PRODECODER HY22 User manual

MANUAL
PRODECODER HY22
www.prodecoders.com

Instructions
step 1:
step 2:
step 3:
step 4:
step 5:
step 6:
Open the Gate by pulling it back
Turn the Turbo wheel all the way to the RIGHT
With the reset tool, push down (reset) the 12 pins
You have 6 pins on the two sides of the tool.
Start by pushing down the SIX pins from one side, then push down the other SIX
pins on the other side
After all pins are reset, close the Gate by pushing it in
The TURBO wheel stays all the way to the right
Important!!! Every time when you insert the tool into the lock or you pull it out
of the lock, the GATE must be closed (PUSHED IN) and the Turbo wheel must
be turned all the way to the RIGHT
Insert the tool into the lock, hold it freely

step 7:
step 9:
step 10:
step 11:
Open the Gate by pulling it back
Start “pumping” – you can “pump” by turning the Tension
wheel all the way to the left, hold it and start moving the
Turbo wheel to the left until you reach the end point (stop
point). After that, return the Turbo wheel to the right until its
stops. Release the Tension wheel. Repeat the procedure by
changing only the tension wheel's direction (left and right)
After you open the lock, turn the Turbo wheel to the left,
close the Gate by pushing it in, and finally return the Turbo
wheel all the way to the right
Remove the tool from the lock
Don’t forget to watch the Instructions Video from
your USB drive or the link on your email