SPEECHPOD CONFIGURATION AND SETUP PROCEEDURE
Once you have accessed the conguraon menu by pressing the SpeechPOD buon, you have access to all the
funcons relevant to the SpeechPOD element.. All these funcons are shown below, but remember if you do not
have a parcular element (e.g. PIR Moon sensor) on the device you have purchased, you will not be able to set
the conguraon menu for this element.
Pressing the LANGUAGE buon UP or DOWN will scroll through the list of available languages and the
device will tell you which language is currently selected. The languages programmed by the factory are
as follows and once selected all the menu sengs will be spoken in the selected language.
“ENGLISH” ; “FRANCAIS” ; “DEUTSCHE” ; ESPAŇOL ; AMERICAN ; OTHER
Pressing the MESSAGE buon UP or DOWN will scroll through the list of available messages you have
programmed in the Cig-Arrête® folder on the SD Flash Card. You can program several messages in this
folder and use the MESSAGE buon to select the parcular message to be played in the event of a
smoking detecon. Please note that whichever message you select will be played for an alarm event
from either the ame detector, or the smoke detector.
Pressing the MODE buon UP or DOWN will scroll through the opons for the available SpeechPOD func-
ons. The opons are shown below with a brief descripon for each one. The MODE buon works together
with the TIME DELAY buon which selects the various opons or me delays for each MODE selected.
“CLEANER MODE—PLEASE SELECT TIME TO OFF”
Used by cleaning sta to change the normal operaonal mode to play a message alerng parally sighted
people that the oor may be wet and slippery. Use the TIME DELAY buon to select the me required for the
oor to dry (10 mins to 60 mins) Aer the me period SpeechPOD will return to its normal mode and me
delays etc.
“DELAY AFTER ACTIVATION—PLEASE SELECT TIME DELAY”
SpeechPOD will play the selected message immediately sensing moon, but will not play any message again
for a me period which is selected by pressing the TIME DELAY buon UP or Down. Typically this funcon is
used for infecon control messages to use hand gel prior to vising paents and relaves.
“DELAY BEFORE ACTIVATION—PLEASE SELECT TIME DELAY”
SpeechPOD will be acvated on sensing moon but will not play the selected message for a me period
which is selected by pressing the TIME DELAY buon UP or Down. Typically this funcon is used for hand
washing, where a person enters a washroom and the product waits for 60 seconds before reminding them
about the importance of hand hygiene.
“SEQUENTIAL MESSAGES—PLEASE SELECT ON OR OFF”
Press the TIME DELAY buon to switch this ON or OFF. When ON, at the rst detecon of moon SpeechPOD
will play the rst message in the SPOD folder, on subsequent acvaons, the next message in the folder will
be played and so on. This avoids any message fague and always makes the announcement fresh.
“MESSAGE REPEATS”
Once you have pressed the MODE buon above, you can press the TIME DELAY buon UP or DOWN to scroll
through the MESSAGE REPEATS (the number of mes that the device will play the message in alarm) The
factory default seng is ONE. The opons available are:
“OFF” ; “ONE” ; “TWO” ; “THREE”
Once you have congured the SpeechPOD® element present on your device, press the SPEECHPOD buon
again to return to ‘RUN MODE’ which makes the device run normally and ready to generate alarm condions.
On exing the conguraon mode the device will provide the following message:
“DEVICE CONFIGURED”
+
