PowerPoint P2152CH Service manual

Cod:0103091364-00.01
P2152CH
Extractors
Installation, use and maintenance

1

Information and Advice
CAUTION:Accessible parts may become hot when used with cooking appliances.
In certain circumstances electrical appliance may be a danger hazard.
A) There must be adequate ventilation of the room when the cooker hood is used at the same time
as appliances burning gas or other fuels.
B)Do not check the status of the filters while the cooker hood is operating.
C)Do not touch the light bulb within half an hour after appliance has been use.
D)Do not light a flame under the cooker hood.
E)Avoid opening gasometer when there is no pan on the stove, as it is damaging for the filters and
a fire hazard.
F)Constantly check food frying to avoid overheated oil splashing and becoming a fire hazard.
G) Disconnect the electrical plug prior to any maintenance.
H) Regulations concerning the discharge of air have to be fulfilled.
I) When the range hood and appliances supplied with energy Other than electricity are simultan
ously in operation.The negative pressure in the room must not exceed 4 Pa (4x10-5 bar).
J)If the supply cord is damaged,it must be replaced by the manufacturer, its service agent or
similarly qualified persons in order to avoid a hazard.
K)This appliance can be used by children aged from 8 years and above and persons with reduced
physical, sensory or mental capabilities or lack of experience and knowledge if they have been
given supervision or instruction concerning use of the appliance in a safe way and understand the
hazards involved. Children shall not play with the appliance. Cleaning and user maintenance shall
not be made by children unless they are older than 8 and supervised.
L)the range hood is inteded to be installed over a hob having no more than four hob elements.
M) Indoor use and household use only.
N)When the appliance is not in use and before cleaning, unplug the appliance from the outlet.
O) Attention ! Observe the warning in the instruction sheet concerning the operation of the
appliance when air is discharged from the room.
P) There is a fire risk if cleaning is not carried out in accordance with the instructions.
Q) The air must not be discharged into a flue that is used for exhausting fumes from appliances
burning gas or other fuels (not applicable to appliances that only discharge the air back into the
room.
I)Children should be supervised to ensure that they do not play with the appliance.
S)Warning: Failure to install the screws or fixing device in accordance with these instructions may
result in electrical hazards.
T)The installation height of hood shall not be less than 65cm.
U)The filter screen must be cleaned regularly, otherwise there is a danger of fire.
V)The installation must be carried out according to the screws and positions required by the
instructions, which will easily damage the connecting wires.
W)If the supply cord is damaged, it must be replaced by the manufacturer, its service agent or
similarly qualified persons in order to avoid a hazard.
2

3
Using your Extractor
For best performance, you should switch on the extractor 15 minutes
before starting to cook and leave it to run for approximately 15 minutes
after the end of cooking.
Control Panel
B - Speed level buttons
C - Light button
• Press button “C”.
To switch on the extractor or to change the speed at any time when
the extractor is running
• Press the relevant “B” button for the first, second or third speed level
as required.
• Press the “A” button.
Fig. 1 A B C

Fig. 2
Care and Maintenance
IMPORTANT：DO NOT PERFORM MAINTENANCE OR CLEANING
OF THE EXTRACTOR WITHOUT FIRST SWITCHING OFF THE
ELECTRICITY SUPPLY.
Cleaning
You should use a non-abrasive cleaner. Any abrasive cleaner
(including Cif) will scratch the surface and could erase the control panel
markings.
of water and mild detergent and drying to a shine with a clean cloth.
Cleaning the grease filter
The grease filter should be kept clean to minimize the risk of fire.
At least once a month the grease filters should be removed and
cleaned with warm soapy water. You can also wash the grease filters
in a dishwasher, ensuring that the filters are put in an upright position
to prevent damage from other items in the dishwasher. After rinsing and
drying, replace the filter.
To remove the grease filter, push in the button on the handle and then
pull down on the filter at the front. When you have released it at the
front, then you can pull out the filter. To replace the grease filter, repeat
the steps in reverse.
Please note:
Cleaning the grease filter in the dishwasher
may lead to discolouration.
This is normal and does not constitute a fault
with the appliance.
Please note:
The extractor must not be used without the grease filter in place.
4

