OPERATION
NautoPilot 5000 Series
IV
4002.DOC010102 Edition: September 2014
Figure 1: NautoPilot 5000 Series, Operator Unit 1.....................................
Figure 2: Standalone application for the NautoPilot 5000 Series 4.......................
Figure 3: Integrated application of NautoPilot 5000 Series 5............................
Figure 4: Course Trim angle 11......................................................
Figure 5: Heading Control after manual set heading adjustment 17.......................
Figure 6: Principle of Course Control versus Heading Control 18.........................
Figure 7: Explanations for a heading change in Course Control 19........................
Figure 8: Principle of Course Control display 20........................................
Figure 9: Course Control after manual set heading adjustment 21........................
Figure 10: Principle of Track Control 24................................................
Figure 11: Example for GO--TO--WAYPOINT Manoeuvre
for NP5100, NP5300 and NP5400 28........................................
Figure 12: Example of Five Different GO--TO--WAYPOINT Manoeuvres depending on
the initial heading 28.......................................................
Figure 13: Geometrical Requirements of GO--TO--WAYPOINT Manoeuvres 29..............
Figure 14: Changing over to Track Control -- on transmitting a FROM--WPT by
the ECDIS 32.............................................................
Figure 15: Procedure of the Track Change Manoeuvre (Example) 33......................
Figure 16: Extreme Case Example of a Track Change Manoeuvre 35......................
Figure 17: Changing TO--WPT and NEXT--WPT without Interrupting Track Control 36........
Figure 18: Intended RETURN--TO--TRACK manoeuvre Impossible with the Ship
too Close to the TO--WPT 43................................................
Figure 19: Track Control impossible with the Distance to the Track too large 43.............
Figure 20: NautoPilot Operator Unit (operation elements) 47..............................
Figure 21: Structure to adjust parameters and values 49.................................
Figure 22: First display (after switching ON the NautoPilot Operator Unit) 50...............
Figure 23: Tendency bar 53..........................................................
Figure 24: First display (after switching ON the NautoPilot Operator Unit in night mode,
black/white) 54............................................................
Figure 25: First Display (heading changes with RoT is selected). 55.......................
Figure 26: First Display (Eco/Prec switchover) 56.......................................
Figure 27: Switching to display selection 57............................................
Figure 28: Displays for ”HDG /Rudder Plot” 58..........................................
Figure 29: Example of a ”SET” request after a parameter has been changed 58.............
Figure 30: Displays for “Track Data” 61................................................
Figure 31: Example of a request to press ”SET” after a parameter has been changed 62.....
Figure 32: Display for “NP 5000 Actual Rudder” with one and two rudders 64...............
Figure 33: Displays for “Acceleration Monitor” 66........................................
Figure 34: Example of a request to press ”SET” after a parameter has been changed 68.....
Figure 35: Display for the ”Position Monitoring” function (no limit exceeded) 71..............
