
OPERATIONS
1. ON/OFF: Press and hold the button for 3 seconds. If users can't turn on,
please replace the batteries.
2. LED brightness adjustment: Press the button and adjust the LED
illumination level until the maximum value is reached. When the button is
pressed again, the LED light is off.
3. ZOOM/ROTATE: Short press the button to enlarge the image.
Press once: Picture is magnified 1.5 times.
Press 2X: Picture is magnified 2 times.
Press 3X: Picture is displayed in its original position.
Press and hold the button to flip the image. The figure to the right
demonstrates how the image is adjusted for each button press.
FCC INFORMATION
Note: This equipment has been tested and found to comply with the limits for a
Class B digital device, pursuant to part 15 of the FCC Rules. These limits are
designed to provide reasonable protection against harmful interference in a
residential installation. This equipment generates, uses and
can radiate radio frequency energy and, if not installed and used in accordance
with the instructions, may cause harmful interference to radio communications.
However, there is no guarantee that interference will not occur in a particular
installation. If this equipment does cause harmful interference to radio or
television reception, which can be determined by turning the equipment off and
on, the user is encouraged to try to correct the interference by one or more of
the following measures:
—Reorient or relocate the receiving antenna.
—Increase the separation between the equipment and receiver.
—Connect the equipment into an outlet on a circuit different from that to which
the receiver is connected.
—Consult the dealer or an experienced radio/TV technician for help.
Changes or modifications not expressly approved by the party responsible for
compliance could void the user's authority to operate the equipment.
This device complies with Part 15 of the FCC Rules.
Operation is subject to the following two conditions:
(1) this device may not cause harmful interference, and (2) this device must
accept any interference received, including interference that may cause
undesired operation.
EU Environmental Protection
Waste electrical products should not be
disposed of with household waste. Please
recycle where facilities exist. Check with
your local authority or retailer for recycling
advice.
Warning: Permanent damage to the flex tube and loss of operation will occur
if the flex tube is subjected to narrow radius or sharp angle bends.
Batteries Installing:
1. Open the battery compartment cover.
2. Insert four new batteries into the battery compartment. Make sure the polarity of
the batteries is correct in the process.
3. Close the battery compartment cover again so that it locks into place.
SPECIFICATIONS
Model No.
Screen Size
Power Supply
Imaging Sensor
Effective Pixels
Field of view
Diameter of camera head
Waterproof capacity
Cable length
Dimensions of handle
Operating temperature
Operating humidity
Approx. weight
※All specifications are subject to minor change without prior notice.
Parameter
2.4" TFT LCD
AA x 4 batteries(1.5V x 4)
1/9-inch CMOS
640 x 480
52±5°
5.2mm
IP67(for lens/tube only)
990mm
198 x 75 x 42(mm) (Excluding Flexible Tube)
-10°C~50°C/14°F~122°F
15~85%RH
254g±5g(Including batteries)
ROTATE
ROTATE
ROTATE
ROTATE