Powermate PE0601300 User manual

PE0601300
Electric Generator
Insert
www.powermate.com 01/09 0066909
Thank you for selecting a Powermate® Generator. The
Powermate® generator has been made to supply reliable,
portable electrical power when utility power is not
available. We hope you will enjoy your new generator.
Welcome to our worldwide family of Powermate®
generator users.
IMPORTANT – Please make certain that persons who
are to use this equipment thoroughly read and
understand these instructions and any additional
instructions provided prior to operation.
Pramac America, LLC
4970 Airport Road
P. O. Box 6001
Kearney, NE 68848
1-800-445-1805
www.powermate.com
© 2009 Pramac America, LLC. All rights reserved.
Powermate ® is a registered trademark of Pramac America, LLC.

* 25 HP Subaru OHV engine
* Cast-iron cylinder sleeve
* Low oil sensor
* Receptacles on control panel
* Electric Start
* 8 gallon plastic fuel tank
RECEPTACLES
D. Circuit Protectors
The receptacles are protected by an
AC circuit protector. If the generator is
overloaded or an external short circuit
occurs, the circuit protector will trip. If this
occurs, disconnect all electrical loads and
try to determine the cause of the problem
before attempting to use the generator
again. If overloading causes the circuit
protector to trip, reduce the load.
NOTE: Continuous tripping of the
circuit protector may cause damage to
generator or equipment. The circuit
protector may be reset by pushing the
button of the protector or pulling the toggle
handle up to the “ON” position.
2English
CONTROL PANEL
MAJOR GENERATOR FEATURES
TYPE CONFIGURATION DESCRIPTION
A
SCHUKO 10/16A 250VAC IP54 WITH PROTECTED
RECEPTACLES
SINGLE PHASE 230V
B
2P + T 32A 230VAC IP44
SINGLE PHASE 230V (1/3 OF DESIGN LOAD)
C
3P + N + T 32A 230/400VAC IP44
THREE PHASE 400V (FULL DESIGN LOAD)

The generator is equipped with electric start. An “Off-On-
Start” rotary key switch is provided on the recoil end panel. All
necessary wiring is provided. The battery is provided. See
engine manual for wiring diagram (3A Charge Coil), and
additional information.
Note that the battery must be connected in order for this
engine to run. The 12V fuel solenoid must be engaged in order
for fuel to reach the carburetor. This fuel solenoid also helps
prevent engine backfire. This engine is not equipped with recoil
start.
The charging system of the unit is supplied by the
starter/alternator of the engine. 12 volts DC is constantly
charging the battery when the unit is running . Disconnecting
the battery will stop the charging of the battery.
Before charging a storage battery, check the electrolyte
fluid level in all the cells. (Sealed batteries do not require
checking). Add distilled water to each cell if necessary, to bring
the level back up to the manufacturer’s required level.
WARNING: Storage batteries give off
EXPLOSIVE hydrogen gas while charging. Do
not allow smoking, open flames, sparks, or
spark producing equipment in the area while
charging.
WARNING: Battery electrolyte fluid is
comprised of sulfuric acid that can be very
dangerous and cause severe burns. Do not
allow this fluid to contact eyes, skin, clothing,
etc. If contact or spillage does occur, flush
the area with water immediately.
CAUTION: This battery charging system is
intended to recharge weak batteries, not to
"boost start" vehicles. Do not overcharge
battery or leave battery unattended.
CAUTION: Do not continue to charge a
battery that becomes hot or is fully charged.
We recommend a 12 V battery with at least 235 cranking
amps, Model U1L, Lawn and Garden Battery.
1. Place the battery in the position provided.
2. Place the bolts through the holes on the battery pan.
3. Place the bolts through the loops on the Hold-Down bracket.
4. Place the spacers and washers on the bolts.
5. Tighten down the Hold-Down assembly with the 1/4-20 nuts
provided.
Note: Spacers may be removed depending on the battery
height.
WARNING: Batteries contain sulfuric
acid (when filled). May contain explosive
gasses. Always abide by safety warnings
provided with the battery.
- Keep sparks, flame and cigarettes away.
- Hydrogen gas is generated during
charging and discharging.
- Always shield eyes, protect skin and
clothing when working near batteries.
Connect the red 8 ga. battery lead to the positive (+)
battery post and the black 8 ga. battery lead to the negative (-)
battery post with the bolts and nuts provided.
Item Description Qty.
A. *Bolt, 1/4-20 X 8” 2
B. *Washer 1/4 2
C. *Spacer 2
D. Hold Down bar (P/N 0036525.02) 1
E. *Wing nut, 1/4-20 2
* These are standard parts available at your local hardware
store.
3
English
DC FEATURES
BATTERY INSTALLATION
ELECTRIC START WIRING
BATTERY KIT PARTS LIST

