Quick Containers LED Sensor Light User manual

Shipping Container
LED Sensor Light Instructions
Model: LED Sensor Light Input Voltage: USB 5V
Figure 1: Product Pack
Introduction
Thank you for choosing your container light from Quick Containers! This motion sensor LED light has an extra strong
magnetic back allowing for easy fixing to a shipping container roof or wall. A sticky back strip is also included if using in
non-magnetic storage spaces such as a lined or aluminum container. This can make moving and working inside a
shipping container much safer and easier, especially in poor light and winter months.
This LED light has a combination of 2 automatic sensor modes, it can be set to activate just using the motion sensor, or it
can activate from either the motion or light sensor using wireless PIR technology. Fitted with a 120 degree motion
sensor that will be activated from approx. 10ft/3m of motion detected. The light will automatically turn off after 20
seconds of no motion. We recommend 1 lighting unit per 10ft of container length.
Featuring a built in lithium battery which can be charged directly by USB cable (included), the light has ultra-high
conversion efficiency enabling the battery life to serve 30,000 hours. Re-charge when light starts to go dim.

Instructions
Firstly you will need to charge your light
using USB cable included.
Charging –blue indicator light on
Fully charged –red indicator light on
Charge time –4-6 hours
Once charged you will need to set
the mode you require.
Mode 1: Always on
Press switch for 2 seconds to turn on permanently.
Mode 2: Motion & Light sensor –activated if motion
detected within 10ft/3m, it will not be activated in
bright light to save energy.
From Mode 1 press switch for less than a second to
activate Mode 2. The green light will show.
Mode 3: Motion only sensor –activated if motion
detected within 10ft/3m.
From Mode 2 press switch for less than a second to
activate Mode 3. The red light will show. When in your
selected mode simply affix to your container wall or roof
using the magnetic strip and/or the 3M sticky back strip.
To turn off all modes press the switch
for about 2 seconds while light is on.
Specification: Detecting Range: 3m (10ft)
(T< 26℃) / Detecting Angle: 120 degree
Voltage: USB 5V
Wattage: 1.5W
Colour: Pure white
LED number: 33 PCS
Dimension: 24×4×1.8cm (9.4”×1.6”×0.7”)
Weight: 145g
Package Includes:
1 x Motion Sensor LED Light
1 x Magnetic Strip (with 3M Adhesive)
1 x USB Charger Cable
1 x User Manual
Precautions:
●Do not use in very damp or very
humid spaces
●If your container has significant condensation, we
recommend mounting these lights on the container
walls and not the roof
●Do not charge for more than 6 hours
●If the LED light is dim, recharge the unit
●Due to the integral Lithium-ion battery, do not use if
the unit is damaged.
Aftersales & Guarantee
12 Month warranty against any defects and covered by our 30
day money back guarantee –if for any reason these are not
right for you, return them to us and we will refund you in full
any time in the first 30 days after purchase.