Protherm Panther 24 KTV Quick start guide

Operation and
Installation Guide
24 KTV / v.18
24 KOV / v.18
24(12) KTO / v.18
24(12) KOO / v.18
Wall-hang gas boiler
Output range 8,4 - 24,6 kW
Possibility of equithermal control
Panther
xxxxxxxxxx_00 - v.1 1/2007
EN
version

1
Panther 24 KTV / 24 KOV / 24(12) KTO / 24(12) KOO
The boiler’s Serial no. is shown on the plate which is attached to the front side of the
control panel. The control panel is accessible after removing the front cover.
In the section “Operating Instructions” you will find description of the boiler’s main functions
and guidelines on how to handle the boiler safely. The section “Installation Instructions”
is for skilled workers only.
Obsah
Table of contents
Introduction........................................... 2
OPERATING INSTRUCTIONS
Controls and signals............................. 4
Selecting Read mode ........................... 5
Selecting Setup mode .......................... 5
Error codes........................................... 7
Schematic diagram of boiler control ..... 8
Starting up and shutting down boiler .... 9
Boiler control......................................... 9
Protection functions............................. 10
Service and maintenance.................... 11
Warranty and warranty conditions ....... 12
Technical specifications....................... 13
Connection dimensions ....................... 17
Usable overpressure into system ....... 18
INSTALLATION INSTRUCTIONS
Schematic diagram of boiler ............... 19
Introduction.......................................... 21
Delivery completeness ........................ 23
Preparing for boiler installation............ 25
Installing the boiler............................... 27
Air and combustion gas
passages (KTV, KTO).......................... 30
Electrical connection of boiler.............. 35
Connection of boiler to hot water tank. 36
Converting to different fuel .................. 37
Electrical wiring diagram..................... 38

2
1. The boiler and all the associated
equipment must be installed and used
in accordance with the installation
design, all the corresponding valid legal
prescriptions and technical norms and
with the manufacturer’s instructions.
2. The boiler may be installed only in an
environment for which it is designed.
3. After installation, the boiler may be put
into operation by an authorised service
organisation only.
4. The boiler complies with the prescripti-
ons valid in the Slovak Republic. When
used in the conditions of other count-
ries, any applicable deviations must be
identified and addressed.
5. In the event of a defect call the
manufacturer’s service organisation
– any unauthorised intervention may
damage the boiler (and possibly also
associated equipment!).
6. The service technician putting the boiler
into operation for the first time is obliged
to familiarise the user with the safety ele-
ments of the boiler, their characteristics
and with the relevant required response
of the user, with the fundamental parts
of the boiler and manner of use of the
boiler. If this technician is also delivering
the boiler, he/she must ensure that the
original packaging of the boiler is availa-
ble for potential further transport thereof
until the moment of launch into operati-
on.
7. Check whether the delivery is comple-
te.
8. Check whether the model and type
supplied corresponds to the type
required for use, i.e. check whether the
data relating the boiler settings stated
on the plate correspond with the data
relating to the local network supplying
fuel (gas) to the place of installation, or
have this performed by a professional
technician who shall install the boiler or
put it into operation.
9. Whenever you are not sufficiently certain
of how to control the boiler, seek out and
study all the corresponding instructions
in this Operation and Installation Guide
carefully and proceed accordingly.
10. Never remove or damage any markings
and signs on the boiler. Also store the
original packaging of the boiler in an
undamaged condition for potential fur-
ther transport in the case that the boiler
is not put into operation.
11. When performing any repairs, only ori-
ginal parts may be used. It is prohibited
to make any changes to the boiler’s
internal installation, or to interfere with
this in any way.
12. When shutting the boiler down for a
longer period of time, we recommend
that you close the gas supply and dis-
connect the boiler from the electricity
network. This recommendation applies
in conjunction with the general condi-
tions stipulated in this Operation and
Installation Guide.
13. At the end of its useful life, the boiler or
its parts must be disposed of ecologi-
cally, in a manner which avoids causing
any harm to the environment.
14. The manufacturer is not liable for and
provides no warranty for damages cau-
sed by the failure to abide by:
• the conditions stipulated in this Operati-
on and Installation Guide;
• prescriptions and norms;
• proper installation and operation proce-
dures;
• conditions stated in the Warranty Certi-
ficate and the Service Book.
15. If the boiler is delivered to the user by
Introduction

3
the technician who also installs the boi-
ler, this technician is also obliged to pre-
sent to the user all the accompanying
documentation for the boiler (in particu-
lar the Operation guide, Service Book
etc.). If the boiler is not put into opera-
tion, the original packaging of the boiler
must be available for the potential fur-
ther transport thereof.
Safety of equipment and people
• According to the findings of the SZÚ
Brno (National Testing Institute), the boi-
ler (as well as all its optional accesso-
ries) complies with the requirements of
European Directive 90/396/EEC on gas-
fuelled appliances and European Directi-
ve 92/42/EEC on efficiency, the Euro-
pean Directive 2006/95/EC on electrical
means of operation for use in certain
voltage ranges and the European Directi-
ve 89/336/EEC on electromagnetic com-
patibility.
• The appliance is also approved accor-
ding to the European norms EN 677, EN
625, EN 60335-01, EN 50165, EN
55014, EN 61000-3-2 and EN 61000-3-
3.
• In order to operate and handle the boiler
in accordance with the purpose for which
it is designed in actual conditions of use
(hereafter referred to only as use), it is
necessary to abide also by additional
conditions – the most essential of which
(i.e. those which must not be omitted)
are found in the following regulatory
documents:
- in the design area: STN 06 0310 and
STN 06 0830;
- in the fire safety area: STN 92 0300;
- for installation and fitting (and repairs):
STN EN 1755 or STN 38 6460, as appli-
cable STN 38 6462, Decree no. 48/1982
Coll. (as amended by the later prescripti-
ons) and the binding occupational health
regulations;
- in time of running and operation: STN 38
6405;
- in the area of discharge of combustion
gases and air inflow STN EN 483, com-
pany material – “catalogue of dual piping
for discharge of combustion gases and
inflow of combustion air designated for
type C gas appliances, i.e. in closed
“TURBO” version.
• In addition to the above mentioned docu-
ments, it is necessary when using the
boiler to proceed in accordance with this
Operation and Installation Guide and the
accompanying boiler manufacturer’s
documentation. During use of the boiler
any handling by children, persons under
the influence of intoxicating substances,
non-certified persons, etc. must be pre-
vented.
In practice situations may arise in which
the following essential measures must
be adopted:
• prevent the boiler from (even accidental-
ly) being switched on while conducting
inspections or working on the combusti-
on gases flue route or gas and water dis-
tribution pipes by disconnecting the boi-
ler from electrical power supply also by
other means than only using the main
switch (e.g. by pulling the power cord
plug out of the power socket);
• shut the boiler down every time when
there are any (even temporary) flamma-
ble or explosive fumes present in the
area from which combustion air is
supplied to the boiler (e.g. from paint
when painting, laying and spraying mol-
ten substances, from gas leaks, etc.);
• if it is necessary to drain water from the
boiler or from the whole system, the
water must not be dangerously hot;
• in the case of a water leak from the
boiler’s heat exchanger or when the
exchanger is clogged up with ice, do not
attempt to start up the boiler until normal
operating conditions have been resto-
red;