PROAIM BMP-40R User manual

1
What’s In The Box
Please inspect the contents of your shipped package to ensure you have received everything that
is listed below.
Blimp Mic Windshield (BMP-40R)
All rights reserved.
No part of this document may be reproduced, stored in a retrieval system, or transmied by any form or by any means,
electronic, mechanical, photo-copying, recording, or otherwise, except as may be expressly permied by the applicable copyright
statutes or in wring by the Publisher.
Assembly Manua l
40cm Blimp Windshield with Microphone
Suspension and Handle Mic Holders Bonus 6 pc. Boom
Pole Adapter Set
Accessories
40cm Synthec Fur Cover

2
 Open the locking clip on the blimp cage from
both sides as shown in the image.
 Take the mic holder rod out of the cage.
NOTE: The rubber and holder clamps come
aached to the rod. But if any rubber or clamp
is not in a good condion, you can replace it as
shown in the images.
Blimp Mic Windshield Setup
 Insert mic into the suspension system and
connect it with a connector cables.
 Remove the cap on the blimp cage as shown
in the picture.
 Then, slide on the blimp cage to aach it back
to the handle.

3
 Adjust the wire on the blimp cage with the
handle.
 Now close the cap on the blimp cage, and ad-
just the wire of the blimp cage with the han-
dle again.
 Securely connect the XLR connectors on the
coiled audio cable to the XLR connectors on
the blimp cage.
NOTE: Boom pole height can be increased/
decreased with the help of a boom pole adapter
 Tighten the 3/8"-16 screw on the boom pole
together with the thread on the blimp cage
handle.
 Put the given spring on the screw and insert
the screw into the thread of the boom pole
cage.
 To increase the height of the boom pole, loos-
en and remove the ratchet knob on the han-
dle of the blimp cage. Then aach the adapt-
er set to the handle. Finally, insert the screw
inside the thread of the adapter set.

4
 Correctly insert the adapter set and secure it
with the ratchet knob on the other side of the
blimp cage.
 Aer assembling the blimp pole, you can also
use it with a Synthec fur cover to further
minimize the noise.
 Aach the smaller size adapter with the blimp
cage to reduce the height of the boom pole.
 Blimp cage properly secure with adapter set
as shown in the picture.
Note: Synthec fur cover reduces wind noise
when recording in adverse environmental con-
dions

5
YOUR PROAIM BMP40 R BLIMP MIC WINDSHIELD
ALL DRESSED UP AND READY TO GO!
(SHOWN WITH OPTIONAL ACCESSORIES)
Warranty: We oer one year warranty for our products from date of purchase. Within this period of
me, we will repair it without charge for labor or parts. Warranty doesn’t cover transportaon costs nor
does it cover a product subjected to misuse or accidental damage. Warranty repairs are subjected to
inspecon and evaluaon by us.
Liability: We are not liable for damage caused by products that we do not supply or from mishandling in
transit, accident, misuse, neglect, lack of care of the product, or service by anyone other than our
company.
Contact Us: In case of any kind of dissasfacon, please Contact us immediately and we promise our
utmost support and care unl you use our product.