Raven RTH-10 Parts list manual

3. Battery Performance
• The battery is fully recharged after
8-12 hour with applied power
• The solar panel supports a continuous
charge with a few hours of sunlight
per day*
*May vary dependent on the users
geographic location
1. Getting Started
• The Solar Hybrid device is IP67
rated, can be mounted exteriorly
or interiorly. The magnetic mount
allows it to be mounted without
hardware on magnetic surfaces.
2. Wired & Non-Wired
Installation
• Wired Installation (Recommended)
• Device will report every
30 seconds when moving
• Red Wire — 12V Power
• Black Wire — Chassis Ground
• Yellow Wire — Not Used
• Non-Wired Installation
• Device will report every 5 minutes
when moving
MORE →
RTH-10 Device Installation
Solar Hybrid Device
Open Wires
*Magnetic Cradle Included
Device
Plug

Hours | 7 AM–5 PM CST | Mon–Fri
Sales & Support | [phone]
Login | tracking.ravenslingshot.com
Website | ravenprecision.com
Email | A[email protected]om
6. Verify Device Installation
• When the Solar Hybrid device has
power, a red light will be solid
• Single Blue LED —Cellular service
• Single Red LED —GPS service
5. Device Installation
• Align the device plug and insert it into
the Solar Hybrid device
• when the wire harness in firmly in
place, screw the collar down firmly
• Do not push the attachment in at an
angle or use too much force
7. Look — You’re On The Map!
• Log-in to tracking.ravenslingshot.com
or open your app and start tracking!
Questions & Troubleshooting
• Call [phone] to talk to a
Technical Support Specialist or
visit edge.ravenprecision.com and
view the Slingshot on Demand
training resources.
4. Wire Management
• Run the device plug to the preferred
storage location
• Secure the cables to ensure safe
asset and device operation