It may be difficult to see the laser in bright sunshine.
Please read and understand all instructions before use.
Retain this manual for future reference.

18" Laser Level
2For technical questions call: 1-800-665-8685
8347023V 1.51
OPERATION
BUBBLE LEVELLING
1. Take laser level and rotary base out of box.
2. Firm level on rotary base, and adjust three screws on base until both bubbles are exact in the centre.
HORIZONTAL AND VERTICAL DIRECTION
Turn switch on, a horizontal laser beam is projected. When rotating the base, the laser beam will scan through 360°
in horizontal direction. If a vertical laser beam or laser line is required, insert the prism into the hole.
A compact tripod can be used, which is specially designed for laser level with rotary base. The tripod is made of
anodized aluminium, and the opened length of which is 108 cm, whereas the closed length is 40 cm.
BATTERY REPLACEMENT
The battery must be replaced when the laser beam become dim or the light spot becomes larger or smaller. Take off
the cover on the end of laser level where the switch is installed, and replace two used batteries (1.5V). Make sure
that the positive and negative terminal of the batteries are in place.
CARE AND MAINTENANCE
• Laser tools must be handled with care; avoid shock, vibrations and extreme heat
• Avoid moisture which could obstruct the lens. If needed, use a soft cloth or cotton swab and glass cleaner
to clean the lens.
CAUTION: Before cleaning the lens remove the batteries to prevent the possibility of the laser beam
contacting your eyes.
• Keep the Laser Line dry and clean
• Check batteries regularly to avoid deterioration.
• Remove batteries if the Laser Line is to be stored for an extended period of time
DISPOSING OF THE TOOL
If your tool has become damaged beyond repair, do not throw it out. Bring it to the appropriate recycling facility.
APPLICATIONS
Accurate height gauging,
alignment of ceilings,
electrical plugs,etc.
Leveling of
floors,stairs,slopes,etc
Generating a vertical reference
plane, e.g. Positioning of
partitions,etc.
Marking of drill holes, anchor
holes, for series installations,etc.