Pyle PLCD27 User manual

Car Audio Hifi System
WNER'S MANUAL
CD PLAYER
R
PLCD27

1
Band
Band tuner
Direct access tuning
Radio wiring
Speaker wiring
Install the unit
Removing the unit
Power
Volume
play/pause
eject
clock
loud
release
Volume setting
bass setting
treble settting
balance setting
fader setting
To p
scan
repeat
random
stop

2
To prevent injury of fire,take the
following precautions: To prevent damage to the machine, take the following precautions:
Insert the unit unitll it is firmly locked to the
main unit, otherwise it may
fall out of place when jolted
When extending the ignition, memory
back up or ground cable, use diameter of
0.75mm(AWG18) or
more automotive grade cable to avoid wire
deterioration or damage
to the wire coating.
To prevent short circuit, never put or leave
any metallic object into the unit.
If you smell or see smoke, turn off the
power immediately and consult your dealer.
Be careful not to drop or shock the unit
strongly, it may break or crack because it
contain glass parts.
Be sure the unit is connected to a 12V
DC power with a Negative Ground
The unit is only designed for use with 4
speakers. Do not combine output for use
with 2 speakers. Do not ground negative
speaker leads to the chassis ground
Do not open the top cover and do not install
theunitin
place where it is exposed to direct sunlight
(including the faceplate),in order to avoid high
heat or humidity, water splash over it or dust.
Do not touch the terminals of the units.
Attaching panel
Attaching panel
Attach the front panel by fixing
the left side of it into this unit as1
showing.Then push the right side
of panel towards into connecting
plug as 2 showing.
If you have difficulty in installing this unit
in your vehicle. Please contact your dealer.
If the unit seems not work in properly press
the reset buttonto reset the memory of the
unit.

Power
Turning ON the power
Press the [PWR]button.
If a disc has already been loaded, CDIN would be shown on
the display, press this button to start play disc even though
the unit is in Radio mode. When disc
is playing, press this button to
pause the disc, press again
to resume the normal play.
Volume
Play/pause
Press to turn on the unit power,Press the button to turn off
the unit.
Play
Press the [CD]button
Pause
Press again the [CD]button
3
Increasing volume
Decreasing
Rotate the [VOL+]button
Rotate the [VOL-]button
VOL+
VOL-
PUSH
ON/OFF
VOL
TOP SCAN REPEAT RANDOM STOP
1256
34 CLK
DSP
EJECT
CD
BD
SELECT
POWER ON/
OFF/VOLUME PLAY/PAUSE
SELECT CLOCK
EJECT
DSP
LCD display
RELEASE
D
OM
RANDOM
STOP
56CLK
CD
BD

Eject
In beam mode, press the BD button can enter radio
mode. If the disc in the slot, press the EJECT button to
eject the disc form the slot and automatically be
switched to the radio mode.
In radio mode, if push a disc into slot, the disc will
automatic insert and begins to play. If the disc in the solt,
press PLAY/PAUSE button to play the disc again.
Clock
Press CLK can display time. Time will display even
power off.
Long Press CLK for 3 second will into clock set mode.
4
Out
In
Press the [ ]button ,if having adisc in the unit.
The disc will be ejected out.
Press the [ ]button again, the disc
will be load in.
LOUD/DSP
Press [ ] button to adjust the hour.
Hour
If there no operation in 5 second, it will quit clock
set mode.
Minute
Quit clock set mode
Press [ ] button to adjust the minute.
Release
press the " " button to release faceplate.
Short press this button to DSP
Press DSP button once, ROCK will bicker on display.
Press DSP button twice, POP will bicker on display.
Press DSP button third, CLASS will bicker on display.
DSP
Long press the DSP button to emphasize the bass output,
press it again to resume the normal listening.
LOUD

