R/Evolution 57008B User manual

Turnout switch controller user's manual
SKU 57008B
Basic wiring Diagram fig-1
Specificatins:
1. Output control ports: 5
2. Output drive rating : 1.5A max
. Input power: 12-24VDC(Minimum 1Amps)
4. Control mode: Slow or Fast selectable
5. Driving time adjusable:0.5s to 5sec
“CAUTION”
1. Do not connect input power to the output terminals. (This will be permanently damaged and void warranty).
2. Avoid moisture and direct sunlight.

Connections:
1. Apply a DC power supply to “INPUT” terminal as shown fig-1.
2. Connect "TURNOUT" devices to SW1 - SW5(Max 5 switches)
Transmitter Setup:
Before linking, select receiver type b.R Type to ACESS.
For this operation, look up pages 12 – 14 on the revolution manual on how to set up the Transmitter and also how to link the
Transmitter to the Receiver.
BASIC TRANSMITTER PROGRAMMING PROCEDURE: Download the manual for the “Train Engineer Quick Start
Guide.” You can download and view all the manuals for the Revolution System on our website at www.revoelectronics.com
under Support/manual.
OPERATING YOUR TURNOUT SWITCHES
1. Use < or > keys to select the cab number that you assigned to the switch control unit that you want to operate the
switch control unit on.
The switch control unit name will be displayed on the top line along with SU-, indicating that this is operating as a
single unit switch control board.
2. Use the up and down arrow keys or press #1 to 6 number keys to select the turnout switch number.
. Use the Right Arrow key to go right switch position and the Left Arrow key to run left switch position.