Qlight SRN Operator's manual

1
115
5025
55
108
HORN
• Protection rating : IP55
• Ambient operating temperature : -25°C to +50°C
General Electric Horn
SRN/ SEN15/ SEN25
Model
number Voltage Current Sound pattern
Certicates Weight
SRN
DC12-24V Max.
0.320A
WS - 5 Warning
sounds
WM - 5 Melodies
WA - 5 Alarms
WV - 5 Customiz-
able sounds
0.72kg
AC110V 0.075A
0.98kg
AC220V 0.035A
SEN15
DC12-24V Max.
0.370A
0.76kg
AC110V 0.080A
1.03kg
AC220V 0.040A
SEN25
DC12V 2.211A
0.95kg
DC24V 1.022A
AC110V 0.226A
1.23kg
AC220V 0.113A
SRN - WS - 220 - LC
[Model
number] [Sound] [Voltage] [Sound selection]
| | | |
• SRN
• SEN15
• WS- Warning sounds
• WM- Melodies
• WA- Alarms
• WV- Customizable
sounds
• 12/24
-DC12V-24V
• 110- AC110V
• 220- AC220V
• (Blank)
- Standard type
•LC Type
-Uses external
contact
• SEN25 • WS- Warning sounds
• WM- Melodies
• WA- Alarms
• WV- Customizable
sounds
• 12-DC12V
• 24-DC24V
• 110- AC110V
• 220- AC220V
• (Blank)
- Standard type
•LC Type
-Uses external
contact
※ CE compliant : DC12V-24V(SRN)
DC12V-24V, AC100V/220V(SEN15/SEN25)
Ordering Specications Product Specications
Thank you for purchasing Qlight’s products. Please read this user manual carefully
prior to installation and operation to ensure safe and correct use.
Precautions for Safety
Failure to follow the instructions below may cause a loss of life or serious physical injury.
1. Please remove any objects that can interrupt ventilation around the product.
2. Please turn o󰘯 the power of the product immediately if it fails to operate properly.
3. Carefully wire the product according to each product’s speci󰘰cation.
4. Please be careful in preventing chemicals such as thinner, benzene, etc. in contact with the surface of the product.
5. Do not apply excessive force/impact to the product.
6. Failure to follow any of the instructions above may cause malfunction or damage to the product, 󰘰re, and electric shock.
Precautions for Correct Use
Failure to follow the proper instructions may cause damage to property, the product, and or malfunction of the
product that would void the warranty.
1. During wiring or maintenance, please completely turn o󰘯 the power of the product. (Failure to follow this may lead to an electric shock.)
2. Do not install the product in locations that subjects it to excessive dust or water other than the conditions designated by the IP protection
ratings indicated for each product. (Failure to follow these instructions may cause a 󰘰re to the product, electric shock, physical injury,
malfunction or damage to the product.)
3. Do not alter or repair this product. If maintenance or repair service is required, please contact your local Qlight contact point. (Failure to
follow these instructions may lead to 󰘰re, electric shock, or product damage.)
4. Please apply the correct voltage to the product. (Failure to follow these instructions may lead to 󰘰re, electric shock, or product damage.)
5. When the product is applied to a condition that may impact lives or property, please make sure to have a double safety device. (Failure to
follow this may cause damage to property, 󰘰re, electric shock and loss of life.)
Please scan the QR code for more
detailed product information.
www.qlight.com

2
Ø125
Ø88
Ø10 CABLE ENTRY
3-Ø9 FITTING HOLES
12263
25 25
105
20 87
185
130
128
200
72
41 41
130
20 102
Ø103
Ø10 CABLE ENTRY
3-Ø9 FITTING HOLES
SEN15/ SEN25
SRN
Dimensions
(Unit : mm)
Sound Selection and Wiring Instructions
• External power line - VCTF(0.75sq x 2C) x 400mm
• External signal line - UL1007 AWG22(0.3sq) 400mm
• This product can be wired regardless of polarity.
• Standard : Internal switch
Internal switch allows to choose sound pattern for SRN/ SEN15/ SEN25 models
SRN/ SEN15/ SEN25-DC/AC
EXTERNAL CONTACT
Fuse Fuse
COMMON COMMON
POWER POWER
EXTERNAL TRANSISTOR-NPN
Ch 1 Ch 1
Ch 2 Ch 2
Ch 3 Ch 3
Ch 4 Ch 4
Ch 5 Ch 5
Red(R) Red(R)
Amber(A) Amber(A)
Green(G) Green(G)
Blue(B) Blue(B)
White(W) White(W)
White(W) White(W)
Black(BK) Black(BK)
Black(BK) Black(BK)

