PowerPoint P21561XBSS Specification sheet

Cod:0103087104-00.03
P21561XBSS
Extractors
Installation, use and maintenance

Fig. 2-I
Fig. 2-II
Fig. 2-III
Charcoal filter installation
Care and Maintenance
IMPORTANT: DO NOT ATTEMPT TO MAINTAIN OR CLEAN THE
EXTRACTOR WITHOUT FIRST SWITCHING OFF THE ELECTRICITY
SUPPLY.
In re-circulating mode, air is vented back into the kitchen through the
opening in the cooker hood.
This method is advised if you are not using your hob intensively.
Re-circulated air requires the use of charcoal filters to remove odours.
To ensure the best performance from your cooker hood, the charcoal
filter should be replaced every 3-6 months, dependent on use.
Check with your local retailer or dealer for information on how to obtain
replacement charcoal filters.
Note: This charcoal filter is non-washable and must be replaced as
required. To install a new charcoal filter, first remove the grease filter,
as shown in Fig.2-I. Then install the charcoal filter as shown in Fig.2-II
and replace the grease filter (Fig.2-III).
5

1X1.5W LED MAX
P21561XBSS
6

FUSE 3A
PROTECTION LINE
3A Fuse is installed inside the plug to protection line.
26.5W
230-240V ac, 50Hz
7

8

A
B
C*
D
E
F
P21561XBSS
9
60.5
120.5
175
75
80
Height dependent

IMPORTANT SAFETY WARNING: ONLY USE THE SCREWS PROVIDED WITH THE EXTRACTOR TO MOUNT
THE DUCTING ADAPTOR. THE USE OF LONGER SCREWS MAY CAUSE DAMAGE TO THE INTERNAL WIRING
WHICH WILL NOT BE COVERED BY THE WARRANTY.
10mm
Fig. 5 Fig. 6
Fig. 7 Fig. 8
Fig. 9 Fig. 10
Tools required Mark wall as required (see Fig.3)
Drill 4 holes for mounting the body Fit wall fixings and top screws - Ensure that any fixings you use
are appropriate for the wall type.
8
Mount chimney brackets.
INSTALLATION
10

The metal casing of this appliance has been coated with a preservative to protect it during transport and storage.
This should be removed during installation by using a non-abrasive stainless steel cleaner. Always follow the
instructions given with the cleaner being used.
Fig. 13 Fig. 14
Adjust and secure the chimneyAdjust and secure the chimney
11
Fig. 12Fig. 11
Fix ducting (seal joint) Mount the chimney
t an
t an

Attribute Symbol Value Units
Model Identification
Annual Energy Consumption AECHood kWh
Time Increase factor f
FDEHood
EEIHood
Measured Airflow at Best QBEP m3/h
Measured Pressure at Best PBEP Pa
Maximum Airflow QMAX m3/h
Measured Electric Power at Best WBEP W
Nominal Lighting Power WL W
Average Illumination of the
lighting system on the cooking
surface
EMiddle Lux
Measured Power Consumption
in standby
PSW
Measured Power Consumption POW
Noise level LWA dBA
GFEHood %
LEHood
P21561XBSS
%
12
PowerPoint
15.1
1.7
8.7
52.8
181.9
39
285.1
22.6
1.5
74
--
0.0
52
57.8 (E)
49 (A)

12