4English
The Manufacturing Company warrants the products put on the market with the brands of its own property and/or
subsidiary companies', in compliance with terms and conditions provided for by the law in force. In particular, the
warranty has a 12-month validity as from the date of the product purchase by the user-customer, and such date is
that specified on the purchase tax record.
In order to be entitled to the warranty the end user shall notify the dealer of the possible defect within the terms
provided for by the law by exhibiting the official documentation proving the date of the product purchase, in particular
the purchase invoice, the receipted bill for tax purposes or any other tax record showing the purchase occurred,
where the serial number of the product is indicated. In the event that the defect is notified over the terms fixed or the
above-mentioned documentation is lacking, no warranty will be allowed.
The warranty is intended to be only limited to the replacement of those parts (and to the costs strictly related to
it), which show a manufacturing defect or wrong assembly, according to the final judgement of the technical
management or the person entitled by it. Each and any other liability and/or obligation to other expenses, direct
and/or indirect damage and losses arising from the use and/or total and/or partial impossibility of using the product
are excluded.
The warranty of the spare parts used for repairing during the warranty period is anyway restricted to the terms
provided for by the law and in no way it may be renewed. However, such warranty may be used only and exclusively
when the authorized personnel carry out the replacement of parts and this is subordinate to the use of original spare
parts.
Repairing carried out during the warranty period is intended to occur ex-head office of the dealer who executed
the sale or ex-authorised service centre that is nearest to the customer office. Therefore, any expense relating to
transports and/or packaging concerning repairing itself is charged to the buyer.
The product shall be actually exhibited at the place where the warranty may be obtained without any change and
without other devices and/or accessories assembled except those existing upon the sale itself. The warranty may be
obtained only and exclusively exhibiting the request for it in any one of the items indicated in the enclosed list.
The warranty automatically lapses as soon as the terms provided for by the law have expired or when just one of
the following cases occurs:
A) User-customer's non- or wrong maintenance or third parties'.
B) User-customer's breaking of the seals affixed and/or change of the programming parameters or third
parties'.
C) User-customer's employment of inadequate fuels and/or lubricants or third parties'.
D) User-customer's inability to use the product or third parties'.
E) Use of the product for professional purposes when not provided for.
F) Repairing carried out by non-authorized personnel.
G) User-customer's employment of non-original spare parts or third parties'.
H) Impacts, fires, flooding and/or other accidental events even if of geological or atmospheric nature.
In addition, the warranty may not be applied to the breakdowns arising from standard wear.
The warranty relating to the components that are not produced by the Manufacturing Company is allowed within
the limits given by the manufacturers of such components.
The current warranty invalidates and replaces any other express or implied warranty, and it will not be able to be
changed except in writing by the Manufacturing Company exclusively.
Thursday, 05 September 2002
GENERAL TERMS OF WARRANTY

5
PARTS DRAWING
English

REF. PART DESCRIPTION QTY
NO. NO.
1 0066901 Carrier, assembly, full 1
2 0066904 Panel, wired complete 1
3 Note C Fuel tank Assembly 1
4 Note A Engine, 25hp Subaru 1
5 0057254 Nut, hex flg 5/16-18 10
6 0056231 Cap Fuel w/Gauge 6” 1
7 0064607 Assy, deflector 1
8 0056427 Assy, Stator bracket 1
9 0055620 Washer, flat .42 x 1.5 2
10 0062503 Muffler 1
11 0064597 Manifold, Exhaust 1
12 0062498 Muffler Clamp 1
13 0050941.01 Muffler Bracket 1
14 0052931 Clamp, Vinyl J 1/2” 1
15 0006253 Assy Wire Blk 8ga 17.25 1
16 0006254 Assy Wire Red 8ga 17.25 1
17 1130564770 Oil Drain Hose 6”
18 Note B Clamp hose worm SAE6 1
19 0057747 Fitting 3/8NPT x 1/2 barb 1
20 0057746 Valve ball 3/8NPT M/F 1
21 0062499 Fitting 3/8NPTF 14mm-M 1
22 0058618 Screw, #10 x 1 4
23 0049224 Assembly, ground wire 1
24 0053320 Screw HWH #10-14 x .63 4
25 0047864 Screw HSW #10-32 x .5 1
26 Note B Bolt HH 5/16-18 x 1.5 8
27 0048736 Nut Nyloc 5/16-18 4
28 0000919.01 Bolt whz 3/8-16 X 3/4 1
29 Note B Washer, flat 5/16 1
30 Note B Bolt HH 5/16-18 x 1 3
31 Note B Washer, lock 5/16 7
32 0051094 Isolator 7
33 Note B Washer, star ext 5/16 3
34 0066956 Rotor, assembly 1
35 0066957 Brush gear assembly 1
36 0065113 Bolt, rotor 1
37 0066958 Frame & Stator, 50 Hz 1
38 0065114 Louvered Side Panel 2
39 0066959 Transformer 1
40 0062585 Generator Head cover 1
41 0056623 Adapter, engine 1
42 0064729 Fuel valve with filter 1
42A 0062673 Fuel bushing 1
43 0049070 Circuit Breaker 15A 2
44 0066906 Assy, Circuit Breaker 4P 20A 1
45 0062540 Shield, heat 1
46 0057183 Grommet 7/8 ID 1
47 0049291 Strain Relief 1
48 Note B Bolt HH 5/16-18 x 1.25 1
49 0049352 Washer, flat 5/16 W 3
51 0061393 Nut, whz 8mm 4
52 0056813 Bolt HH M8 x 18mm 2
53 0049279 Bolt whz 5/16-18 X .50 2
54 0056680 Filler Flootool Funnel 1
55 0057512 Bolt whz 3/8-16 X 1.25 4
56 0066902 Spring, governor 1
57 0066916 Bracket, circuit breaker 1
76 0063133 Varistor 1
PARTS LIST
English
6

ELECTRICAL SCHEMATIC DRAWING - PE0601300
CARBURETOR FUEL SOLENOID
Note A: Pramac America, LLC will not provide engines as replacement parts. Engines are covered through the engine manufacturer's warranty. Consult the accompanying
engine manual or contact our service department for assistance.
Note B: These are standard parts available at your local hardware store.
Note C: Contact your nearest Powermate ® Service Center for replacement fuel tanks.
WARNING: To avoid possible personal injury or equipment damage, a registered electrician or an authorized service representative should
perform installation and all service. Under no circumstances should an unqualified person attempt to wire into a utility circuit.
7
English