Charcoal filter
In re-circulating mode, air is vented back into the kitchen through the
opening in the cooker hood.
This method is advised if you are not using your hob intensively.
Re-circulated air requires the use of charcoal filters to remove odours.
To ensure the best performance from your cooker hood, the charcoal
filter should be replaced every 3-6 months, dependent on use.
Note: This charcoal filter is non-washable and must be replaced as
required.
To attach a new charcoal filrer, follow the steps below:
1.Remove the grease filter (fig.3-I).
2. Place the charcoal filter on the centre of the motor support. Once firmly
located, turn the charcoal filter clockwise 90 degrees until the filter locks
into position(fig.3-II).
3.Replace the grease filter(fig.3-III)
To order replacement charcoal filters please scan the QR code on the
rating plate located behind the grease filter inside the hood.
Fig. 3-I Fig. 3-III
Fig. 3-II
The LED lights
Replaceable (LED only) light
source by a professional
LED LED
In case of malfunction of the illumination system contact the
technical service.
5

Electrical Information
Mains electrical voltage: 230 – 240Vac
Total rated power consumption:
44W
Troubleshooting
Please note:
Your extractor is equipped with a motor protection device that will
happen during cooking when most or all of the zones/burners are
being used simultaneously, or if your extractor is installed incorrectly,
lower than the recommended height.
This is normal, and the extractor will work again once the motor has
If your extractor is not working:
2. Check that the fuse in the spur has not blown.
6
FUSE 5A
PROTECTION LINE
5A Fuse is installed inside the plug to protection line.

GUARANTEE
comes with a 1 Year Warranty. An additional 1 year extended warranty is available by registering your product here
www.powerpointaplliances.ie
7

If the instructions provided with your gas hob state that the required
distance between the hob and the extractor must be greater than
650mm, then that is the distance which should be observed. This is
a legal requirement and may lead to your hob being disconnected
from the gas supply and the installation reported to RIDDOR (the
height should be measured from the top of the burners).
The width of any hob must not be greater than the width of the extractor
installed above it.
4.giF
Installation
IN THE ABSENCE OF ANY INSTRUCTIONS SUPPLIED WITH THE
GAS HOB, THE MINIMUM DISTANCE BETWEEN THE HOB AND
EXTRACTOR MUST BE AT LEAST 650mm.
When the extractor is to be installed above an electric hob, the
NB. This hood is supplied with a charcoal filter as standard.
If you are ducting the air outside please ensure this filter is removed
before use.
minimum distance between the hob and extractor must exceed 600mm
for ceramic and solid plate hobs and 550mm for induction Hobs.
When the extractor is to be installed above a gas hob, the minimum
distance between the hob and extractor must exceed 650mm.
Gas: 650mm recommended.
Electric: 600/550mm recommended.
8

INSTALLATION
Extractor dimensions.
Mark out the dimensions of the cut-out based on your extractor.
5.giF
I
J
EF
G
H
D
C
B
A
A
C
D
B
6.giF
A
B
C
D
499
268
200
487
A
B
C
D
E
F
G
H
I
J
518
499
515
480
260
274
200
290
173
10
9

Remove the grease filter, unscrew
NB. Ducting Kit - For best results Please use 120mm ducting. A reducer maybe
required for smaller diameter ducting.
the 4 screws of the fixed panel and
remove it.
Place the extractor into the cabinet
opening and secure it with screws.
Secure the panel on with the 4
previously removed screws (Fig 7)
and insert the grease filter.
Connect the exhaust pipe to the
ducting adaptor and locate on the
extractor as indicated.
INSTALLATION
7.giF 8.giF
9.giF 10.giF
10

This product was supplied by Shomar Ltd Dublin Ireland.
To contact us for after-sales service or spare parts please visit our website
www.powerpointapplainces.
ie or scan the QR code below.