RaceAmerica 06-5830 User manual

1
RaceAmerica ID Recongure Kit
T-Link Wireless
RaceAmerica Corp.
280 Martin Ave. Unit#1
Santa Clara, CA 95050
[phone]
www.raceamerica.com
[email protected]
Copyright 2008 RaceAmerica Corporation
Rev B
Model 06-5830 ID Recongure Kit

2
RaceAmerica ID Recongure Kit
PACKAGE CONTENTS
This package contains three T-Link Reconfigure
Jumpers labeled for their specic position (D, E or F) as
used on a race course.
RECONFIGURING T-LINKS
T-Link identier codes are preset at the factory for use
in specic locations on the race course. Using an external
Recong Jumper (06-5830), a T-Link’s ID code can be
changed enabling a single backup unit (ID C) to replace
any unit with the same optimizer code.
To temporarily change the ID code of a T-Link unit,
power the unit off. Select the Recong Jumper with the
desired ID code (D, E or F) and install it into the T-Port
Figure 1 - T-Link power and external connections
Power On/RF Transmit
ON - Power ON
Blink - Transmit
RF Receive Status
Blink - Receive
connector of the T-Link unit to be recongured. Power
on the T-Link unit. The left LED will ash three short
times to conrm the T-Link unit has been recongured
to the new ID code. Unplug the Recong Jumper and
connect any cables to the T-Link unit for normal use.
Do not power off the T-Link unit after a new ID code
has been assigned. The change of ID is temporary.
When the T-Link unit is powered off, the ID code will
revert back to the preset ID shown on the bottom of
the T-Link unit.
These jumpers will work with any optimizer
code, however, all T-Links in a network must have
the same Optimizer Code. The Optimizer code can
be found on the ID label on the bottom of the T-Link
next to the ID code.
ID Code
e.g. ‘D’
Optimizer Code
e.g. C30
Align Status
Pulsing - Aligned
OFF - Speed NOT aligned
ON - Finish NOT aligned