Quest Engineering Westminster Installation guide
Westminster Annex
• Full item instructions and extended details •
Westminster
Page: 2
Westminster Annex instructions
Thank you
for purchasing this product. At Quest we take every care to ensure that the product fulls
your expectations. We hope you enjoy using this product
Quest manual download site
The quest manual download site can be found at the url below or the QR code
to the left
http://www.questleisure.com/manuals.
General Information
There are many different ways to erect your annex. We recommend using the method listed on the
next page, but if you find a different way that works better for you, then that is perfectly fine as
well.
Erecting an annex can sometimes be done by a single person, but even for a very simply lightweight
annex is always easier and quicker with two. With the premium poled annex we always recommend
using two people as it makes the process far easier.
We do not recommend erecting the annex in strong winds or stormy weather. This is due to the fact
that until the annex is fully erected, pitched and pegged it could become unstable in the wind and
lead to damage to the annex and your vehicle and this is not covered by the warranty.
If you do have to erect your annex in windy or stormy weather, please take extra care as before the
annex is fully pegged down it can easily be blow up into the air, causing damage to the annex, your
vehicle and potentially dangerous to yourself.
Fire and Ventilation
• If using gas or other combustion appliances additional ventilation is required.
• Do not place hot appliances near the walls, roof or curtains.
• Always observe the safety instructions for these appliances.
• Never allow children to play near hot appliances.
• Keep exits clear.
• Make sure you know the fire precaution arrangements on the site.
• Make sure ventilation openings are open all the time to avoid suffocation.
Page: 3
Westminster Annex instructions
Storage , Care and Cleaning
Details on how to look after your annex.
Canvas Seams
• The main seams of this annex are taped to ensure water protection. These can become damaged
over time but can be repaired and re-sealed by using seam sealer.
• For the best results, we recommend contacting your dealer to find out which products to use.
UV Degradation
• UV degradation causes the material to go brittle, fade or change colour. The time it takes to do
this will differ depending upon how often you use it and what the weather is like when you do. It is
a natural process which affects all materials used outdoors. This annex is coated to help prevent
this process, but it does not stop the degradation, it only helps slow it down.
• You can help protect against this degradation by regular care and proofing of the annex. The
annex should be regularly cleaned and re-proofed to ensure that mold and mildew do not build
up and damage the annex. After cleaning your annex, you should always reproof the annex
as cleaning the annex will damage the UV coating on the material. For the best results, we
recommend contacting your dealer to find out which products to use.
• Weathering due to excessive UV degradation is not covered by the warranty.
Condensation
• All coated, non-breathing materials suffer from condensation. The amount of condensation
depends upon the weather conditions and the environment (such as wet ground etc.). During
condensation, water can collect on the fabric of the annex. If enough condensation forms this can
run down the annex and drip off seams or any other stitching point.
• It can be lessened by ventilation. Ventilating your annex allows air to flow though the annex and
lessens the buildup of condensation. Condensation is often mistaken for leaking and is not a
reason for complaint or a fault of the annex.
Usage
• This annex is designed for private and non-commercial use. This is a touring annex and is not
suitable for permanent use.
• In case of storms or snowfall, the annex must be taken down to avoid damage.
• This annex is a touring annex and as such has a standard usage of approximately 8 - 12 weeks per
year.
Page: 4
Westminster Annex instructions
Storage
To help keep your product looking newer for longer and prolong the life and use of the product, we
recommend that the product is always kept inside its bag when stored away. If the product is not
going to be used for an extended period (such as a winter period) we recommend that it is carefully
folded away and stored in a clean, dry and free from damp location.
• Your annex should never be stored away when wet or damp as this will lead to mould and mildew
build up which will damage your annex and invalidate your warranty.
• If you have packed your annex away wet or damp, always dry it out thoroughly before storing it
away.
• Ensure that the annex bag itself is clean and dry before storing the annex away in it as moisture
and dirt inside the bag will be transferred to the annex when stored away.
