Pro-Ject Audio Systems VTA it User manual

Setup Guide
How to install VTA it
To install “VTA it“ you need to unscrew the tonearm-base and
the RCA-box of your turntable.
These steps require following tools:
- Philips #1 Screwdriver
- 5.5mm Nut Driver Wrench
Difficulty Expert
Time 30 min
Steps 16
Install at your own risk!
The installation of “VTA it“ should be done by an experienced
technician. Unauthorized installations void the warranty.
Find a dealer:
www.project-audio.com/en/nd-a-dealer/
Required tools:
N
e
e
d
H
e
l
p
?
A
s
k
y
o
u
r
D
e
a
l
e
r
!

1 2 3 4
5 6 7 8
910 11 12
13
Remove the counterweight and anti-skating weight from the
tonearm. Secure the tonearm using the supplied red wire.
Remove the main platter. Bring the turntable in an upright position to have access to
both the upper- and underside.
Underside: remove upper screw while holding the tonearm
from the other side.
Loosen the lower screw just a little to be able to
rotate the RCA box.
Carefully rotate the RCA box... ... until the 5.5mm nut is accessible. Using the PH1 and 5.5mm nut wrench, loosen the tonearm
(base) by 3mm.
Loosen the upper nut by 3mm. Check if the gap is sucient. Slide in the VTA spacer from behind until the spacer
is ush with the arm base.
Tighten both nuts. Please make sure to hold the
antiskating support with your nger while doing so.
14 16
Rotate the RCA box back to the initial position. Tighten both screws. Remove the red securing wire and re-install
counterweight and anti-skating weight.
Reseat main platter.
15