Quantum 63932 Assembly instructions
63932
Visit our website at: http://www.harborfreight.com
Owner’s Manual & Safety Instructions
Save This Manual Keep this manual for the safety warnings and precautions, assembly,
operating, inspection, maintenance and cleaning procedures. Write the product’s serial number in the
back of the manual near the assembly diagram (or month and year of purchase if product has no number).
Keep this manual and the receipt in a safe and dry place for future reference. 21e
When unpacking, make sure that the product is intact
and undamaged. If any parts are missing or broken,
please call 1-888-866-5797 as soon as possible.
Copyright©2021 by Harbor Freight Tools®. All rights reserved.
No portion of this manual or any artwork contained herein may be reproduced in
any shape or form without the express written consent of Harbor Freight Tools.
Diagrams within this manual may not be drawn proportionally. Due to continuing
improvements, actual product may differ slightly from the product
described herein. Tools required for assembly and service may not be included.
Read this material before using this
product. Failure to do so can result in
serious injury. SAVE THIS MANUAL.
Page 2 For technical questions, please call 1-888-866-5797. Item 63932
Specifications
Battery Rechargeable Lithium-Ion
Battery Rating 3.7V 2000mAh
Brightness 280 Lumens (high)
28 Lumens (low)
IMPORTANT SAFETY INFORMATION
To prevent serious injury, FIRE, and EXPLOSION:
1. Keep dry.
2. Only use included charging adaptors. Other
adaptors may damage tool or cause fire.
3. Do not submerge Light.
4. Do not operate in explosive atmospheres, such as
in the presence of flammable liquids, gases, or dust.
5. Do not open, crush, heat above
140° F or incinerate.
6. Not a toy. Keep out of reach of children.
Charging Instructions
Read the ENTIRE IMPORTANT SAFETY INFORMATION section at the beginning of this document
including all text under subheadings therein before set up or use of this product.
Note: Do not charge flashlight while in use.
1. Twist the adjustable band near the top of
the Flashlight to expose the USB port.
2. Insert the provided USB cable into USB port.
3. Insert the other end of the cable into the AC/DC
Adaptor and plug Adaptor into a 120V outlet.
4. The Charge Light Indicator will light up Red
during charging. After approximately 3 hours
the Charge Light Indicator turns Green,
indicating the Flashlight is fully charged
and ready for use. Unplug the Adaptor.
NOTICE: Do not leave the Battery in a discharged
state. Charge the Battery every 3 months if the
Flashlight is not in use. This will keep the Battery
from wearing down and add to its life. Do not charge
the Flashlight at temperatures below 40° F.
Operating Instructions
Read the ENTIRE IMPORTANT SAFETY INFORMATION section at the beginning of this document
including all text under subheadings therein before set up or use of this product.
NOTE: Before using Flashlight for the
first time, fully charge the Battery.
1. Press the Power button at the bottom of the light
once to turn on maximum brightness mode.
2. Press again to switch the light to economy mode.
3. Press a third time to switch the light to flash mode.
4. To turn off, press and hold Power
button for three seconds.
5. When finished using the Flashlight,
store indoors away from children.
NOTICE: Do not open the housing, there
are no user-serviceable parts inside.
Page 3For technical questions, please call 1-888-866-5797.Item 63932
Battery Removal
Note: Contains Li-Ion battery. Battery must
be recycled or disposed of properly.
1. To open flashlight, remove both ends of flashlight
by twisting. See Figure A for flashlight structure.
2. Remove Battery Assembly from
the main flashlight housing.
3. Battery is hard-wired to circuit board. To
remove battery, cut wires and remove battery
from Battery Housing. See Figure B.
Figure A: Flashlight Structure
Wires
Battery
Battery Housing
Figure B: Battery Connection
Record Product’s Serial Number Here:
Note: If product has no serial number, record month and year of purchase instead.
Note: Replacement parts are not available for this item. Reference UPC 193175443137.
26541 Agoura Road • Calabasas, CA 91302 • 1-888-866-5797
Limited 90 Day Warranty
Harbor Freight Tools Co. makes every effort to assure that its products meet high quality and durability
standards, and warrants to the original purchaser that this product is free from defects in materials
and workmanship for the period of 90 days from the date of purchase. This warranty does not apply to
damage due directly or indirectly, to misuse, abuse, negligence or accidents, repairs or alterations outside
our facilities, criminal activity, improper installation, normal wear and tear, or to lack of maintenance.
We shall in no event be liable for death, injuries to persons or property, or for incidental, contingent,
special or consequential damages arising from the use of our product. Some states do not allow the
exclusion or limitation of incidental or consequential damages, so the above limitation of exclusion
may not apply to you. THIS WARRANTY IS EXPRESSLY IN LIEU OF ALL OTHER WARRANTIES,
EXPRESS OR IMPLIED, INCLUDING THE WARRANTIES OF MERCHANTABILITY AND FITNESS.
To take advantage of this warranty, the product or part must be returned to us with transportation charges
prepaid. Proof of purchase date and an explanation of the complaint must accompany the merchandise.
If our inspection verifies the defect, we will either repair or replace the product at our election or we may
elect to refund the purchase price if we cannot readily and quickly provide you with a replacement. We will
return repaired products at our expense, but if we determine there is no defect, or that the defect resulted
from causes not within the scope of our warranty, then you must bear the cost of returning the product.
This warranty gives you specific legal rights and you may also have other rights which vary from state to state.
Other Quantum Flashlight manuals