Care and Cleaning Instructions
Never use and harsh or abrasive cleaners or brushes when cleaning this product as the frame and
fabric may be damaged when doing so. Never fold and put the product away when wet as this can
trap water in the product, which can lead to mould and mildew build up.
• Fabric - Cleaning : We recommend using a dedicated annex cleaner for the fabric, if one is not
available simply warm soapy water. After it has been cleaned, rinse with clean water to make sure
there's no soap or cleaner left inside the fabric. Once rinsed allow the product to dry naturally
before folding away and storing. After cleaning we always recommend re-proofing your annex as
the act of cleaning it may damage the coating on the fabric. Re-proofing also helps keep your
annex waterproof and extends its life by protecting it against the sun and weather.
• Fabric - Re-proofing : Always clean the annex before re-proofing otherwise you will compress
direct into the fabric which can lead to mould build up and damage to your annex. Once cleaned
and dried re-proof your annex using a dedicated annex re-proofing product. Follow the guidelines
on the re-proofing tool as each product may differ slightly, but always ensure that the re-proofing
has got time to dry and cure before packing the annex away.
• Frame : First allow any dirt to dry and brush with a soft brush to remove loose dirt. Once this is
done wipe the frame down with warm soapy water and a soft cloth. Once cleaned allow to dry
naturally before storing away.
Storage , Care and Cleaning
Details on how to look after your product.
Before You Pitch your Annex
A few extra details before you pitch your annex for the rst time.
IMPORTANT
We always recommend pitching your annex at least once before you go away, this is to familiarize
yourself with your annex and to check that there are no issues with it before you are away on your
break.
Pegging Elastics
Your annex comes with pegging elastics. These should be used on all the pegging points that have a
metal hoop on. The pegging elastics allow you to tension the canvas whilst giving it some play in the
wind, which helps against damage and improves the performance of your annex. To use the pegging
elastics follow this simple process :
• Take one pegging elastic and feed the elastic through the metal hoop.
• The ball on the end of the pegging elastic will then lock against the metal hoop when pulled tight.
• Then peg though the elastic loop at the bottom.
Page: 6
Westminster Annex instructions
12
2
Main Pegging Points
Pitching your Annex
Details on how to erect and pitch your annex.
Use the instructions on the next few pages to help you pitch your annex. The frame diagram that
came with your frame is shown below for easy reference and the main pegging points on your
annex are shown on the diagram below. Both of the images below are referenced in the instructions
afterwards.
No Qty Description
12 Rear pegging points
(one left and one right)
22 Front corner points
(one left, one right)
Please note that some of the right
hand points cannot be seen due to
the angle of the diagram.
Frame Diagram
Page: 7
Westminster Annex instructions
Pitching your Annex
Details on how to erect and pitch your annex.
Part 1
a.Take the annex canvas and frame and lay them
on the ground next to your caravan using a
protective sheet.
b.You can now start putting the frame together
ready for use later.
c. Put the 3 roof poles (6,13,7) together, the 2 front
leg poles (1,2) together, the awning connector
pole (10,11,12) and the 2 front cross pole (8,9)
together ready for use.
c. Next unzip the side panel from the Kensington awning as shown in the image above
(highlighted by the blue area).
d.Then zip the Westmisnter annex onto the Kensington awning.
e. The next two steps are done when inside the Kensington awning.
f. Take the awning connector pole (poles 10,11,12 as shown in the frame diagram) and connect
this to the rear leg and front leg of the Kensington annex using the clamps on both ends of
the pole.
g.Then using the velcro strips place the sleeve on the annex over this pole.
Page: 8
Westminster Annex instructions
Pitching your Annex
Details on how to erect and pitch your annex.