Treble set mode
Press SEL button third,
display shows TRE ,then
rotate the volume + button to adjust treble
level up. Rotate the volume - buttonto adjust
treble level down.
Press SEL button fourth
display shows BAL ,then
rotate the volume + button
to adjust left speaks level .
Rotate the volume - button
to adjust right speaks level .
Balance set mode
Fader set mode
Press SEL button fifth,display shows FAD ,then
rotate the volume + button to adjust front speaks
level. Rotate the volume - buttonto adjust back
speaks level.
Speaker mode
5
PRESS
SELECT
Press SEL button once,display shows VOL ,
then rotate the volume + button
to adjust volume level up.Rotate
the volume - button to
adjust volume
level down.
Volume set mode
Bass set mode
Press SEL button twice,displayshows BAS ,
then rotate the volume + button to adjust bass
level up. Rotate the volume - button to adjust
bass level down.
VOLUME BASS
BALANCE
TREBLE
FADER
In press mode, VOL is sel function
VOL
SEL
VOL+
VOL-
PRESS
PUSH
ON/OFF
VOL
TOP SCAN REPEAT RANDOM STOP
125634 CLK
DSP
EJECT
CD
BD
SELECT
TOP REPEAT
RANDOMSCAN
STOP
SELECT
VOL+/-

6
Top
Repeat
Random
Scan
Select the first track directly
In CD mode,press this button, the first track will play.
Press [TOP]button
Press the button once to repeat the same track continuously,
Press the button twice to repeat the disc continuously,
RPT will appear on the LCD display.
Press [RPT]button
Press this button to play all the track inrandom order. RDM
will appear on the display. Press it again to stop random playing.
This button is invalid ifthe unit is in PBC On mode.
Press [RDM]button
Press this button once for TRACK INTRODUCTION,the first
ten seconds of each track on the disc will paly. To confirm
the track number. Press it again while playing on the desired
track. SCAN will appear on the display.Press it again to
stop it.
Press [SCN]button
Stop
Press this button once to stop play music .
Press [STOP]button

Band
Tune
Press BAND button to select among three FM or two AM bands.
(FM1-FM2-FM3-AM1-AM2)
Selecting band
the long press button it can automatically select
frequency station. And the long press it can automatically
select lower frequency station.
higher
In radio mode:
manual tuning:
short press button it can select higher frequency station.
Short press can select lower frequency station.
Auto loading tuning:
7
Frequency
ST
PUSH
ON/OFF
VOL
TOP SCAN REPEAT RANDOM STOP
1256
34 CLK
DSP
EJECT
CD
BD
SELECT
SEEK+SEEK-
BAND
PRESET MEMORY 1-6

APS
MONO
LOUD CLK STOP TOP
RPT
SCAN
RDM
Basic operation
Pull out
Loading and replacing the battery
Use one lithium battery(CR2025)
insert the batteries with the +and - poles aligned properly.
Following the illustration inside the case.
Store unused batteries out of the reach of children. Contact a
doctor immediately if the battery is accidentally swallowed.
Do not set the remote on hot places such as above the dashboard.
Turning ON the power
Press the [ ]button.
Press to turn on the unit power,Press the button to turn off
the unit.
8

External view
........ Number of items External view ........ Number of items
The use of any accessories except of those provided
might result in damage to the unit .make sure only to
use the accessories shipped with the unit ,as shown
above.
9
1
2
3
5
6
............1
............1
............1
............1
............1
............1
7
............2
4
Remote operation the same
of mainframe.
Radio control
Page(7)
Play
Press the [ ]button
Pause
Press the [ ] button again
Play/pause
Increasing volume
Increasing volume
Press the [+]loud VOL
Volume
Press the [-]low VOL
APS MONO
LOUD CLK STOP TOP
RPT
SCAN
RDM
8............1

Follow this easy wiring diagram in order to enable you to install
the new or existing RADIO and SPEAKER wring system.
Be sure the unit is connected to a 12 volts battery with negative ground.
Good ground connections eliminate most electrical noise problem and
require tight with the metal vehicle chassis. remove plastic, paint or dust
for good electrical contact.
SPEAKER WIRING
Theunitisonlydesignedfortheusewith4speakerssystem,itcan
only be connected with speakers rated in the load impedance range
from 4 to 8 ohms. Load impedance less than 4 ohms could damage
the unit.
Never combine (BRIDGE) the outputs for use with 2 speakers, and
Never ground any Negative speaker to the chassis ground.
10
CARANTENNA
RED RCH
WHITE LCH
RCAline outRCAline out
Green Grey
Green
/white Grey /white
LeftFront RightFront
Brown Blue
Brown
/white Blue /white
LeftRear RightRear
RED RCH
WHITE LCH RCAline outRCAline out
Connect to control for antenna
or remote control for amplifier. Orange
Connect to battery or +12 volts of
power source that is always live.
Black
Ground-
Red
12V+
Connect to lgnition key switch.
CARANTENNA
Memory+ YELLOW

