PSI Audio A14-M User manual

Relec SA – Petiots-Champs 11 a+b – 1400 Yverdon-les-Bains – [email protected] - [phone]
PSI AUDIO - Re-assembling A14-M
Don’t&power&up&the&electronics&prior&to&assembling.&&
The&cables&need&to&be&attached&to&the&print&and&on&the&A14,&the&level&axis&needs&to&be&attached&to&the&potentiometer&
(see&photo&below)&
&
&

Relec SA – Petiots-Champs 11 a+b – 1400 Yverdon-les-Bains – [email protected] - [phone]
Attach&cables&to&the&print&
Attach cables from the speaker onto the print and fasten with 2 screws. Make sure it is positioned the right way
round and respecting polarity.
On&the&A14,&the&level&axis&needs&to&be&attached&to&the&potentiometer&&
Make sure the Level axis in turned to “cal”
Make sure the potentiometer is also in “cal” position
When assembling the back panel to the cabinet, take great care in positioning the level axis into the
potentiometer. This can be quite tricky and the best is to use a light to see the axis through the level hole on the
back panel.

Relec SA – Petiots-Champs 11 a+b – 1400 Yverdon-les-Bains – [email protected] - [phone]
Fasten screws on back panel
These screws are not meant to be removed and replace. Please don’t fasten too tight, If necessary use a small
drop of glue in the screw hole on the cabinet.
Replace sticker on level hole on back panel.