Prima Klima BLUELINE PK355/400-EC User manual

P IP .
Instructions
English
PK355/400-EC BLUELINE
primaklima
Article Code
m 3
/h
Hz
Power(W)
Volts
Max. temp.
Weight
PK355/400-EC
4400
50/60
500
230
50 ° C
18,50 Kg
Features:
- PREMIUM ebm-papst EC motor
- Low noise emissions
- Non-stop operation, over 80.000 hours
- Galvanized steel housing
- Controllable with 0-10V signal
- Junction box with Schuko power cable
Safety Information
This machinery must not be put in operation until prior to reading mounting instructions and safety information. All fans are intended for
transportation of air in air handling systems. If installed in non-heated rooms, the fan casing has to be insulated in order to avoid
condensation. They are meant to be used after building them into machines or duct systems or after contact protection grid have been
installed. (EN ISO 13857). Fans with duct connections must be connected to ducts on both sides (inlet/outlet). When there is a risk of
water entering the motor, via the ducts, external protection is required. No moving parts shall be accessible after installation. The fans
are not to be used in hazardous environments or connected to flue ducts. The fans must not be installed outdoors, (with exception of
roof fans and fans with, for this purpose, corresponding IP class), lithe fans are installed without insulation in non-heated areas there is a
risk of condensation. Safety accessories (i.e. motor protection, safety grille) may not be dismounted, short cut or disconnected.
CAUTION! Before service or maintenance, switch off power, (all-pole circuit breaker), and make sure the impeller has come a standstill.
CAUTION! The fans can have sharp edges and corners which may cause injuries. CAUTION! Be careful when opening the fans service-
hatches (swing-out), the fan and motor assembled on the hatch is relatively heavy.
This appliance may be used by children under 8 years of age and older and persons with reduced physical, sensory or mental abilities or
lack of experience and knowledge when supervised or instructed to use the appliance in a safe way and understand the potential
hazards. Children should not play with the appliance. Cleaning and maintenance performed by the user must not be carried out by
children without supervision.
Transportation and Storage
All fans are packaged at the factory to withstand normal transport handling. When handling the goods use suitable lifting equipment in
order to avoid damage to fans and personnel. Do not lift the fans by the connecting cable, connection box, impeller or inlet cone. Avoid
blows and shock loads. Store the fans in a dry place protected from weather and dirt until final installation.
Operation
Before initial operation, check the following:
- Electrical connection has been properly completed.
- Protective conductor has been connected.
- Motor protection installed.
- Safety devices in place (protection grid)
Leftover installation materials and foreign materials have been removed from the casing.
When putting into operation, check the following:
- Connection data corresponds to the specifications on the nameplate: Maximum voltage +6%, -10%, according to IEC38.
Rated current must not be exceeded with more than S% at rated voltage. CAUTION! When the speed is regulating by reducing the
voltage the motor current may exceed the rated current at a lower voltage. In this case the motor windings are protected by the thermal
contact. The minimum static fall of pressure must be observed.
- The direction of rotation should correspond to direction-of rotation arrow.
- Smoothness of motor operation (no abnormal noises).
- Fans must only be operated by a person that has sustainable knowledge or education within this field or handling must be carried out
with the supervision of such person.
Maintenance, Service and Repair
Before maintenance, service or repairs make sure that:
- Power supply is interrupted (all-pole circuit breaker).
- Fan impeller has come to a complete standstill
- Observe personnel safety regulations!
The fan should be cleaned, when necessary, at least once per year to avoid imbalance and unnecessary damage to the bearings. A filter
will prolong the time interval between each cleaning of the fan. (It is sometimes recommended to install a filter guard). The fan bearings
are maintenance free and should only be replaced if damaged. Do not use a high-pressure cleaner (steam jet) when cleaning the fan.
Make sure the fan impeller's balance weights are not moved or the fan impeller distorted. Listen for abnormal operating noise.

0-8Y
004
ON
flu 4
%NH
RD
GNYE
GNYE
eu -
BK .
WI 14
IM12
Ld
*040 0 1
R98
reat 1 47 8IF
*RSA
T
Oid
ce)
GNYE- grüntgeb,
green-yaw GD- geb, gad
BU -Mau, bkae BN - traun, tram
BK- sdnrarz, black RD - rat, red
INH - neiß,
Declaration of Conformity
C E
Manufacturer: PRIMA
KLIMA
TRADING CZ, s.r.o., Zämosti 594, 33828 Radnice, Czech Republic
Hereby confirms that the fans listed in this document comply with the requirements of the following guidelines:
Machinery Directive 2006/42/EC Annex II B; Low Voltage Directive 2006/95/EC; EMC Directive 2004/108/EC
The following guidelines are consistent with:
EN 60204-1: 2006; EN 15012100: 20110 Safety of Machinery; General Principles for Design
EN 13857 Safety of Machinery; Safety distances in the danger zone of the upper and lower limb
EN60.335-1 Electrical equipment for domestic use and similar purposes; Part 1 General Requirements
EN 60529 Protection class of housing IP CODE
EN61000-6-2 Electromagnetic compatibility of EMC
Connection Scheme:
PK355/400-EC ebm-papst motor data sheet:
Messwerte
Venda U
V
I- 230
2 1- 230
3 1- 230
4 1- 230
5 1- 230
6
1- 230
7
1- 230
8 I- 230
9
230
10
1- 230
11 1- 230
12
1-
230
13 1-
230
14
1-
230
16
1-
230
16
1-
230
P. 1 I
10. bur. q. P .1
W
A
d1394 d(A) se%
Pa arm it sg
500 2,20 73 80 5770 0 3395 0.00
500 220 66 73 4425 200 2605 0.80
500 220 60 67 3205 350 1885 1.41
500 220 64 73 1900 500 1120 2,01
277 121 67 75 4680 0 2755 0.00
386
1,68 64 71 4010 166 2360
0,67
427 1,86
58 66 2990 309
1760 1,24
369 1,61 61
69 1690 397
995 1,59
153 0,67 83 70 3845 0 2260 0,00
214 0,93 59 66 3295 112 1910 0,45
237 1,03 53 61 2460 209 1445 0,84
204 0,89 56 64 1390 259 820 1,08
74 0,32 56 64 3005 0 1770 0,00
102 0,45 52 59 2500 69 1515 0,28
113 0,49 47
55 1925 129
1130 0,51
98
0.43 50 58
1085 161 640 0,66
.. 4 75
Hz mairr 1
50
1725
50
1545
50 1500
50 1570
50 1400
50 1400
50 1400
50 1400
50
1150
50 1150
50 1150
50 1150
50 900
50
900
50
900
50 900
= frepalv n • Orchorld
Leapsawne I = 9.eme.dnohre M. = Schakluclapee
Lont., Schabbemcgd
augereeip
Valmorahan p, • Onotlanollung
Errors and changes excepted.
The company PRIMA
KLIMA
TRADING CZ, s.r.o. assumes no liability for the content.
©2021 PRIMA
KLIMA
TRADING CZ, s.r.o., All rights reserved.
primaklima
PRIMA KLIMA
TRADING CZ, s.r.o., Zämosti 594, 33828 Radnice, Czech Republic, Email: [email protected],
Tel.: [phone]
www.orimaklima.com