Part 2
a. Take the left side
roof poles (6,13,7 -
highlighted in gold) and
attach the clamp at
the end to the awning
connector pole. Please
note that there is a
gap in the canvas next
to the zip to allow the
clamp through and to
connect to the awning
connector pole.
b. Then t the front
left corner spider joint
(4 - highlighted in gold)
and the leg pole (1,2 -
highlighted in gold).
c. Now put the cross pole (8,9 - highlighted in orange) in place and connect the front centre
spider (5 - highlighted in red) in place and connect the last cross pole (8,9 - highlighted in
orange) in place.
d.Now repeat step a-b with the right side roof pole (6,13,7 - highlighted in gold) and t the right
front corner spider joint (3 - highlighted in gold) as shown in the diagram above.
e. Finally put the centre roof pole (6,13,7 - highlighted in red) in place, again ensuring that the
gap in the canvas next to the zip to allows the clamp through and to connect to the awning
connector pole.
f. Once all the poles are in place tension the frame by going around each pole tensioning as
you go. You may nd it easier to do each pole a bit at a time and go around them a couple of
times.
g.You should nd that the poles follow the seams of the annex when in the correct place. If they
do not , tension them correctly until they do.
Page: 9
Westminster Annex instructions
Part 4
22
Part 3
Pitching your Annex
Details on how to erect and pitch your annex.
a.First peg the two rear points (as
shown by number 1 on the image
to the left).
b.Then peg the two front corners of
the annex (as shown by number 2
on the image to the left) ensuring
that the panels are pulled taught
when pegging.
c. Peg the rest of the annex starting from the
rear and moving to the front. These pegging
points use the pegging elastics which are
shown in the image to the left.
d.Once all pegging has been completed go
back around and re-tension any poles that
require it.
1
Page: 10
Westminster Annex instructions
Warranty : 24 Months (2 Years) warranty.
Warranty Claim
• In the unlikely event of a warranty claim, you must contact your retailer.
• If you have not registered your product, rst ll out the registration form overleaf and take this with
you when you go to your retailer.
• Take the product to your retailer that you purchased it from along with your proof of purchase and
explain the issue with the retailer.
• The retailer will then check the product and get in touch with the wholesaler or manufacturer.
• The retailer will keep you informed of the progress of the claim.
• The wholesaler or manufacturer will not (unless under special circumstances) get in touch with you
as all information will be passed back directly to the retailer.
Warranty Information
• This product comes with a full 24 month manufacturers defect warranty and covers any manufacturers
defects for two (2) years from the date of the original purchase. It does not cover any damage
occurred though:
• The product falling, being dropped, scratched or damaged in any way.
• The product has been technically changed by the owner or another third party
• Improper use of the product, including but not limited to extended use, permanent pitching,
commercial use.
• Normal wear and tear - which includes (but is not limited to): colour fading, wearing, stretching.
• Weather damage - which includes (but is not limited to) U.V. degradation and colour changing.
• The aected part will be replaced or repaired (manufacturers option) if they are found to be defective
within the two (2) years time frame.
• The warranty will be void if the product has been subject to neglect, misuse, improper installation,
misapplication, alteration or accident including, but not limited to, improper installation, maintenance
or use of unauthorised parts or attachments.
• Damage caused by not following the instruction manual in full will invalidate the warranty, if this
results in consequential damages, Quest will not be liable for these damages or any costs incurred
due to these damages.
• Quest will not be liable for material damage or personal injury caused by improper use or if the
safety instructions are not properly executed in full.
• All claims must be made though the retailer you purchased the product from and not direct with the
wholesaler or manufacturer.
• Warranty claims cannot be honoured without an original dated receipt and or proof of purchase.
• By executing repairs the original warranty period of two (2) years will not be extended, nor the right
to a complied new warranty. This warranty is only legal on European soil.
• This warranty does not overrule the European directive 2011/83/EU.
• This product may not be amended or changed.
Warranty
Details of the warranty on your annex.
Page: 11
Westminster Annex instructions
Registration
Registration form for your annex.
Your Name*
Your Email
Address*
Postcode*
County
Annex Name Quest Elite Premium Poled Westminster Annex
Purchase date*
Batch Number
Detail Details*
All elds marked with a * are required. Your batch number can be found on the
label inside the annex and printed on the side of the box.
This form can also be lled in online at :
https://www.questleisure.com/register
or by using the QRCode to the right
twitter.com/questleisure facebook.com/questleisure youtube.com/questleisure
www.questleisure.com
Template Version : 4 • Instruction Version : 1
Table of contents
