4
Note:
Only one 4-pole cable is
required to connect 2-channel
configurations of several MT10
and SW18 / SW28 subwoofers.
Only one 4-pole cable is required
to connect two e.g. monitor paths
elegantly without additional
reversible cables.
Description:
The MT10 is a universal 2-way multi-purpose loudspeaker with a
built-in passive frequency crossover. It is equipped with one 10“
cone chassis with a water-repellent coating and one 1“ high-
frequency driver. The directivity characteristic is 90° x 60° (h x v).
The horn may be rotated by 90°.
This loudspeaker is to be used exclusively with the
ProAudio Technology system amplifiers.
Different setups enable a practice-oriented usage with or without
SW18 / SW28 subwoofers.
Alternatively Hoellstern DELTA series amplifiers with built-in DSP
may be used.
Should you have any questions, please contact
ProAudio Technology regarding this subject.
Cabinet:
The cabinet is made of 12 mm birch multiply wood and coated
with a robust 2-component texture paint finish. A 45° corner
allows it to be used as a monitor speaker. It is fitted with two
handles, eight stacking feet and a tripod flange. Two flying rails
and eight M10 flying points complete the list of features. Behind
the front grille is a layer of black acoustic foam.
Connection:
The connections are made on the rear side through a total of four
Neutrik NL4 SpeakON sockets which are angled in two directions
by 45 degrees relative to the rear cabinet wall. Three of the
four sockets are wired in parallel with each other. Pin pair 1 is
connected to the speaker chassis. On the fourth SpeakON socket,
which is marked correspondingly and rotated by 180 degrees, the
pins have been reversed. Pin pair 2 is connected to the speaker.
Combinations of MT10 and subwoofers, which are fed via a 4-
pole lead, must be connected only to the non-marked SpeakON
sockets!
Never use the marked SpeakON socket that is arranged rotated
by 180 degrees.
Operation on System Amplifiers:
The amplifier configuration software will display help texts for the
individual loudspeakers. Select a setup which contains the name
“MT10“.
On the DELTA8.4-DSP system amplifier up to four MT10 can be
driven per channel.
On the DELTA14.4-DSP system amplifier a maximum of eight
MT10 can be driven per channel.
Details will be shown by the software upon entering the number
of MT10 speakers per channel.
Note:
Use the MT10 loudspeaker only
on system amplifiers with the
available setups. Otherwise there
may be a risk of damage and
inadequate performance.
