Prorack PR3600 User manual

Page 1 of 3
6100010838 Rev1
Bike Fork Mount Carrier
First Time Installation
• Please read instructions carefully before installation.
• Check the contents of kit. Contact your Prorack dealer if any parts appear to be missing or damaged.
• Clean your roof racks prior to tting the basket.
Important Warning
• It is critical that all Prorack racks and accessories be properly and securely attached to your vehicle. Improper
attachment could result in an automobile accident, and could cause serious bodily injury or death to you or to others.
• You are responsible for securing the racks and accessories to your car, checking the attachments prior to use, and
periodically inspecting the products for adjustment, wear, and damage.
• If you do not understand all of the instructions and cautions, or if you have no mechanical experience and are not
thoroughly familiar with the installation procedures, you should have the product installed by a professional installer
such as a roof rack specialist.
BlockHead attaches securely to flat surfaces. Recommended Mounting Hardware
includes 6 mm (1/4”) bolts or screws, fender washers, and locking nuts
12
Remove the skewer from the block by
loosening the nut
Use the template below to scribe two
drilling points
• Use 6 mm (1/4”) mounting hardware.
• Always check handlebar clearance before
attaching block.

12 mm 9.5 mm
19 mm
7 mm
81 mm
Page 2 of 3
6100010838 Rev1
3Align block with drilled holes
Pivot the bolts or screws into place. 4Tighten hardware securely.
Test installation by pulling and shaking.
Replace skewer and attach the nut.
56
Set the bicycle forks onto the skewer. With lever open, tighten nut until the
lever closes with some resistance.
Loosen or tighten the nut as needed so that lever
closes with some resistance.
Check the template against the block before drilling
Test security by tugging at forks. If forks can move out of the skewer, open lever and
tighten the nut slightly
Close lever again with rm pressure. Repeat if necessary.

Page 3 of 3
6100010838 Rev1
Caution
• Make sure all loads are securely fastened. Check regularly during longer journeys.
• Never drive into a car wash with the bike attached to the system.
• Do not exceed the vehicle manufacturer’s load rating.
Maintenance
• Check accessory is securely attached whenever you ret it to the vehicle. If the unit feels loose, refer to the tting
instructions and readjust.
• Regularly check all fasteners. This includes all attached accessories and roof racks.
• Clean with hot soapy water and sponge as required.
• Lubricate skewer occasionally.
Prorack
17 Hinkler Court, Brendale
QLD 4500, Australia
Freephone
AU: 1800 143 548 www.prorack.com.au
NZ: 0800 4776 722 www.prorack.co.nz
ALL CONTENT SUBJECT TO YAKIMA AUSTRALIA PTY LTD COPYRIGHT © 2012