11
Before installing the receiver permanently, fit it in the approximate place in your car Connect the
equipment according to the speakers and electrical connections. When
your system is operated properly,(preferably with the
car engine running), follow the instructions
for permanent installation
of your system.
1)Adapter
(not supplied)
2)Bend over tabs
of half sleeve
(supplied)
3)Support strap
(supplied)
Half sleeve
(supplied)
4) Two wrenches for release
the unit (supplied)
INSTALL THE UNIT
1)Install half sleeve, can be with or
without adapter. It will fit better
with adapter.
2)Bend over some tabs where possible
tosecure the half sleeve inside of dash.
3) Support strap to bestrutted under
dash, secure this strip to avoid skipp
ing of disc.
Insert removal wrench into the small
gap on the right side of the unit and pull
the unit slightly out on the same side,
then release the wrench. Repeat the
same action for the left side. By now,
you can remove the unit and unplug
the wires connector.
REMOVING THE UNIT

Signal/Noise radio......................................................70dB
Frequency response..............................20Hz-20KHz(+3dB)
Channel separation..................................................>45dB
Dual D/A converter.......................................................16Bit
Tuning range............................................USA:87.5-108MHz
(100KHz step)
EUROPE:87.5-108.0MHz
(50KHz step)
FM usable sensitivity(S/N=30dB)..............................<12dB
Stereo separation.....................................................>45dB
FM Tuner
AM Tuner
Tuning range...........................................USA:520-1720KHz
(10KHz step)
EUROPE:522-1620KHz
(9KHz step)
AM sensitivity..............................................................28dB
Operating power.....................................12 Volts DC,negative
ground
%10THD output wiring.........................Designed for using four
speakers only front and rear
channels cannot be combined
in use with 2speakers.
Load impedance..................................compatible 4 to 8 ohm
speakers
Fuses........................................................1amp and 10 amp
Dimensions...........................................178mm(L)x50mm(W)
x150mm(H)
Weight......................................................................2.5Kgs
CD PLAYER GENERAL
Specifications subject to change without notice.
12

What might seem to be a malfunction in your unit may
just be the result of slight misoperation or miswiring.
Before calling service, first check the following table
for possible problems.
?The power does not turn ON.
The fuse has blown.
Install half sleeve, can be with or
?NO Sound.
The cable connect incorrectness.
Exactitude connect of the cable.
?Noise on Radiopoor recepiton
Antenna andAntenna Cable.
Check antenna and antenna cable, the antenna base must be
grounded and connected with good condition, repace
antenna or antenna cable if needed.
?Noise on both Radio and CD
Poor ground,dirty or corroded at the car Battery posts
Check the black wire for proper grounding clean and tighten ground
connection.
?No/Poor sound on one or more speakers
Speakers or speaker wiring or volume, Balance and
Fader setting
Check the speaker wiring and test the speakers all in good condition
check the setting of volume, Balance and Fader controls.
?CD sound skips
Installation the unit angle is greater than 45 ,or
mounting is not fixed and the back strap is not secure.
Adjust the unit with mounting angle less than 45 and make sure the
unit is mounted securely and tighten with the back strap(supplied)
?Unit completely inoperative, no Light and Sound
Incorrect wire connection, Power RED/YELLOW or
Ground wire or Blown fuse
ChecktheRedwireto+12Voltswithkeylgnitionwitch,yellowwireto
+12 Volts battery and black wire to ground. Check Fuse with red/yellow
wire, or check the fuse block on your car.
13

CD PLAYER
Car Audio Hifi System