Pyle PLVWR900 User manual

INSTRUCTION MANUAL
PLVWR900
POWER
ON/OFF OPEN/CLOSE SEL
HD TFT LCD MONITOR
PLVWR900
9 INCH HIGHRESOLUTION TFT LCDMONITOR

WELCOME
Thank you forthe purchase ofthis monitor.Beforeoperating the unit,pleaseread this
manual thoroughly andretain it forfuture reference.
Precautions
Toprevent short-circuiting ofthe electrical systemand cause seriousdamage to the
unit or thevehicle, you areadvised to followthe instructions carefully.
Should there berequirement to replaceblown fuse,do rememberto disconnect all
power supply andswitched off theunit before replacingit with anew one.Use only
correct rating fuse toavoid damage the unit.
During operation,if there issymptom of over-heating orsystem mal-function,do switch
off the unitand consult yourdealer immediately.Pleasedo not attemptto open upthe
unit since thereis no serviceableparts inside.
To avoiddamaging the LCD paneland cause serious injuryto you or others,please
observe the followings:
Do not drop theLCD display panel ofsubject it to directimpact.
Should the LCDpanel is broken,doavoid all humancontact to thebroken glasses or
Fluid leaked outfrom the enclosure.Ifcome into contact,do flush andclean affected
areas with plentyof water.Seekmedical attention immediately.
This unit isdesigned using highquality electronic componentsand manufactured
under stringent qualitycontrol system.The systemunit will providemany hours of
quality performance ifuse correctly.Dofollow the maintenanceprocedure below:
The battery life ofthe remote control unitis about six monthslong.To ensureeffective
control,please replace thebatteries regularly.Donot use newand used batteriesat the
same time toavoid damaging the goodbattery.
Do not useany chemical solvent,cleaningagent or corrosivedetergent to cleanaway
dirt on thesurface of thescreen.By doing so,youmay cause irreversibledamage to the
surface of theTFT screen.To clean offdirt or fingerprints,we recommend theuse of a
soft damp lenscleaning cloth.

PRODUCT FEATURE
High resolution fullcolor TFT
Brand new LCDpanel
Easy installation,compact size
provides VCR/VCD/DVD/Game playersignal input
Two videoinputs
With remote control
on screen displaymenu
Auto power offif no signalfor 10 minutes
Low voltage autoalarm
FRONT PANEL
POWER
ON/OFF OPEN/CLOSE SEL
HD TFT LCDMONITOR
PLVWR900
1.neon light poweron/off
2.power indicator
3.open/close the monitor
4.negative adjustment
5.menu activate
6.positive adjustment
7.monitor power on/off
8.reset
1234567
8
A.The image will beshown 4 to 5seconds later
after press (7).
B.Press (1) for over4 seconds to turnthe neon off.
C.Reset to the factorydefault value by (8).
Note:Although the effectivepixels for theliquid crystal isgiven as 99.98%or more,
0.02% of pixelsmay not lightor may lightincorrectly.It isa very commonphenomenon
in active matrix displaytechnology,do notindicate fault or brokenof the unit.

REMOTE CONTROL
1
3
5
7
2
4
6
8
AV1/2 1.power on/off
2.V1/V2 switch
3.brightness -
4.brightness +
5.color -
7.color +
7.contrast -
8.contrast +
SPECIFICATION
Screen size 9inch(diagonal)
Display method TFTactive matrix system
Back light Coldcathode fluorescent lamp
System PAL& NTSC
Aspect ratio 16:9
Power source DC12V
Resolution 1024x532
Power consumption 10W
Max video input 1.0Vp-p
Input impedance 75Ohm
Dimension 24.2x15.7x3.2cm
WIRING
RED: DC 12V
BLACK:GND
YELLOW:V1 INPUT
WHITE: V2 INPUT

Pyle ,Inc
1600 63rdStreet
Brooklyn,NY11204
www.pyleaudio.com