Razer Nabu Watch Parts list manual

REPLACING THE INTERNAL BATTERY OF YOUR NABU WATCH
Do not attempt to service this device if your product is still under warranty, instead
please contact the Razer hotline or visit razersupport.com.
WHAT YOU NEED
1 x T5 Torx screwdriver
1 x 2.4 mm flat-head screwdriver
CR2032 replacement battery
HOW TO REPLACE THE BATTERY
1. Turn the watch over, then r
screwdriver.

2. Firmly push any of the wrist straps near the back plate to unlatch the back plate.
You may then remove the back plate by carefully prying it open with your other
hand.

3. Remove the rubber cover.

4. Peel off the battery polarity sticker.

5. Insert a flat-head screwdriver This will unlatch the battery clip.

6. Replace the CR2032 battery.
Note: Please observe the correct battery placement as seen on the battery polarity
sticker. Do not use metallic tweezers, pliers and the like to remove/replace the battery.

7. Close the battery clip until the battery clip snaps shut.

8. Return the battery polaritysticker and the rubber cover.

9. Make sure that the rubber O-ring is properly placed into its allotted groove.
Note: The rubber O-ring seals and protects your Razer Nabu watch from liquids. It is
important to always return the rubber O-ring to its original position first before
fastening the back plate.

10. Reattach the back plate.

11. Using the Torx screwdriver, lightly and equally tighten each screw first before fully
tightening the back plate in place. This will ensure that the O-ring remains properly
fitted into its allotted groove as you tighten the screws.
12. On your phone, launch and pair your Razer Nabuapp with your Razer Nabu watch.
The Razer Nabu watch will automatically sync current
time.