3
•
First, machine holes on the mounting surface
•
The mounting hole of this product is 9mm in diameter.
• If the tap is machined, fasten the bolt through the
mounting hole of the product.
• When machining holes, insert the bolt through the hole of the
product,
and tighten the nut from the opposite side of the
mounting surface.
•
When adjusting the phase and lower angle of the mixed housing
after product cancellation Loosen the bracket xing bolts(
①
)
on the side of the product slightly to adjust the desired angle.
■
Installation
■ Adjusting the Angle of the Horn Housing
Housing
(ABS)
Bolt
①
■ Sound Type by Group
Category Sound
pattern Channel Sound tone
Volume (Max.)
SRN,
SEN15 SEN25
WS
5 Warning
sounds
Ch1 Fire.A-ANG
108dB 115dB
Ch2 Emergency WA-U
Ch3 Ambulance PI-PO
Ch4 Machinery Fault
Ch5 High Expansion
WM
5 Melo-
dies
Ch1 Sweet Home
108dB 115dB
Ch2 For Elise
Ch3 Cuckoo's Waltz
Ch4 Piano Sonata
Ch5 Turkish March
WA 5 Alarms
Ch1 Beep Intermittent
105dB 113dB
Ch2 Door Chime
Ch3 Phone Ring
Ch4 PI.PI.PI Short
Ch5 Tripping Beat
WV
5 Cus-
tomizable
sounds
Ch1-
Ch5
Available upon
request
(customized voice
type)
98dB 108dB
• The volume output of this product
is adjustable.
•
Turn the volume dial clockwise to
increase the volume, and turn
counter clockwise to decrease the
volume.
•
There will be no sound when the
dial is put at MIN.
Volume Dial
VOL.
MAX. MIN.
• Standard unit has 5 built-in sound tones.
Select different built-in sounds using the sound setting switch(
①
).
ON
1 2 3 4 5
ON DP
1 2 3
Sound Setting Switch(
①
)
Volume Dial
Parts Denition/ Installation
■
Parts Denition
Sound Selection
Mounting Hole Specications
Installation Environment and Protection Rating
• This product is designed for use with protection rating of IP55.
• If the product is installed in locations that subject it to excessive dust or water other than the designated IP protection rating indicated(IP55),
it may cause malfunction or damage to the product.
• In case of outdoor applications, install the product in the upright position. Do not install the product horizontal or upsidedown positions where
water can potentially penetrate into the product and impact it’s operation.
• For further information, please visit our website (www.qlight.com).
3-Ø9 HOLES
3-Ø9 HOLES
50 82
• Machine holes on the mounting surface referring to the diagram below.
SEN15/ SEN25SRN
Volume Adjustment
■ Adjusting the Angle of the Horn housing

Qlight Co., Ltd. www.qlight.com | [email protected]
Head Ofce | Suite #1510, STX-V Tower, 128 Gasan digital 1-ro, Geumcheon-gu, Seoul, Korea Tel. [phone] Fax : [phone]
Factory | 185-25, Mukbang-ro, Sangdong-myeon, Gimhae-si, Gyeongsangnamdo, Korea Tel. [phone]
Qlight Overseas Sales Dept | 704 Nakdong-daero, Sasang-gu, Busan, Korea(Eomgung-Dong) Tel : [phone]
Qlight Public Relations & Marketing Team Ofce | 704 Nakdong-daero, Sasang-gu, Busan, Korea(Eomgung-Dong) Tel : [phone]
Qlight USA, Inc. www.qlight.com www.qlightusa.com | [email protected]
3003 North First Street, Suite #341, San Jose, CA 95134 USA Tel. [phone] Fax. [phone]
SHANGHAI Qlight Electronic Co., Ltd. www.qlight.com www.qlightcn.com | [email protected]
China Factory/ Shanghai Sales Ofce | #19, Nanda Road, Baoshan Area, Shanghai, China Tel. [phone] Fax. [phone]
Product Operation Inquiry / Customer Support [phone]
You can expect prompt service if you have exact information such as model name, symptom, telephone number and address.
※ALL PRODUCT, PRODUCT SPECIFICATIONS AND DATA ARE SUBJECT TO CHANGE WITHOUT NOTICE TO IMPROVE
RELIABILITY, FUNCTION OR DESIGN OR OTHERWISE.
Head office : Suite #1510, STX-V Tower, 128 Gasan digital 1-ro, Geumcheon-gu, Seoul, Korea (Postal Code : 08507)
Factory : 185-25, Mukbang-Ro, Sangdong-Myeon, Gimhae-Si, Gyeongsangnam-Do, Korea (Postal Code : 50805)
For your safety
Specication and dimensions listed in this catalogue subject to change without notice for product quality improvement.
The newest product information is available on our website.(www.qlight.com)
Please read the instruction manual attached to the product carefully before installation and use.
www.qlight.com
EN - SRN -1911A