
2
Aach handle, set it as per required angle
and ghten it with knob. Then open the
semi-sphere end cap by slightly rotang it.
Open locking clips at both ends of the blimp
cage. Slide-out the cage to detach it from
mic holder rod.
Insert three kinds of Holder Clamps in the
inseron slots to use dierent mics with
dierent diameters.
Blimp Setup
Aer inserng, close the Blimp Windshield
back with end cap.
And you can also use Fur Cover, as shown,
to further minimize the noise.
Insert Mic into the suspension system and
connect it with connector cable. Slide-in
the blimp cage to aach it back to handle.