Prodigy P500 User manual

INSTALLATION MANUAL
PRODIGY

2 3
PRODUCT INSTALLATION
Before Installing..........................................................4
Parts..................................................................................5
Installation.....................................................................6
TABLE OF CONTENTS

4 5
BEFORE INSTALLING PARTS
Confirm the compatibility of your bathroom using the
dimensions below:
A. What is my rough-in?
12” from the wall to the center of the toilet trap.
B. Where is my shutoff valve?
Type B1: The shutoff valve will be positioned outside of the toilet base
if it is more than 6.25“ from the center of the trap when measured along
the wall.
Type B2: The shutoff valve will be positioned inside the toilet base if it is
less than 5”.
C. Shutoff valve position If the shutoff valve is positioned between B1 and
B2, it must have a depth of less than 4” to allow for proper installation.

6 7
INSTALLATION
Remove the existing toilet
1. Close the water shutoff valve
and flush the toilet.
2. Disconnect the existing
water hose and unscrew the
flange bolts.
3. Remove the toilet and wax
ring, leaving the exposed
trap (pictured below).
Install the Prodigy Base
1. Attach the provided
water hose to your water
shutoff valve.
2. Apply the new wax ring to
the exposed trap.
3. Line up the toilet base over
the flange screws. Place the
toilet base and re-secure the
flange bolts.
*if you will not install the
Prodigy immediately,
cover the exposed trap to
eliminate any fumes.
*You may need to use the included
conversion nut to fit your water shutoff
valve. Simply screw the conversion nut
into the 1/2” side of the hose before
connecting it to your water shutoff valve.
*A team of two people is
recommended to correctly
place the toilet base.

8 9
INSTALLATION (CONT.)
Attach Bidet Seat Removing The Bidet Seat
1. Feed the water hose through
the back of the toilet base
and attach it to the underside
of the bidet seat.
2. Attach the bidet seat to the
toilet base by lining up the
mounting hooks and pressing
down until you hear a “click.”
Do not use excessive force when
attaching the bidet seat to the
toilet base.
1. The bidet seat can be
removed by pulling the tabs
beneath the unit forward and
lifting up.

10 11
INSTALLATION (CONT.)
1. Open the water shutoff valve. 2. Plug in the power.
*The Prodigy must be plugged
into a properly installed and
grounded outlet.
3. Insert the included batteries
into the remote control and
flush the toilet.
Contact us
Please contact Bio Bidet support if you have any questions. Trained support
agents are available Mon - Fri, 9:00 AM - 5:00 PM CST.
Email: [email protected]om
Phone: [phone]
Chat: www.biobidet.com

Thank You
Technical Support/Customer Service
7900 S Route 31 Crystal Lake, IL 60014
T: 847.458.2334
U.S. TOLL FREE: 877.339.5214
www.toiletseats.com
[email protected]om
www.biobidet.com