PROception PROAPW300L User manual

PROAPW300L- 300Mbps 2.4GHz In Wall Access Point
with RJ45 Port
PROAPW750L- 750Mbps 2.4 & 5GHz In Wall Access Point
with RJ45 Port
PROAPCEILING- 1200Mbps 2.4 & 5GHz Ceiling Access Point
[email protected]
www.blake-uk.com
0114 223 5000
PD2011-9145-03
Default Data:
•In Default GATEWAY mode the management IP address is 192.168.188.253
•Default Login Password: admin
•Default Wi-Fi password 4wG7cZXd
•WAN: Ethernet Port, connect with router.
LAN: Forward port onto local network.
•DC Input: Is 48V.
•AP is FAT (Default) but can also operate in FIT mode (see advanced set up
guide).
•Reset: Press 15 seconds to revert to factory default data.
LED Indicator: To show the working status of 2.4G, 5G and Power.
(LED can be switched off by timer in advanced settings.)
Compatible with all Operating
Systems

PROAPW300L- 300Mbps 2.4GHz In Wall Access Point
with RJ45 Port
PROAPW750L- 750Mbps 2.4 & 5GHz In Wall Access Point
with RJ45 Port
PROAPCEILING- 1200Mbps 2.4 & 5GHz Ceiling Access Point
[email protected]
www.blake-uk.com
0114 223 5000
PD2011-9145-03
SIX STEP EASY AND QUICK SETUP.
1. On an Apple phone, using your camera, scan QR code 1
On android download the free QR Code Reader
by Duy Pham (MMLab) from Playstore and scan QR Code 1
Wait 10 seconds for the phone to connect to the AP
2. Now Scan QR code 2
If after several seconds you get “webpage not available, simply switch off mobile
data on your device and scan again
3. Log in with the word admin (lowercase)
4. Select Get IP from Gateway (Customers router)
If your connecting to a business network you may need to select static IP and set
up with setting from the company network Admin.
5. Set-up Wi-Fi name (SSID) and required password
It is recommended that you leave all other setting to default unless you are
familiar with these settings.
6. Click Apply…
You have now successfully setup the Access point with your Wi-fi name and
password. The Ap will now reboot, get a new IP from the customers router and
start broadcasting Wi-Fi. This can take 2-3 mins for this to complete. You may
see 2.4 GHz Wi-Fi start first and 5GHz Wi-Fi start a little later.
You will now need to reconnect to the Wi-Fi with your new SSID and password.
NOTE:- You can also connect to the Wi-Fi name Prowifi_2.4G with password
4wG7cZXd and browse to 192.168.188.253 if the QR code cannot be scanned.
EU Declaration of Conformity
Blake UK hereby declares that the radio equipment type PROAPW300L, PROAPW750L & PROAPCEILING
are in compliance with Directive 2014/53/EU.
The full text of the EU declaration of conformity is available at the following internet
address: www.blake-uk.com/DoC
Apple Quick Connect
1st Scan here to connect 2nd Scan here to setup
If the access point is still in its default Gateway mode, then connection is easier via Wi-Fi.
If you are using Apple products simply scan the QR codes below with your Tablet.
The 1st QR code connects to the Wi-Fi and the 2nd QR code connects to the Login screen.
This can sometimes work with Android depending on the QR code app and the Tablet. If not
download QR Code Reader as detailed below.