Power Tec 92259 User manual

92259
www.power-tec.co.uk
Hot Stapler Plastic
Repair System
- Professional
Includes 2 pin plug
Distributed by The Tool Connection Ltd
Kineton Road, Southam, Warwickshire CV47 0DR
T [phone] F [phone]
[email protected] www.toolconnection.co.uk
Guarantee
If this product fails through faulty materials or workmanship, contact our
service department direct on: [phone]. Normal wear and tear are
excluded as are consumable items and abuse.
www.power-tec.co.uk
Caution
Always wear safety goggles when cutting staples
• Once the pin is in the stapler and the heat is applied, the staple will become extremely hot.
(100-200˚C). Do not touch without full protection
• Do not use with wet hands
• Do not soak product with water
• Do not use in wet conditions
• Turn off when unattended and make sure the tips are cold before leaving on any surface.
• Do not use for any purpose other than that it is intended for.
• Make sure all health and safety procedures are in place before commencing work.
The Tool Connection cannot be held responsible for any damage caused to property or
personnel when using this product.
92259_INSTRUCTIONS_V6.indd 1-2 14/02/2011 11:12

1 2
www.power-tec.co.uk www.power-tec.co.uk
92259
Hot Stapler Plastic Repair System
- Professional
Instructions
1. Plug in to standard 240v system. Press ON/OFF button to switch on (yellow LED).
2. Use temperature control button (red LED) to select:
L for Thin plastic (bumpers etc).
M for 5mm thick plastic (spot lights etc).
H for thick or hard plastic.
3. Choose suitable staple for repair and insert it into the tips.
4. Prepare plastic for repair by butting together.
5. Heat staple by pressing and holding the handle switch for 10 seconds.
6. Press the staple gently against the plastic to be repaired; push staple until it is about half
way through material, then twist through about 10-15°.
7. Release the heat button and hold the staple on the repair until it feels firm.
8. Slowly withdraw the tool, leaving the head of the staple in place.
9. Cut off the protruding ends of the staple.
10. Remove the remaining ends of the staple with sander.
11. Continue with repair in the normal way.
Note:
When repairing large areas, repeat the procedure at regular intervals.
Stainless Steel staples supplied (replacements available)
Staple Description Size Part No
V shaped (supplied) 8mm x 100mm 91784
V shaped (supplied) 6mm x 100mm 92260
U shaped (supplied) 6mm x 100mm 91782
U shaped 8mm x 100mm 91783
U shaped – right angle 6mm x 100mm 92261
U shaped – right angle 8mm x 100mm 92262
Power Indicator
Temp Control
Indicators (Red LED)
Temp Control Switch
Power Switch
Fuse
Output Cable
Power Plug
Power Cable
Grip
Switch Button
92259_INSTRUCTIONS_V6.indd 3-4 14/02/2011 11:12