Protek RC P-8 User manual

1 – Hauler Bag
1 – Tool Caddy
1 – Left Side Panel
1 – Right Side Panel
P-8 SUPER HAULER BAG INSTRUCTIONS
Bag Contents
2 – Shelf Panels with Divider
6 – Medium Drawer End Caps (9 ½“)
2 – Large Drawer End Caps (19 ½”)
2 – Small Drawer End Caps (8”)
1 – Large Drawer
3 – Medium Drawer
1 - Small Drawer
STEP 1 Assembly of Hauler Bag
1A) Remove bag from plastic, lay on flat surface with the front of the bag facing
upwards. Place left side panel (without notches) in bag with the top of the panel
underneath small plastic holder at top of bag. Slide lower portion of side panel
into position. Repeat for right side.
Note: Velcro gap on left side panel should be larger on top than on the bottom.
1B) Starting with the bottom shelf, secure the Velcro strip for shelf to left and
right side of hauler bag. Make sure to push the shelves as far back as possible
and attach to the Velcro strip to the rear of the bag. Fold down divider. Repeat
for top shelf.
1C) Completed hauler bag with shelves.

STEP 2 Assembly of Tool Caddy
2A) Place tool caddy on flat surface and pre-bend all hinged surfaces.
Note: Velcro gap on left side panel should be larger on top than on the bottom.
2B) Fold both sides up towards the center.
2C) Fold end up and over flaps from the sides. Push tab into the slot on bottom
of the tool caddy. Repeat for opposite side.
2D) Completed tool caddy.
2E) Secure velcro for pre-installed tool holder and place tool caddy in top of
hauler bag.

STEP 3 Assembly of Storage Drawers
3A) Remove Medium Drawer and place on flat surface. Pre-bend all hinge
surfaces for easier assembly.
Note: Velcro gap on left side panel should be larger on top than on the
bottom.
3B) Remove covering from double-sided tape, fold side panel up, and tuck
small flap inside end panel. Secure to end panel with double-sided tape.
3C) Repeat with opposite side.
3D) Once both sides have been completed, remove covering from double-sided
tape on the back panel, and place the end cap over the top to ensure to cover
the flaps from the side panel and end panel. Repeat for the front of the drawer.
3E) Repeat for all drawers.

STEP 4 Final Assembly
4A) Place all drawers in hauler bag.
Front Back
After-Sale Service & Guarantee
ProTek R/C guarantees this item to be free of defects in materials and workmanship for three (3) months after original
purchase date. Warranty will not cover items that have been modified, disassembled, or otherwise misused according
to the item’s instructions. Proof of purchase is required for to submit a warranty claim. ProTek R/C isnot responsible for
bodily injury and/or property damage that may occur from the use of, or caused by, this item.