POWER ON BOARD Bright Bar WLB26 Instruction Manual

USER’S MANUAL
& WARRANTY INFORMATION
IMPORTANT SAFETY INFORMATION, SAVE THESE INSTRUCTIONS
THIS MANUAL CONTAINS IMPORTANT INFORMATION REGARDING
THE OPERATION AND WARRANTY OF THIS PRODUCT. PLEASE READ
CAREFULLY BEFORE USE AND RETAIN FOR FUTURE REFERENCE
4140 S.W. 30th Ave., Ft. Lauderdale, FL 33312
Toll Free: (800) 54-HOW-TO
unauthorized use or repair, neglect, misuse, abuse, failure to follow instructions for care
and maintenance, fire, flood and Acts of God.
If your problem is not covered by this warranty, call our Technical Support Department toll
free at (800) 54-HOW-TO for general repair information and charges if applicable.
STATE LAW RIGHTS: This warranty gives you specific legal rights. Some states do not
allow limitations on how long an implied warranty lasts or the exclusion or limitation of
incidental or consequential damages, so the exclusions or limitations stated herein may
not apply. This warranty gives the purchaser specific legal rights; other rights, which vary
from state to state, may apply.
TO REQUEST WARRANTY SERVICE FOR THIS PRODUCT: Contact Technical Support by
telephone, fax or mail (see below). We suggest that you keep the original packaging in
case you need to ship the unit. When returning a product, include your name, address,
phone number, dated sales receipt (or copy) and a description of the reason for return
and product serial number. After repairing or replacing the unit, we will make every effort
to return it to you within four weeks.
WARRANTY ACTIVATION: Please complete Warranty Activation Card and mail to Power
On Board. Enter “WLB26P” as Model and “Bright Bar™LED rechargeable Work Light”
as Product Type. All Power On Board products must be registered within 30 days of
purchase to activate this warranty. Mail the completed registration form, along with a
copy of the original sales receipt, to:
Black & Decker
4409 W. Wanda, McAllen, TX 78503
• TOLL FREE: (800) 54-HOW-TO • FAX: [phone] •
WARRANTY IS NON-TRANSFERABLE.
BD081906
Bright Bar™
LED Rechargeable Work Light
© 2006 VECTOR PRODUCTS, INC.
MADE IN CHINA
WLB26P

IMPORTANT SAFETY INSTRUCTIONS
WARNINGS
This unit contains an Ni-MH battery and should be
disposed of properly. Do not dispose of batteries in fire.
This may result in an explosion.
Do not expose the unit to fire or intense heat as the battery
may explode.
Charge or power this unit ONLY with the originally supplied
Class 2 transformer. Consult manufacturer for replacement.
Never look directly into the light or shine the light into another
person’s eyes.
CAUTIONS
• DO NOT expose this Work Light to extremely high temperatures.
• This Work Light is moisture-resistant, NOT waterproof. Do not submerge
in liquids of any kind.
Read This User’s Manual Before Using This Unit.
SAVE THESE INSTRUCTIONS

INTRODUCTION
Thank you for purchasing the Power On Board®Bright
Bar™LED Rechargeable Work Light. Please read this
manual carefully before use to ensure optimum performance
and avoid damage to the unit.
FEATURES
•26 high-intensity LED bright bar illuminates a wide area
• Corded or cordless operation
• Built-in rechargeable Ni-MH battery (with supplied 120 volt
AC Charging/Power Adapter)
• Hi/Low settings extend runtime
•High impact, weather- and shatter-resistant ABS housing
• 360° Swivel Hanging Hook for hands-free use
•Seven hours continuous runtime on LOW setting, four hours
continuous runtime on HIGH setting, on a single charge
•Rubber Base allows unit to stand on flat surfaces
OPERATING THE UNIT
Position the Work Light as desired. Press the HIGH/OFF/LOW
Switch on the side of the unit.
The up position turns the unit ON in HIGH setting.
The down position turns the unit ON in LOW setting.
The center position turns the unit OFF.
1

OPERATING THE UNIT IN CORDED MODE
Insert the 2-pin DC connector of the AC/DC Charging/
Power Adapter into the unit’s 12 Volt DC Charging
Port. Insert the plug end into a (powered) standard
North American 120 Volt 60 Hz outlet. Operate the
unit as outlined in the previous section.
RECHARGING THE BUILT-IN BATTERY
Insert the 2-pin DC connector of the AC/DC Charging/Power
Adapter into the unit’s 12 Volt DC Charging Port. Insert the plug
end into a (powered) standard North American 120 Volt 60Hz
outlet. The red Charging Indicator LED will light to indicate the
unit is charging.
Notes: Do not charge for longer than 8 hours.
Charge or power this unit ONLY with the originally
supplied Class 2 transformer. Consult manufacturer
for replacement.
Battery Disposal
This unit contains an Ni-MH battery and should
be disposed of properly. For more information on
recycling batteries, call toll-free [phone].
WARNINGS
• Do not dispose of the battery in fire. This may result
in an explosion.
• Do not expose the battery to fire or intense heat as
it may explode.
THREE YEAR LIMITED WARRANTY PROGRAM
This limited warranty program is the only one that applies to this product, and it sets forth
all the responsibilities of Power On Board regarding this product. There is no other
warranty, other than those described herein. Any implied warranty of merchantability or
fitness for a particular purpose on this product is limited in duration to the duration of this
warranty.
This Power On Board product is warranted, to the original purchaser only, to be free of
defects in materials and workmanship for three years from the date of purchase without
additional charge. The warranty does not extend to subsequent purchasers or users.
Manufacturer will not be responsible for any amount of damage in excess of the retail
purchase price of the product under any circumstances. Incidental and consequential
damages are specifically excluded from coverage under this warranty.
This product is not intended for commercial use. This warranty does not apply to damage
to units from misuse or incorrect installation/connection. Misuse includes wiring or
connecting to improper polarity power sources.
RETURN/REPAIR POLICY: Defective products may be returned to manufacturer. Any
defective product that is returned to manufacturer within 30 days of the date of purchase
will be replaced free of charge. If such a product is returned more than 30 days but less
than three years from the purchase date, manufacturer will repair the unit or, at its option,
replace it, free of charge.
If the unit is repaired, new or reconditioned replacement parts may be used, at
manufacturer’s option. A unit may be replaced with a new or reconditioned unit of the
same or comparable design. The repaired or replaced unit will then be warranted under
the terms of the remainder of the warranty period. The customer is responsible for the
shipping charges on all returned items. During the warranty period, manufacturer will be
responsible for the return shipping charges to the customer in the United States.
LIMITATIONS: This warranty does not cover accessories, such as charging adapters,
bulbs, fuses and batteries, damage or defects resulting from normal wear and tear
(including chips, scratches, abrasions, discoloration or fading due to usage or exposure
to sunlight), accidents, damage during shipping to our service facility, alterations,
2 3